Hexa- and octanuclear iron(III) salicylaldoxime clusters

The syntheses, structures and magnetic properties of six iron complexes stabilised with the derivatised salicylaldoxime ligands Me-saoH(2) (2-hydroxyethanone oxime) and Et-saoH(2) (2-hydroxypropiophenone oxime) are discussed. The four hexanuclear and two octanuclear complexes of formulae [Fe(8)O(2)(OMe)(4)(Me-sao)(6)Br(4)(py)(4)]·2Et(2)O·MeOH (1·2Et(2)O·MeOH), [Fe(8)O(2)(OMe)(3.85)(N(3))(4.15)(Me-sao)(6)(py)(2)] (2), [Fe(6)O(2)(O(2)CPh-4-NO(2))(4)(Me-sao)(2)(OMe)(4)Cl(2)(py)(2)] (3), [Fe(6)O(2)(O(2)CPh-4-NO(2))(4)(Et-sao)(2)(OMe)(4)Cl(2)(py)(2)]·2Et(2)O·MeOH (4·2Et(2)O·MeOH), [HNEt(3)](2)[Fe(6)O(2)(Me-sao)(4)(SO(4))(2)(OMe)(4)(MeOH)(2)] (5) and [HNEt(3)](2)[Fe(6)O(2)(Et-sao)(4)(SO(4))(2)(OMe)(4)(MeOH)(2)] (6) all are built from a series of edge-sharing [Fe(4)(μ(4)-O)](10+) tetrahedra. Complexes 1 and 2 display a new μ(4)-coordination mode of the oxime ligand and join a small group of Fe-phenolic oxime complexes with nuclearity greater than six.     

Kinetics studies of the gas-phase reactions of NO3 radicals with series of 1-alkenes, dienes, cycloalkenes, alkenols, and alkenals

The gas-phase reactions of NO(3) radicals with series of 1-alkenes, dienes, cycloalkenes, alkenols, and alkenals were studied in pure N(2) or 20% O(2)/80% N(2) bath gas at room temperature and atmospheric pressure using a relative rates technique. Rate coefficients were derived from rates of loss of the organic compounds observed using a chemical ionization mass spectrometer. No difference in the measured kinetic data was observed in the presence or absence of O(2). The rate coefficients obtained (k (10(-13) cm(3) molecule(-1) s(-1)), with uncertainties representing 95% confidence intervals) are as follows: 1-hexene, 0.233 ± 0.021; 1-heptene, 0.245 ± 0.029; 1-octene, 0.292 ± 0.044; 1,3-butadiene, 1.24 ± 0.09; isoprene, 6.24 ± 0.11; 2,3-dimethyl-1,3-butadiene, 14.1 ± 0.5; 1,3-cyclohexadiene, 112 ± 8; cyclopentene, 4.82 ± 0.13; cyclohexene, 5.38 ± 0.20; cycloheptene, 5.28 ± 0.23; 2-buten-1-ol (crotyl alcohol), 3.23 ± 0.12; cis-2-penten-1-ol, 3.11 ± 0.11; cis-2-hexen-1-ol, 3.81 ± 0.38; trans-2-pentenal, 0.193 ± 0.040; trans-2-hexenal, 0.136 ± 0.029; trans-2-heptenal, 0.231 ± 0.036; cis-4-heptenal, 4.03 ± 0.24. The measured rate coefficients are compared to values from previous studies and three structure-activity relationships (SARs), and good agreement is found, in general. In particular, the recently developed SAR of Kerdouci et al. (Kerdouci, J.; Picquet-Varrault, B.; Doussin, J. ChemPhysChem2010, 11, 3909-3920.) is found to estimate the rate coefficients within 35% for all of the measured reactions except for NO(3) + 1,3-butadiene. The SAR prediction for that reaction is nearly 50% lower than the measured value, suggesting that it underestimates the effect of conjugation on the reaction of NO(3) with this small diene. The measured rate coefficients for reactions with a series of alkenols are used to modify the SAR substituent factor for the -CH(2)OH group, and those for reactions with a series of trans-2-alkenals are used to derive a substituent factor for the -C(O)H group, which was not included in the original SAR because of insufficient experimental data.     

