Size-related vaporisation and ionisation of laser-induced glass particles in the inductively coupled plasma

Ongoing discussions about the origin of elemental fractionation occurring during LA-ICP-MS analysis show that this problem is still far from being well understood. It is becoming accepted that all three possible sources (ablation, transport, excitation) contribute to elemental fractionation. However, experimental data about the vaporisation size limit of different particles in the ICP, as produced in laser ablation, have not been available until now. This information should allow one to determine the signal contributing mass within the ICP and would further clarify demands on suitable laser ablation systems and gas atmospheres in terms of their particle size distribution.The results presented here show a vaporisation size limit of laser induced particles, which was found at particle sizes between 90 nm and 150 nm using an Elan 6000 ICP-MS. Due to the fact that the ICP-MS response was used as evaluation parameter, vaporisation and ionisation limits are not distinguishable.The upper limit was determined by successively removing the larger particles from the aerosol, which was created by ablation of a NIST 610 glass standard at a wavelength of 266 nm, using a recently developed particle separation device. Various particle fractions were separated from the aerosol entering the ICP. The decrease in signal intensity is not proportional to the decrease in volume, indicating that particles above 150 nm in diameter are not completely ionised in the ICP. Due to the limited removal range of the particle separation device, which cannot remove particles smaller than 150 nm, single hole ablations were used to determine the lower vaporisation limit. This is based on measurements showing that larger particles occur dominantly during the first 100 laser pulses only. After this period, the ratio of ICP-MS counts and total particle volume was found to be constant while most of the particles are smaller than 90 nm, indicating complete vaporisation and ionisation of these particles.To describe the influence of different plasma forward powers on the vaporisation limit, the range 1000–1600 W was studied. Results indicate that optimum vaporisation and ionisation occurs at 1300 W. However, an increase of the particle ionisation limit towards larger particles was not observed within the accuracy of this study using the full range of parameters available for optimisation on commonly used ICP-MS instruments.     

Evaluation of polymeric flocculants for oily water systems using a photometric dispersion analyzer

During oil production and treatment, oil-in-water (O/W) emulsions are formed. These dispersions require treatment prior to disposal. In order to improve oil/water separation processes through any physical process (decanting, flotation, centrifuging etc), the particle size of the dispersed phase should be increased. This may be obtained by a flocculation process, which consists in the agglomeration of several particles or drops using as flocculating agent hydrophilic high molecular weight macromolecules. Poly (ethylene-b-propylene oxide) and poly (vinyl alcohol) polymers have been evaluated as flocculating agents for oily water systems. Their performance is related to the particle size increase of the dispersed phase. In this work, a photometric dispersion analyzer (PDA) has been used to accomplish the oil drop agglomeration. Synthetic as well as produced water was used. Data are in good agreement with previous tests. Qualitative information related to aggregates or particle size distribution of the oily water systems can be obtained using PDA.     

A theory of adsorption kinetics with time delay and its application to overshoot and oscillation in the surface tension of gelatin solution

A theory of adsorption kinetics with time delay [Ohshima et al. (1992) Colloid Polym. Sci. 270:707] is developed and applied to the surface tension of a polymer solution. It is found that the general appearance of the overshoot and oscillation in the time course of the surface tension of aqueous gelatin solution observed by Sato and Ueberreiter [(1979) Makromol. Chem. 180:829, 1107; (1979) Polym. Prepr. Am. Chem. Soc. Div. Polym. Chem. 20:907) can be explained by the present theory.     

The effect of β-cyclodextrin on the properties of cetyltrimethylammonium bromide micelles

The effect of ß-cyclodextrin (ß-CD) on cetyltrimethylammonium bromide (CTAB) micellar properties was studied by the determination of the diffusion coefficient, D. When the CTAB micelles have a spherical structure, D firstly increased and then remained unchanged, while the micellar aggregation number, N, decreased with the addition of ß-CD. When the CTAB concentration was less than the first critical micellar concentration, CTAB molecules could be included into ß-CD cavities with the molar ratio of CTAB to ß-CD being about 1:1. However, when the CTAB concentration was higher than the first critical micellar concentration, mixed spherical micelles were formed with the molar ratio of CTAB to ß-CD being 9:1.     

