Ultrasonic investigation of amorphous carbon in various frequencies at low temperatures from 2.1 to 300 K

Using pulse echo overlap measurement, the elastic behavior of amorphous carbon has been studied at ambient and low temperatures. The smaller ratio B/G of the bulk modulus to shear modulus and smaller Poisson's ratio σ at room temperature indicate that there is an intrinsic stiffening of transverse acoustic phonons in the amorphous carbon. The acoustic velocity and attenuation for longitudinal modes have been measured between 2.1 and 300 K at three frequencies of 7, 21 and 35 MHz, respectively. Their frequency and temperature dependence are observed. The elastic constant C₁₁ increases with decreasing temperature and show enhanced stiffening at low temperatures. In the 130-220 K region, the abnormal change and effect of longitudinal velocity and attenuation with temperature and frequency, and a phase transition associated with structure relaxations are discussed.     

All-optical broadcast and multicast technologies based on PPLN waveguide

All-optical 1 ×4 broadcast and 1 ×3 multicast experiments of a 40-Gb/s return-to-zero on-off keying （RZ- OOK） signal based on a periodically poled lithium niobate （PPLN） waveguide are demonstrated in this letter. Clear opened eye diagrams and error-free performance are achieved for the broadcast signals at 1541.3, 1543.7, 1548.5, and 1550.9 nm. Multicast technology uses cascaded second-harmonic generation and difference-frequency generation in a Ti：PPLN waveguide. An error-free operation with a negligible power penalty is achieved for the three wavelength-division multiplexing multicast signals at 1533, 1537, and 1541 nm.     

Resonantly pumped Q-switched Er:GdVO4 laser

We describe a Q-switched Er:GdVO₄ laser resonantly pumped by a MgO-doped periodically poled LiNbO₃ optical parametric oscillator （MgO: PPLN OPO） at 1536 nm. In continuous-wave lasing, the maximum output power is 1.14 W with an incident pump power of 4.7 W and a slope efficiency of 27%. In Q-switched operation, 1.1 mJ of output pulse energy is achieved at 200 Hz. The upper-state lifetime at different pulse repetition frequencies is also calculated.     

Polarization-dependent carrier dynamics in a passive InAs/InP quantum dot waveguide

We investigate carrier dynamics in a passive InAs/InP quantum dot (QD) waveguide using 255 fs optical pulses at a central wavelength of 1568 nm. We observe strong anisotropy of absorption saturation for different polarizations. Pump-probe measurements indicate the presence of carrier relaxation dynamics on a timescale in the order of tens of picoseconds due to cascaded relaxation of carriers generated by two-photon absorption (TPA) from the bulk region to the QDs via the wetting layer. These relaxation timescales are much longer than in QD amplifiers. Our observations are supported by a rate-equation model which includes TPA, showing good agreement with the pump-probe measurements.     

非线性光学及其若干新进展

扼要介绍了非线性光学的基本概念及其最近10年来在飞秒激光，半导体材料，光纤通信和光信息存储等若干方面的研究进展。     

动态场空间分布实时测量装置的研究

描述了一套多路动态场空间分布实时测量系统，该系统是一套以微要为中心的数字化系统，可实现多路动态场空间分面睥精神病时测量。系统由微机、TMS320C50板、开关电路、检波器、传感器、放大器等设备构成硬件系统，并通过编制C50板嵌入式软件和微机主控程序实现系统功能。     

空间光学遥感器主镜加工过程中疲劳寿命研究

针对空间光学遥感器主镜镜面加工过程中,磨盘与主镜间磨削动作往复运行引起的主镜柔性支撑结构疲劳寿命问题,通过建立主镜组件的有限元模型,利用MSC.Fatigue软件按应力-寿命(S-N)法对主镜组件进行了疲劳寿命分析,确定了支撑结构的薄弱部位,并对仿真过程进行了误差分析,讨论了影响仿真结果的各个因素.对比热真空试验和动力学试验前后主镜镜面面型数据,验证了支撑结构加工、设计参量的合理性.通过疲劳寿命仿真分析,可以有效预示光学结构在加工过程中的疲劳情况,为空间光学遥感器结构的设计、加工提供理论依据和参考.     

Continuous-wave and Q-switched Operation of a Tm,Ho:YAP ring laser

We demonstrated continuous-wave (CW) and Q-switched operation of a Tm,Ho:YAP ring laser at 77 K. The maximum CW output power of 2 W at 2130.7 nm was obtained under the incident pump power of 12 W, corresponding to a slope efficiency of 23% and an optical-to-optical efficiency of 16.7%. For the Q-switched regime the maximum output energy of 5 mJ with the pulse width of 160 ns at the repetition rate of 100 Hz was achieved, corresponding to a peak power of 31.25 kW.     

Photoluminescence properties of color-tunable SrMgAl10O17:Eu2+,Mn2+ phosphors for UV LEDs

Aluminate phosphors SrMgAl₁₀O₁₇ codoped with Eu²⁺ and Mn²⁺ ions were prepared by solid-state reaction. The phase structure and photoluminescence properties of the as-prepared phosphors were characterized by powder X-ray diffraction, photoluminescence excitation and emission spectra. Upon excitation of UV light, two broad emission bands centered at 470 and 515 nm were observed, and they were assigned to Eu²⁺ and Mn²⁺ emissions, respectively. The emission color of the phosphors can be tuned from blue to cyan and finally to green by adjusting the concentration ratios of Eu²⁺ and Mn²⁺. Effective energy transfer occurs from Eu²⁺ to Mn²⁺ in the host due to the spectral overlap between the emission band of Eu²⁺ and the excitation bands of Mn²⁺. The energy transfer mechanism was demonstrated to be electric dipole–quadrupole interaction. The energy transfer efficiency and critical distance were also calculated. The phosphors exhibit strong absorption in near UV spectral region and therefore they are potentially useful as UV-convertible phosphors for white LEDs.     

新型动磁式直线压缩机电机的改进设计

研制了一种新型直线压缩机驱动用动磁式直线振动电动机。建立了电动机磁路物理模型,并对电动机动子动力学模型进行了求解,得到了电磁驱动力的基本要求,分析了电动机参数对动子运动特性和电动机性能的影响。运用电磁场有限元方法对动磁式直线电动机电磁场模型求解,磁通分布揭示了电磁力产生机理,分析并优化了不同于传统直线电机的设计方式。数据分析揭示了动磁式直线电动机力-位移-电流之间的关系,为压缩机和电动机控制系统设计奠定了基础。