Oscillation of coercivity between positive and negative in MnxGe1-x：H ferromagnetic semiconductor films

Amorphous MnxGe1-x :H ferromagnetic semiconductor films prepared in mixed Ar with 20% H2 by magnetron cosputtering show global ferromagnetism with positive coercivity at low temperatures. With increasing temperature, the coercivity of MnxGe1-x :H films first changes from positive to negative, and then back to positive again, which was not found in the corresponding MnxGe1-x and other ferromagnetic semiconductors before. For Mn0.4Ge0.6 :H film, the inverted Hall loop is also observed at 30 K, which is consistent with the negative coercivity. The negative coercivity is explained by the antiferromagnetic exchange coupling between the H-rich ferromagnetic regions separated by the H-poor non-ferromagnetic spacers. Hydrogenation is a useful method to tune the magnetic properties of MnxGe1-x films for the application in spintronics.     

氰化给体中分子间相互作用促进的全小分子光伏混合物的超快电子转移

氰基取代被认为是优化全小分子有机太阳能电池性能的可行方法. 然而,氰基取代对太阳能电池中电荷产生动力学的影响仍未得到探索. 本文光谱研究表明,在全小分子太阳能电池中,氰化给体中增强的分子间电荷转移相互作用会显著促进共混物中的电子转移. 实验发现,在氰基取代给体中,分子间相互作用引起的离域激发,在混合物中会进行超快电子转移. 相比之下,在没有氰基取代的给体中剩余的局域激发态,并没有积极参与电荷分离. 此发现很好地解释了为何氰化取代给体的共混物器件的性能会得到提升,表明可以通过调控分子间相互作用、来优化全小分子器件性能.     

Fabrication and characterization of rod-like nano-hydroxyapatite on MAO coating supported on Mg-Zn-Ca alloy

The poor corrosion resistance of magnesium alloys is a dominant problem that limits their clinical application. In order to solve this challenge, micro-arc oxidation (MAO) was used to fabricate a porous coating on magnesium alloys and then electrochemical deposition (ED) was done to fabricate rod-like nano-hydroxyapatite (RNHA) on MAO coating. The cross-section morphology of the composite coatings and its corresponding energy dispersion spectroscopy (EDS) surficial scanning map of calcium revealed that HA rods were successfully deposited into the pores. The three dimensional morphology and scanning electron microscopy (SEM) image of the composite coatings showed that the distribution of the HA rods was dense and uniform. Atomic force microscope (AFM) observation of the composite coatings showed that the diameters of HA rods varied from 95 nm to 116 nm and the root mean square roughness (RMS) of the composite coatings was about 42 nm, which were favorable for cellular survival. The bonding strength between the HA film and MAO coating increased to 12.3 MPa, almost two times higher than that of the direct electrochemical deposition coating (6.3 MPa). Compared with that of the substrate, the corrosion potential of Mg-Zn-Ca alloy with composite coatings increased by 161 mV and its corrosion current density decreased from 3.36 × 10⁻⁴ A/cm² to 2.40 × 10⁻⁷ A/cm² which was due to the enhancement of bonding strength and the deposition of RNHA in the MAO pores. Immersion tests were carried out at 36.5 ± 0.5 °C in simulated body fluid (SBF). It was found that RNHA can induce the rapid precipitation of calcium orthophosphates in comparison with conventional HA coatings. Thus magnesium alloy coated with the composite coatings is a promising candidate as biodegradable bone implants.     

低气压条件下氢气潘宁放电的模拟分析

为更好地理解低气压、弱电离条件下潘宁离子源放电过程中离子和电子的动力学行为, 通过建立二维轴对称模型, 采用粒子模拟与蒙特卡罗相结合(PIC/MCC)的方法, 考虑了电子与氢气之间的弹性碰撞、激发、电离以及氢原子、离子之间的弹性碰撞和电荷交换等过程, 对微型氢气潘宁离子源放电和引出过程进行了数值研究. 考察了磁场位形、壁面二次电子发射系数、引出电压和充气压力对放电过程的影响, 得到了实验中难以诊断得到的放电腔内电子与离子数密度分布, 阳极电流、引出极离子电流、单原子氢离子比例和双原子氢离子比例等宏观参数与实验结果相一致. 通过仿真使得对氢气潘宁放电机制的研究从定性过渡到定量, 这对于潘宁离子源的设计和改进具有重要意义. 关键词： 潘宁放电 氢气 粒子模拟 蒙特卡罗     

Spin gapless semiconductor like Ti2MnAl film as a new candidate for spintronics application