A sensitive and specific HPLC-MS method for the determination of sophoridine,sophocarpine and matrine in rabbit plasma

A sensitive and specific method was developed for the determination of sophoridine (SRI), sophocarpine (SC) and matrine (MT) in rabbit plasma by HPLC-MS. After an administration of Kuhuang by injection, blood samples were collected and extracted with methanol. The extract solutions were analysed by HPLC-MS method. The separation was performed on a ZORBAX Extend-C18 column using methanol/water/diethylamine (50:50:0.07, v/v/v) as mobile phase. The quinolizidine alkaloids were detected by using mass spectrometry in the SIM mode. There was a good linear relationship between peak area and concentration of analytes over the concentration range of 13.2–995.0 ng mL^–1 for SRI, 7.0–530.0 ng mL^–1 for SC and 8.8–655.0 ng mL^–1 for MT, respectively. The absolute recovery of this method was more than 57% for SRI, 87% for SC and 91% for MT. The accuracy of assay was more than 90%. The limits of detection (LODs) were 6.8 ng mL^–1 for SRI, 3.5 ng mL^–1 for SC and 4.2 ng mL^–1 for MT, respectively. The limits of quantitation (LOQs) were 13.2 ng mL^–1 for SRI, 7.0 ng mL^–1 for SC and 8.8 ng mL^–1 for MT, respectively. The intra-day and inter-day coefficients of variation (RSDs) were less than 10.1, 6.3 and 5.8% for SRI, SC and MT, respectively. The developed method was applied to determine the concentration–time profiles of SRI, SC and MT in rabbit plasma after injection of Kuhuang.     

Synthesis,Characterization and DNA-binding Properties of Three 3d Transition Metal Complexes of the Schiff Base Derived from Diethenetriamine with PMBP

A new ligand H₂L, 1,7-di(1-phenyl-3-methyl-5-pyrazolone-4-benzylidene)diethenetriamine and its three transition metal complexes, ML · nH₂O [M=Cu(II), n=2; M=Zn(II), n=0.5; M=Ni(II) (1), n=3] have been synthesized in anhydrous EtOH and characterized on the basis of elemental analyses, molar conductivities, i.r. spectra, u.v. spectra and thermal analyses. In addition, the DNA-binding properties of the ligand and its complexes have been investigated by absorption, fluorescence and viscosity measurements. The experimental results indicated that the ligand and the complex (1) can bind to DNA , but the other two complexes can’t; the binding affinity of the complex (1) is higher than that of the ligand and the intrinsic binding constant k_b of the complex (1) is 7.893×10⁵ m⁻¹.     

Mass spectral behavior of some homoleptic and mixed aryldichalcogenide bis(diphenylphosphino)ferrocenenickel(II), palladium(II), and platinum(II), and bis(diisopropylphosphino)ferrocenepalladium(II) complexes

The mass spectral behavior of a number of organometallic complexes containing the Group 10 metals Ni, Pd, and Pt, together with various thiolate ligands were studied. For Pd, two main types of complexes, differing by the substituents on the phosphorus atom were studied. Types I and II were substituted with bis(diphenylphosphino)ferrocene and bis(diisopropylphosphino)ferrocene ligands, respectively. The Ni complexes, except for one, and the Pd Type I complexes had no molecular radical cations (M(+.)) in their EI spectra. On the other hand, all the Pt complexes showed intense M(+.) ions in their EI spectra indicating that these complexes were more stable as radical cations than those of Ni and Pd. The FAB and MALDI spectra of all the complexes displayed intense quasi-molecular ions (MH(+)) and the fragmentations in both modes were similar. The MALDI spectra of several complexes displayed only M(+.) ions while one gave evidence of both MH(+) and M(+.) ions. Several Pd Type II complexes yielded intense M(+.) in their EI spectra.     