Polymeric stabilized emulsions: steric effects and deformation in soft systems

Polymeric stabilizers are used in a broad range of processes and products, from pharmaceuticals and engine lubricants to formulated foods and shampoos. In rigid particulate systems, the stabilization mechanism is attributed to the repulsive force that arises from the compression of the polymer coating or "steric brush" on the interacting particles. This mechanism has dictated polymer design and selection for more than thirty years. Here we show, through direct measurement of the repulsive interactions between immobilized drops with adsorbed polymers layers in aqueous electrolyte solutions, that the interaction is a result of both steric stabilization and drop deformation. Drops driven together at slow collision speeds, where hydrodynamic drainage effects are negligible, show a strong dependence on drop deformation instead of brush compression. When drops are driven together at higher collision speeds where hydrodynamic drainage affects the interaction force, simple continuum modeling suggests that the film drainage is sensitive to flow through the polymer brush. These data suggest, for drop sizes where drop deformation is appreciable, that the stability of emulsion drops is less sensitive to the molecular weight or size of the adsorbed polymer layer than for rigid particulate systems.     

Photocatalytic disinfection of bacterial pollutants using suspended and immobilized TiO2 powders

The photocatalytic disinfection of Enterobacter cloacae and Enterobacter coli using microwave (MW), convection hydrothermal (HT) and Degussa P25 titania was investigated in suspension and immobilized reactors. In suspension reactors, MW‐treated TiO₂ was the most efficient catalyst (per unit weight of catalyst) for the disinfection of E. cloacae. However, HT‐treated TiO₂ was approximately 10 times more efficient than MW or P25 titania for the disinfection of E. coli suspensions in surface water using the immobilized reactor. In immobilized experiments, using surface water a significant amount of photolysis was observed using the MW‐ and HT‐treated films; however, disinfection on P25 films was primarily attributed to photocatalysis. Competitive action of inorganic ions and humic substances for hydroxyl radicals during photocatalytic experiments, as well as humic substances physically screening the cells from UV and hydroxyl radical attack resulted in low rates of disinfection. A decrease in colony size (from 1.5 to 0.3 mm) was noted during photocatalytic experiments. The smaller than average colonies were thought to occur during sublethal ^?OH and O₂^?? attack. Catalyst fouling was observed following experiments in surface water and the ability to regenerate the surface was demonstrated using photocatalytic degradation of oxalic acid as a model test system.     

Computational insight into the reductive oligomerisation of CO at uranium(III) mixed-sandwich complexes

Calculations reveal a multistep pathway towards formation of linear [U](2)-(μ-η(1):η(1)-C(2)O(2)); [U] = U(η-C(8)H(6){SiH(3)-1,4}(2))(η-Cp). However formation of deltate-bridged [U](2)-(μ-η(1):η(2)-C(3)O(3)) requires an alternative mechanism, involving a side-on [U](2)-(μ-η(2):η(2)-CO) complex and whereby the bridging units of [U](2)-(μ-η(2):η(2)-C(n)O(n)) intermediates (n = 1, 2) react directly with free CO.     

Electronic State Spectroscopy of 1,4-Pentadiene As Studied by VUV Photoabsorption Spectroscopy and ab Initio Calculations

We present high resolution VUV photoabsorption spectra of 1,4-pentadiene, C(5)H(8), over the wavelength range 115-247 nm (10.8-5.0 eV). These spectra reveal several new features not previously reported in the literature. These measurements are complemented by the first ab initio calculations for the three most abundant conformational isomers of 1,4-pentadiene, C(5)H(8), which we then use in the assignment of valence and Rydberg transitions. Calculations of the two lowest energy ionic states of 1,4-pentadiene are also presented and compared with the experimental data available in the literature. The measured absolute photoabsorption cross sections have been used to calculate the photolysis lifetime of 1,4-pentadiene in the upper stratosphere (20-50 km).     

