A novel kinetic determination of nitrite based on the perphenazine-bromate redox reaction

An extremely sensitive and selective kinetic method was developed for the determination of trace levels of nitrite based on its catalytic effect on the oxidation of perphenazine (PPZ) with bromate in a phosphoric acid medium. The reaction rate was monitored spectrophotometrically by tracing the formation of the red-colored oxidized product of PPZ at 525 nm within 30 sec of mixing. The optimum reaction conditions were 4.0 μmol L⁻¹ PPZ, 0.4 mol L⁻¹ H₃PO₄ and 30 mmol L⁻¹ bromate at 25 °C. Using the recommended procedure, nitrite could be determined with a linear calibration graph up to 4.50 ng mL⁻¹ and a detection limit of 0.07 ng mL⁻¹. The method was conveniently applied to the determination of nitrite in samples of rain, polluted well and formulated waste waters. Moreover, the published kinetic spectrophotometric methods for nitrite determination are reviewed.     

Solid-phase extraction using molecularly imprinted polymers for selective extraction of a mycotoxin in cereals

The aim of this work was to develop a method for the clean-up of a mycotoxin, i.e. Ochratoxin A (OTA), from cereal extracts employing a new molecularly imprinted polymer (MIP) as selective sorbent for solid-phase extraction (SPE) and to compare with an immunoaffinity column. A first series of experiments was carried out in pure solvents to estimate the potential of the imprinted sorbent in terms of selectivity studying the retention of OTA on the MIP and on a non-imprinted polymer using conventional crushed monolith. The selectivity of the MIP was also checked by its application to wheat extracts. Then, after this feasibility study, two different formats of MIP: crushed monolith and micro-beads were evaluated and compared. Therefore an optimization procedure was applied to the selective extraction from wheat using the MIP beads. The whole procedure was validated by applying it to wheat extract spiked by OTA at different concentration levels and then to a certified contaminated wheat sample. Recoveries close to 100% were obtained. The high selectivity brought by the MIP was compared to the selectivity by an immunoaffinity cartridge for the clean-up of the same wheat sample. The study of capacity of both showed a significant higher capacity of the MIP.     

Reactivity, 31P, 13C, 1H NMR and IR Studies of Δ5-3-Dimethylamino-3-Oxo-1,2,3- Diazaphospholines

Abstract

In precedent work research (1)(2) we have reported a new synthesis method of the Δ⁵-3- dimethylamino-3-oxo-l,2,3 diazaphospholine derivatives (D_i). In this present work, we have to detail the reactivity and the structure of those heterocycles by N.M.R. (³¹P, ¹³C, ¹H) and I.R. In Infra-Red spectroscopy, we show the existence of the intermolecular hydrogen bond of some compounds. The spectrum(³¹P, ¹³C, ¹H) and I.R. was reported of (D_i).     

Thermal effects of solvation processes on alkali metal alcoxide formation and stability

The formation of alkali metal alcoxides by an alcohol reacting on the elemental metal itself cannot be completed under stoichiometric conditions. As a consequence of solvation, the chemical activity of the reacting alcohol is drastically reduced. Thus, the reaction cannot undergo completion without a large excess of alcohol with respect to the alkali metal. Moreover, solvation processes can drop the reaction kinetics down to nearly zero. When an excess of alkali metal is reacted with alcohol, the heat accumulated by solvation can be suddenly released by an addition of pure alcohol. Extremely dangerous thermal runaways can be started this way. This revised version was published online in August 2006 with corrections to the Cover Date.     

Preparation,characterization and ion adsorption properties of functionalized polystyrene modified with 1,4-phenylene diisocyanate and diethylenetriamine

In the present work, linear polystyrene (PS) was functionalized by a sulfonation reaction providing sulfonated polystyrene (PSS). Then, the PSS polymer chains were cross-linked with the 1,4-phenylene diisocyanate (PPDI) group in tetrahydrofuran (THF), which led to a PSS-PPDI polymer. The PSS-PPDI was grafted by diethylenetriamine (DETA) in a solution of THF to obtain polymer PSS-PPDI-DETA. Their structures were characterized by infrared spectroscopy (ATR-FTIR), elemental analysis (EA), differential scanning calorimetry (DSC), thermogravemetric (TGA), thermodynamic (DTA) and differential thermogravimetric (DTG) analysis. Subsequently, the obtained polymers were tested for their ability to remove some metal ions from aqueous media such as Zn²⁺, Cd²⁺ and Co²⁺.     