Surface-functionalized latex particles as controlling agents for the mineralization of zinc oxide in aqueous medium

Polystyrene latex particles modified at the surface with different hydrophilic functional groups were prepared by miniemulsion polymerization and used as controlling agents in the crystallization of zinc oxide from aqueous medium. The effects of the chemical nature of the surface functionalization and the latex concentration on the crystal growth, morphology, and crystalline structure of the resulting zinc oxide were analyzed. Micro- and submicrosized crystals with a broad variety of morphologies depending on the functionalization were obtained. Among the different latexes studied, the acrylic-acid-derived particles were shown to be a convenient system for further quantitative investigations. In this case, as the additive concentration increases, the length-to-width ratio (aspect ratio) of the crystals decreases systematically. Preferential adsorption of the latex particles onto the fast-growing faces {001} of ZnO is assumed to follow a Langmuir-type isotherm, and interaction of the adsorbed particles with the growth centers will reduce the growth rate in [001]. This leads to a quantitative relationship linking the aspect ratio to the latex concentration at constant diameter and surface chemistry of the latex. The dependence of the aspect ratio on charge density of the latex can also be modeled by an algorithm in which attractive forces between the latex particle and the ZnO surface are balanced against repulsive forces of an osmotic nature. The latter are associated with the confined volume between the crystal and latex particle surfaces.     

Cross-metathesis reaction of vinyl sulfones and sulfoxides

Cross-metathesis reactions of α,β-unsaturated sulfones and sulfoxides in the presence of molybdenum and ruthenium pre-catalysts were tested. A selective metahesis reaction was achieved between functionalized terminal olefins and vinyl sulfones by using the ‘second generation’ ruthenium catalysts 1c-h while the highly active Schrock catalyst 1b was found to be functional group incompatible with vinyl sulfones. The cross-metathesis products were isolated in good yields with an excellent (E)-selectivity. Both the molybdenum and ruthenium-based complexes were, however, incompatible with α,β- and β,γ-unsaturated sulfoxides.     

Separation of silver from waste waters by ion-exchange resins and concentration by microbial cells

Summary Waste waters of film processing plants are rich with silver. Part of the silver is regenerated electrochemically, but the rest (0.5 g) remains in waste waters and is sent to sewers. This is a bad politic from both the environmental (toxic waste waters) and the economical point of view (a waste of silver). In this work, the silver was isolated by ion-exchange resins and then concentrated by microorganisms. For exchange of silver, Ionenaustauscher I, II and IV were used. The batch method was used to obtain a static equilibrium. Silver elution from exchangers is based on silver transformation to a stable cation or anion complex. By varying the ligands, pH and eluent concentrations, optimum elution is found at 1 mol/l Na₂S₂O₃, 1 mol/l NH₃, 2 mol/l HNO₃ and 1 mol/l (NH₂)₂CO. The concentration of silver in the eluent is about 50 mg/l. The silver ion uptake from solutions after ion exchange by mixed bacterial culture isolated from photographic waste water drain and pure bacterial cultures Escherichia coli 3009 and Bacillus subtilis 3053. was studied. Experiments were carried out in submerse culture at pH 7 with different Ag⁺ concentrations (4, 8 and 40 mg/l) on a rotary shaker (100 rpm) at 37°C. At the lower Ag⁺ concentrations a good growth and simultaneous removal of Ag⁺ from the solutions was achieved. At Ag⁺ concentration of 40 mg/l growth and removal of Ag⁺ by mixed and pure culture differed significantly. Thus mixed bacterial culture grew well and at the same time removed efficiently Ag⁺ (approximately 90%) from medium. Pure bacterial cultures on the contrary were unable to grow at 40 mg/l Ag⁺, though their biomass showed to be an effective biosorbent for Ag⁺ (approximately 80% of Ag⁺ removal).