"Virtual injector" flow tube method for measuring relative rates kinetics of gas-phase and aerosol species

A new method for measuring gas-phase and aerosol reaction kinetics is described in which the gas flow, itself, acts as a "virtual injector" continuously increasing the contact time in analogy to conventional movable-injector kinetics techniques. In this method a laser is directed down the length of a flow tube, instantly initiating reaction by photodissociation of a precursor species at every point throughout the flow tube. Key tropospheric reactants such as OH, Cl, NO(3), and O(3) can be generated with nearly uniform concentrations along the length of the flow tube in this manner using 355 nm radiation from the third harmonic of a Nd:YAG laser. As the flow travels down the flow tube, both the gas-phase and particle-phase species react with the photogenerated radicals or O(3) for increasingly longer time before exiting and being detected. The advantages of this method are that (1) any wall loss of gas-phase and particle species is automatically accounted for, (2) the reactions are conducted under nearly pseudo-first-order conditions, (3) the progress of the reaction is followed as a continuous function of reaction time instead of reactant concentration, (4) data collection is quick with an entire decay trace being collected in as little as 1 min, (5) relative rates of several species can be measured simultaneously, and (6) bimolecular rate constants at least as small as k = 10(-17) (cm(3)/molecule)/s, or aerosol uptake coefficients at least as small as γ = 10(-4), can be measured. Using the virtual injector technique with an aerosol chemical ionization mass spectrometer (CIMS) as a detector, examples of gas-phase relative rates and uptake by oleic acid particles are given for OH, Cl, NO(3), and O(3) reactions with most agreeing to within 20% of published values, where available.     

Structural biology of plant sulfur metabolism: From assimilation to biosynthesis

Covering: 1966 to 2012Sulfur is an essential element that must be assimilated by all organisms; however, the metabolic pathways for this task vary significantly, even among individual genera of bacteria, and especially so among eukaryotes. While all organisms require sulfurous amino acids, plants require specialized sulfur-containing metabolites, such as glucosinolates and allylsulfur compounds, for protection from herbivory and microbial infection; and the synthesis of specialized peptides (i.e., glutathione and phytochelatins) for protection against reactive oxygen species and exposure to transition metals, such as cadmium. In order to provide the complex array of sulfur-containing metabolites essential to plant viability, flux through the sulfur assimilatory pathway must be tightly regulated by controlling enzymatic activity. The X-ray crystal structures of several primary sulfur assimilatory enzymes, complemented by kinetics, have revealed mechanisms of enzymatic regulation (i.e., via redox state and protein-protein interaction) in these biosynthetic pathways, in addition to the chemical mechanisms of catalysis. This review summarizes the state of our structural knowledge of primary and secondary sulfur assimilatory enzymes from plants.     

Toward an Iron(II) Spin-Crossover Grafted Phosphazene Polymer

Two new cyclotriphosphazene ligands with pendant 2,2':6',2″-terpyridine (Terpy) moieties, namely, (pentaphenoxy){4-[2,6-bis(2-pyridyl)]pyridoxy}cyclotriphosphazene (L(1)), (pentaphenoxy){4-[2,6-terpyridin-4-yl]phenoxy}cyclotriphosphazene (L(2)), and their respective polymeric analogues, L(1P) and L(2P), were synthesized. These ligands were used to form iron(II) complexes with an Fe(II)Terpy(2) core. Variable-temperature resonance Raman, UV-visible, and M?ssbauer spectroscopies with magnetic measurements aided by density functional theory calculations were used to understand the physical characteristics of the complexes. By a comparison of measurements, the polymers were shown to behave in the same way as the cyclotriphosphazene analogues. The results showed that spin crossover (SCO) can be induced to start at high temperatures by extending the spacer length of the ligand to that in L(2) and L(2P); this combination provides a route to forming a malleable SCO material.     

Polychromatic decoupling of a manifold of homonuclear scalar interactions in solution-state NMR

Window-acquired tetrachromatic irradiation allows one to decouple simultaneously four amide protons in cyclosporine?A (wavy arrows; see figure) leading to simplified multiplets of the alpha protons. By inserting a manifold of polychromatic pulses in each dwell time, several subsystems can be decoupled simultaneously.