Structural, (197)Au Mössbauer and solid state (31)P CP/MAS NMR studies on bis (cis-bis(diphenylphosphino)ethylene) gold(I) complexes [Au(dppey)(2)]X for X = PF(6), I

(197)Au M?ssbauer spectra for the d(10) gold(i) phosphine complexes, [Au(dppey)(2)]X (X = PF(6), I; dppey = (cis-bis(diphenylphosphino)ethylene), and the single crystal X-ray structure and solid state (31)P CPMAS NMR spectrum of [Au(dppey)(2)]I are reported here. In [Au(dppey)(2)]I the AuP(4) coordination geometry is distorted from the approximately D(2) symmetry observed for the PF(6)(-) complex with Au-P bond lengths 2.380(2)-2.426(2) A and inter-ligand P-Au-P angles 110.63(5)-137.71(8) degrees . Quadrupole splitting parameters derived from the M?ssbauer spectra are consistent with the increased distortion of the AuP(4) coordination sphere with values of 1.22 and 1.46 mm s(-1) for the PF(6)(-) and I(-) complexes respectively. In the solid state (31)P CP MAS NMR spectrum of [Au(dppey)(2)]I, signals for each of the four crystallographically independent phosphorus nuclei are observed, with the magnitude of the (197)Au quadrupole coupling being sufficiently large to produce a collapse of (1)J(Au-P) splitting from quartets to doublets. The results highlight the important role played by the counter anion in the determination of the structural and spectroscopic properties of these sterically crowded d(10) complexes.     

Nonplanar aromatic compounds. 9. Synthesis, structure, and aromaticity of 1:2,13:14-dibenzo[2]paracyclo[2](2,7)- pyrenophane-1,13-diene

Pyrenophane (6) and an octaphenyl derivative (16) were synthesized using two different routes. Both cyclophanes contain a severely bent pyrene unit (6: theta = 93.6 degrees and 16: theta = 95.8 degrees , according to DFT-calculations (B3LYP/6-311G**)), which was generated at room temperature by a valence isomerization/dehydrogenation (VID) reaction. HOMA and NICS indicate 92-98% retention of aromaticity of the highly distorted pyrene systems compared to planar pyrene.     

Fourier transform infrared observation of the nu3(sigmau) vibration of NiC3Ni in solid Ar

The Fourier transform infrared spectrum of linear NiC(3)Ni was observed by trapping the vapor produced from the dual ablation of nickel and carbon rods with Nd:YAG (yttrium aluminum garnet) lasers in solid Ar at approximately 10 K. Measurements of (13)C isotopic shifts have enabled the identification of the nu(3)(sigma(u)) vibrational fundamental at 1950.8+/-0.2 cm(-1), an asymmetric carbon stretching mode. Experimental results are in good agreement with the predictions of density functional theory at the B3LYP6-311G(*) level. Theoretical results suggest that the molecule is slightly floppy. Although other nickel carbide clusters have been studied theoretically or observed by photoelectron spectroscopy or mass spectrometry, this is the first report on the structure of NiC(3)Ni and its vibrational spectrum.     

Automatic generation of active coordinates for quantum dynamics calculations: application to the dynamics of benzene photochemistry

A new practical method to generate a subspace of active coordinates for quantum dynamics calculations is presented. These reduced coordinates are obtained as the normal modes of an analytical quadratic representation of the energy difference between excited and ground states within the complete active space self-consistent field method. At the Franck-Condon point, the largest negative eigenvalues of this Hessian correspond to the photoactive modes: those that reduce the energy difference and lead to the conical intersection; eigenvalues close to 0 correspond to bath modes, while modes with large positive eigenvalues are photoinactive vibrations, which increase the energy difference. The efficacy of quantum dynamics run in the subspace of the photoactive modes is illustrated with the photochemistry of benzene, where theoretical simulations are designed to assist optimal control experiments.     

Entrapment of functionalized silica microspheres with photo-initiated acrylate-based polymers

The entrapment of silica-based microspheres, commonly used as stationary phases in chromatography, with an organic porous polymer based on poly(butyl acrylate-co-1,3-butanediol diacrylate) was explored. The spheres were immobilized by photopolymerization leading to entrapped beds within 75 microm i.d. fused silica capillaries, and were mechanically stable, resisting pressure drops of over 5600 psi (38.6 MPa) for only 1 cm of material. The morphology of the polymer formation around the spheres was investigated by SEM and corroborated with back pressure measurements, which indicated that the spheres were held together by encapsulating polymer. The entrapped material was extruded from the capillary in some cases to facilitate imaging. The entrapment conditions were explored, varying the polarity of the sphere surface, the solvent, and the monomers, revealing that polymer formation is based on partitioning of the monomers between the surface and solvent. The resulting polymer morphology is discussed with respect to the effects of confinement, supported by experiments with varying microsphere diameters. The columns described here have favourable properties for use in capillary chromatography and supported catalysis among other applications, and is suitable for lab-on-a-chip devices.     

Reactions of tetrachloropyridazine with aliphatic nitrogen nucleophiles

Nucleophilic aromatic substitution reactions of tetrachloropyridazine with a series of aliphatic primary and secondary amines led selectively to products arising from replacement of chlorine at the 4‐position in all cases. The structures of the products were unambiguously confirmed by X‐ray crystallography. Substitution occurs at the most activated site para to ring nitrogen, despite the possible steric hindrance to substitution by adjacent chlorine atoms, reflecting the activating influence of ring nitrogen meta to the site of attack. N,N′‐Dimethylethylene diamine gave a mixture of [6,6] ring fused products following initial substitution at the 4‐position.