A novel Heusler ferrimagnet Ti₂MnAl film has been grown on Si(001) substrate using magnetron sputtering. Characteristics of its magnetic and transport properties reveal the spin‐gapless‐semiconductor (SGS) nature of the stoichiometric Ti₂MnAl, in agreement with theoretical prediction. The as‐grown SGS‐like Ti₂MnAl film demonstrated high Curie temperature, nearly compensated ferrimagnetic properties with small coercivity and low magnetization. It also showed semiconductor‐like behavior at room temperature allowing good compatibility with commercial Si‐based semiconductor. In this regards, Ti₂MnAl film is a potential candidate material for spintronics application, especially for the minimization of energy consumption of device. (© 2015 WILEY‐VCH Verlag GmbH &Co. KGaA, Weinheim)     

槽道尺寸对平板式环路热管性能的影响

设计开发了一套平板式环路热管,比较了2 mm×1.5 mm和1 mm×1 mm(高×宽)两种蒸气槽道环路热管在不同倾角和充液率下的性能。结果发现,两种蒸气槽道在相同条件下最低启动功率相同,但前者启动时间和过渡时间较后者短。稳定运行时,除充液率为55%且功率小于150 W外,其他情况下前者运行温度比后者低。变工况运行时,随功率的增大,温度后者变化很大,而前者变化较小,前者自适应能力强。对于传热特性,两种槽道环路热管的热阻都随功率的增大而逐渐减小,最后趋于平稳;对水平、充液率为55%的系统,功率较小时前者热阻较大,功率增大后,其值大幅减小,215W时仅为0.12℃/W。     

混沌时间序列基于邻域点的非线性多步自适应预测

根据流形理论，利用混沌时间序列中某点邻域内最近几点的P次迭代像，提出了一种多步自 适应预测算法.仿真说明，这种算法使得预测速度成倍提高，而预测稳定后得到的误差均方 根序列呈指数增长趋势，这个指数就是该混沌时间序列的Lyapunov指数. 关键词： 混沌时间序列 邻域 非线性自适应预测 Lyapunov指数     

Two-dimensional non-spatial filtering based on holographic Bragg gratings

The filter made up of two gratings performs as a two-dimensional non-spatial filtering. This paper reports that the volume Bragg gratings are fabricated by interfering two collimated coherent laser beams in photopolymer. Diffraction efficiency of a single grating is up to 78% in Bragg's condition, then a two-dimensional non-spatial filter, which consists of two volume Bragg gratings and a half-wave plate, enables the laser beam filtered in two dimensions with the diffraction efficiency of 54%. The Bragg's condition and effect of polarisation on performances of the two-dimension filter are also discussed.     

Benzothiadiazole-based Conjugated Polymers for Organic Solar Cells

Benzothiadiazole(BT) is an electron-deficient unit with fused aromatic core, which can be used to construct conjugated polymers for application in organic solar cells(OSCs). In the past twenty years, huge numbers of conjugated polymers based on BT unit have been developed,focusing on the backbone engineering(such as by using different copolymerized building blocks), side chain engineering(such as by using linear or branch side units), using heteroatoms(such as F, O and S atoms, and CN group), etc. These modifications enable BT-polymers to exhibit distinct absorption spectra(with onset varied from 600 nm to 1000 nm), different frontier energy levels and crystallinities. As a consequence, BT-polymers have gained much attention in recent years, and can be simultaneously used as electron donor and electron acceptor in OSCs, providing the power conversion efficiencies(PCEs) over 18% and 14% in non-fullerene and all-polymer OSCs. In this article, we provide an overview of BTpolymers for OSCs, from donor to acceptor, via selecting some typical BT-polymers in different periods. We hope that the summary in this article can invoke the interest to study the BT-polymers toward high performance OSCs, especially with thick active layers that can be potentially used in large-area devices.     

HL-2M 装置运行控制技术初步研究

重点介绍了 HL-2M 装置的运行技术和初步的等离子体控制实验结果,包括等离子体放电方案设计、 线圈电流控制、击穿阶段零场匹配和等离子体电流以及位移的控制。为了降低放电运行风险,HL-2M 装置初始放 电采用了简化的放电方案,通过整定 PID 参数实现了线圈电流控制,在击穿阶段获得了 10V 以上的环电压和较大 范围的零场区域,成功实现等离子体击穿。最后,投入了等离子体电流和水平位移反馈控制算法,成功将等离子 体放电脉宽提升至 200ms 以上,且维持 I_p≥100kA 的时间超过了 100ms,上述结果表明 HL-2M 装置运行控制技术 得到了初步的检验。