Ultra high performance liquid chromatography with mass spectrometry method for the simultaneous determination of phenolic constituents in honey from various floral sources using multiwalled carbon nanotubes as extraction sorbents

An ultra high performance liquid chromatography with mass spectrometry method has been developed for the simultaneous separation, identification and determination of 22 phenolic constituents in honey from various floral sources from Yemen. Solid‐phase extraction was used for extraction of the target phenolic constituents from honey samples, while multiwalled carbon nanotubes were used as solid‐phase adsorbent. The chromatographic separation of all phenolic constituents was performed on a BEH C₁₈ column using a linear gradient elution with a binary mobile phase mixture of aqueous 0.1% formic acid and methanol. The quantitation was carried out in selected ion reaction monitoring acquisition mode. The total amount of phenolic acids, flavonoids and other phenols in each analyzed honey was found in the range of 338–3312, 122–5482 and 2.4–1342 μg/100 g of honey, respectively. 4‐Hydroxybenzoic acid was found to be the major phenolic acid. The main detected flavonoid was chrysin, while cinnamic acid was found to be the major other phenol compound. The regeneration of solid phase adsorbent to be reused and recovery results confirm that the proposed method could be potentially used for the routine analysis of phenolic constituents in honey extract.     

Visible-Light-Promoted Switchable Selective Oxidations of Styrene Over Covalent Triazine Frameworks in Water

Using photocatalytic oxidation to convert basic chemicals into high value compounds in environmentally benign reaction media is a current focus in catalytic research. The challenge lies in gaining controllability over product formation selectivity. We design covalent triazine frameworks as heterogeneous, metal-free, and recyclable photocatalysts for visible-light-driven switchable selective oxidation of styrene in pure water. Selectivity in product formation was achieved by activation or deactivation of the specific photogenerated oxygen species. Using the same photocatalyst, by deactivation of photogenerated H₂O₂, benzaldehyde was obtained with over 99 % conversion and over 99 % selectivity as a single product. The highly challenging and sensitive epoxidation of styrene was carried out by creating peroxymonocarbonate as an initial epoxidation agent in the presence of bicarbonate, which led to formation of styrene oxide with a selectivity up to 76 % with near quantitative conversion. This study demonstrates a preliminary yet interesting example for simple control over switchable product formation selectivity for challenging oxidation reactions of organic compounds in pure water.     

Selective functionalization of crown ethers via arene chromium tricarbonyl complexes

The crown ethers dibenzo-16-crown-4 and dibenzo-18-crown-5 and a diaryl polyether were complexed by the chromium tricarbonyl group for the purpose of selective functionalization. This complexation did indeed permit exclusive functionalization of the complexed ring. CHO and CH₂OH functionalities were introduced ortho to the ether group. It was noted that the nature of the two ether chains had a strong influence on the regioselectivity of the functionalization, which occurred preferentially on the side with the polyether chain. Photochemical decomplexation produced functionalized organic crown ethers.     

Fecal Metabolic Profiling of Breast Cancer Patients during Neoadjuvant Chemotherapy Reveals Potential Biomarkers

Breast cancer (BC) is the most common form of cancer among women worldwide. Despite the huge advancements in its treatment, the exact etiology of breast cancer still remains unresolved. There is an increasing interest in the role of the gut microbiome in modulating the anti-cancer therapeutic response. It seems that alteration of the microbiome-derived metabolome potentially promotes carcinogenesis. Taken together, metabolomics has arisen as a fascinating new omics field to screen promising metabolic biomarkers. In this study, fecal metabolite profiling was performed using NMR spectroscopy, to identify potential biomarker candidates that can predict response to neoadjuvant chemotherapy (NAC) for breast cancer. Metabolic profiles of feces from patients (n = 8) following chemotherapy treatment cycles were studied. Interestingly, amino acids were found to be upregulated, while lactate and fumaric acid were downregulated in patients under the second and third cycles compared with patients before treatment. Furthermore, short-chain fatty acids (SCFAs) were significantly differentiated between the studied groups. These results strongly suggest that chemotherapy treatment plays a key role in modulating the fecal metabolomic profile of BC patients. In conclusion, we demonstrate the feasibility of identifying specific fecal metabolic profiles reflecting biochemical changes that occur during the chemotherapy treatment. These data give an interesting insight that may complement and improve clinical tools for BC monitoring.