大气臭氧化学研究进展

臭氧是大气化学中的核心物种。在平流层中,臭氧层可以吸收对生物有害的紫外辐射,对地球生命起保护伞作用。在对流层大气中,适量臭氧对清洁大气是有益的。但是,由于对流层中臭氧前体物排放量的增加,特别是在大城市,产生的高浓度臭氧会对大气环境造成严重污染,对人类、动植物和生态环境具有极大危害。臭氧的研究一般结合外场观测、实验室烟雾箱模拟和计算机数值模拟进行。深入开展大气臭氧化学研究,不仅有助于全面深入理解大气氧化过程以及全面掌握区域乃至全球大气自净能力,而且能为对流层污染控制提供科学依据和方案。本文总结了近年来有关臭氧化学的研究进展,论述了臭氧问题与人类当前面临的一些主要环境问题间的相互关系;重点综述了近年来有关南极臭氧空洞、中纬度地区臭氧低值和北极地区臭氧的损耗机理及其发展趋势;综述了臭氧与大气光化学和气溶胶间的耦合关系,并结合我国实际情况,提出了大气臭氧化学尚待深入开展研究的一些重要科学问题。     

锂皂石修饰碳糊电极测定痕量铜的研究

报道了锂皂石修饰碳糊电极测定痕量铜，在含０．００１ｍｏｌ／Ｌ ＫＣｌ Ｃｕ＾＋２的试液中，开路富集后介质交换到０．０５ｍｏｌ／Ｌ ＫＣｌ中，用微分脉冲伏安法测定，检测限为７．０ｎｇ／ｍＬ。常见阳离子基本不干扰，可不经预先分离直接测定精金矿中铜的含量，结果良好。还探讨了Ｃｕ＾＋２在锂皂石修饰碳糊电极上的反应机理。     

Local and non-local sources of airborne particulate pollution at Beijing

A new element tracer technique has firstly been established to estimate the contributions of mineral aerosols from both inside and outside Beijing. The ratio of Mg/Al in aerosol is a feasible element tracer to distinguish between the sources of inside and outside Beijing. Mineral aerosol, inorganic pollution aerosol mainly as sulfate and nitrate, and organic aerosol are the major components of airborne particulates in Beijing, of which mineral aerosol accounted for 32%–-67% of total suspended particles (TSP), 10% –70% of fine particles (PM2.5), and as high as 74% and 90% of TSP and PM_2.5, respectively, in dust storm. The sources from outside Beijing contributed 62% (38%–-86%) of the total mineral aerosols in TSP, 69% (52%–-90%) in PM₁₀, and 76% (59%–-93%) in PM_2.5 in spring, and 69% (52%–-83%), 79% (52%–-93%), and 45% (7% – 79%) in TSP, PM₁₀, and PM_2.5, respectively, in winter, while only ≈20% in summer and autumn. The sources from outside Beijing contributed as high as 97% during dust storm and were the dominant source of airborne particulates in Beijing. The contributions from outside Beijing in spring and winter are higher than those in summer, indicating clearly that it was related to the various meteorological factors.     

氨水介质中金属锌促进醛的(口片)呐偶联反应

传统的(口片)呐偶合反应必须在无水有机溶剂条件下,由金属或金属化合物促进羰基化合物进行(口片)呐偶合反应.曾经报道过金属锌在强碱介质或弱酸介质中,促进羰基化合物进行水相(口片)呐偶合反应.本文报道一种简便、有效的水相(口片)呐偶合反应,它是在含有少量冠醚的稀氨水溶液中,使用锌粉促进醛基化合物进行水相(口片)呐偶合反应,其中加入少量的冠醚有助于提高反应的产率,(口片)呐醇产率由63%提高到84%.然而,(口片)呐偶合反应的产率受到羰基周围环境的立体位阻影响较大,在此条件下,锌粉能有效地促进芳香族醛类化合物进行水相(口片)呐偶合反应,得到的(口片)呐醇产率高,但非对映异构体选择性差,而脂肪族醛类化合物得到的(口片)呐醇产率较低,在同样的条件下,酮类化合物不能顺利进行(口片)呐偶合反应.     

Particles detection and analysis of hard disk substrate after cleaning of post chemical mechanical polishing

Scrub, ultrasonic and megasonic are widely used in industry as post-CMP (chemical mechanical polishing/planarization) cleaning procedure. In this paper experiments and results are described to analyze the particle contaminations of hard disk substrate after each process of post-CMP cleaning. A scatter spot method has been exploited to detect the location and characteristics of the particles. SEM with EDX is used to observe and analyze the particles’ shape and size as well as the elements. The results indicate that brush scrub process can remove 99% contaminations after CMP but not that efficient for submicron particle. Megasonic is a refined method for cleaning nano-particles. However, contaminations like metallic particles and bacteria from the equipment may cause pollution. The abrasive particles embedded in the plating pits cannot be removed by mechanical force. Pollution in the dryer is also discussed.     

纠缠相干态光场驱动下∧-型三能级原子的辐射谱

采用时间演化算符方法,研究∧-型=三能级原子与纠缠相干态光场共振相互作用的辐射谱.给出了辐射谱一般公式,并讨论在纠缠相干态光场驱动下的辐射频谱结构.结果表明,无论下能级简并与否纠缠相干态光场平均光子数很小时均出现拉比分裂,且强度随双模光场纠缠程度的增加而增加.当两下能级简并时,若两模场的平均光子数较小,辐射谱呈现对称多峰结构,若两模场的平均光子数较大,辐射谱呈现对称五峰结构.当两下能级非简并时,若两模场的平均光子数较小,辐射谱呈现对称多峰结构.若两模场的平均光子数较大,辐射谱呈现对称十峰结构.纠缠相干光与非纠缠相干光辐射谱的本质差别有两点:一是双模光场强量子关联导致纠缠度越强拉比峰强度越高;二是存在纠缠时由于两模场相干性导致辐射谱呈现对称多峰结构.     

Structural and mechanical properties of nano-crystal TiN coatings

The structural and mechanical properties of TiN coatings prepared by ion beam assisted deposition (IBAD) were studied. The coatings have a polycrystal structure with grain size of ～10 nm or less. The hardness of the coatings increases with increasing grain size of TiN crystallites. The coating with grain size of 10.3 nm even has a superhardness of 44.7GPa. The relationship between the hardness and the grain size in the nano-crystalline coatings was discussed on the basis of grain-boundary triple junctions.