Self-calibration method for cerium-doped lanthanum bromide scintillator detector in the 0.1–2.0 MeV energy range

In recent years, the cerium-doped lanthanum bromide, LaBr₃ (Ce = 5 %) detector is increasingly playing an important role in radiation measurements because of its higher energy resolution (~3 % at 662 keV), faster luminescence decay time (~35 ns) and higher detection efficiency compared to 7.65 cm × 7.65 cm NaI(Tl) detector. Intrinsic spectra between 1,800 and 3,000 keV derived from internal radioactivity within LaBr₃(Ce) scintillators have been investigated in some literatures, and these results are confirmed by the experiments in this work. In this paper, a new method for LaBr₃(Ce) detector energy calibration from 100 to 2,000 keV is proposed using the intrinsic spectra (self-calibration) instead of the standard gamma sources. Proof-of-concept experiment results show that self-calibration can guarantee energy accuracy of better than 0.815 % and can be applied outside the laboratory. The stability and applicability of this method are also investigated systematically.     

石墨烯/锌铁氧体复合物的制备及抗菌性能

用氧化还原法和化学共沉淀法分别制备了石墨烯(GE)和石墨烯/锌铁氧体(GE/ZnFe2O4)复合物,通过现代测试技术表征了样品的物相结构、组成和微观形貌.以大肠杆菌、金黄色葡萄球菌和白色念珠菌为测试菌种,分别对样品的抗菌性能进行了研究.结果表明,样品的抗菌活性受GE/ZnFe2O4复合物中GE和ZnFe2O4质量比(mG/Z)以及菌种的影响,其中mG/Z=0.4的复合物对三种菌均有较好的抗菌效果,其最小抑菌浓度分别为25、25和12.5μg/mL;复合物对白色念珠菌的抗菌效果最好,这与菌种的结构有关.此外,对样品的抗菌机理进行了详细研究.     

紫外光辐照下CH3NH3PbI3基钙钛矿太阳能电池失效机制

随着光伏产业的不断发展,有机无机杂化钙钛矿太阳能电池的研发成为科学与工业界广泛关注的焦点。到目前为止,其光电转换效率已经提高到了25.2%,成为替代硅基太阳能电池的核心方案之一。然而,钙钛矿太阳能电池的稳定性较差,容易受到环境中氧气、水分、温度甚至光照的影响,这严重制约了其大规模推广与应用。大量科学研究表明,如何避免紫外辐照下有机无机杂化钙钛矿太阳能电池的性能衰减,对于提高钙钛矿太阳能电池的光照稳定性至关重要。然而到目前为止,仍然没有系统的工作来对紫外辐照下钙钛矿太阳能电池性能以及微结构演化过程进行详细的表征与分析。本文中,我们利用聚焦离子束-扫描电子显微分析(FIB-SEM)以及球差校正透射电子显微分析(TEM)等技术,全面地研究了紫外辐照过程中有机无机杂化钙钛矿太阳能电池性能变化规律以及电池微结构演化特征。实验结果表明,紫外辐照过程中太阳能电池内部会形成0.5–0.6 V的内建电场,钙钛矿中的I^-离子在电场的驱动下向金属Au电极和空穴传输层2, 2’, 7, 7’-四[N, N-二(4-甲氧基苯基)氨基]-9, 9'-螺二芴(Spiro-OMeTAD)一侧迁移;随后,空穴传输层与金电极的界面处,碘离子与光生空穴一起与金电极发生反应,将金属态Au氧化成离子态Au⁺。而Au⁺离子则在内建电场的驱动下反向迁移穿过钙钛矿MAPbI₃层,直接被SnO₂和MAPbI₃界面处的电子还原形成金属Au纳米团簇。除此之外,紫外辐照过程中钙钛矿太阳能电池性能降低的同时,往往伴随着Spiro-OMeTAD与钙钛矿界面处物质迁移、钙钛矿薄膜内晶界展宽以及Au纳米颗粒周围MAPbI₃物相分解等现象。以上各种因素的协同作用,共同导致了紫外光照下有机无机杂化钙钛矿太阳能电池光电转换性能(PCE)、开路电压(V_oc)以及短路电流(J_sc)等性能参数的急剧下降。     

Metal Sulfide Nanoparticle Synthesis with Ionic Liquids – State of the Art and Future Perspectives

Metal sulfides are among the most promising materials for a wide variety of technologically relevant applications ranging from energy to environment and beyond. Incidentally, ionic liquids (ILs) have been among the top research subjects for the same applications and also for inorganic materials synthesis. As a result, the exploitation of the peculiar properties of ILs for metal sulfide synthesis could provide attractive new avenues for the generation of new, highly specific metal sulfides for numerous applications. This article therefore describes current developments in metal sulfide nanoparticle synthesis as exemplified by a number of highlight examples. Moreover, the article demonstrates how ILs have been used in metal sulfide synthesis and discusses the benefits of using ILs over more traditional approaches. Finally, the article demonstrates some technological challenges and how ILs could be used to further advance the production and specific property engineering of metal sulfide nanomaterials, again based on a number of selected examples.     

Copper Nanoparticles In鄄Situ Anchored on Nitrogen鄄Doped Carbon for High鄄Efficiency Oxygen Reduction Reaction Electrocatalyst北大核心CSCD

Compared with noble metal platinum (Pt)-based catalysts, inexpensive non-noble metal electrocatalysts have attracted extensive attention for oxygen reduction reaction (ORR). Herein, chitosan as a kind of biomass resource rich in nitrogen and carbon was used to prepare nitrogen-doped carbon (N-C) and N-C in-situ anchored by copper nanoparticles (Cu/N-C). The as-obtained N-C and Cu/N-C nanoparticles were successfully used as non-noble eletrocatalysts tested for ORR. Compared with the N-C, the Cu/N-C showed the high surface area of 607.3 m2窑g-1 with the mean pore size of 2.5 nm and the pore volume of 0.40 cm3窑g-1. The most positive Gibbs free energy change was the rate determining step for ORR process with the 4e mechanism, where the value of the Cu (111)/N-C(-0.39 eV) was lower than that of the N-C(-0.26 eV). The Cu/N-C exhibited superior onset and half-wave potentials (0.96 V and 0.84 V, respectively) in alkaline media (0.1 mol窑L-1 KOH), all of which are much better than those measured for N-C and commercial Pt/C. Furthermore, the Cu/N-C showed superior methanol crossover avoidance and oxygen reduction stability. © 2021 Authors. All rights reserved.     

热处理对钙钛矿锰氧化物La_(0.95)Sr_(0.05)MnO_3离子价态和磁结构的影响

对于磁性氧化物的磁有序,传统的观点用超交换相互作用(SE)和双交换相互作用(DE)模型进行解释,其出发点都建立在全部氧离子是-2价的基础上.例如,对于LaMnO_3,认为其中的La和Mn都处于+3价,用SE模型解释相邻Mn~(3+)离子间的反铁磁序;当以二价的Sr离子替代一部分La离子后,认为等量的Mn~(3+)离子变为Mn~(4+)离子,用DE模型解释相邻Mn~(3+)和Mn~(4+)离子间的铁磁序.然而,事实上在氧化物中存在一部分负一价氧离子.Cohen[Nature 358 136]利用密度泛函理论计算了BaTiO_3的价电子态密度,结果得到只有Ba离子的化合价与传统观点相同,为+2价;而Ti和0分别为+2.89价和-1.63价,不是传统观点的+4价和-2价,但是与多年来关于氧化物电离度的研究[Rev.Mod.Phys.42 317]和X射线光电子谱(XPS)的研究结果相符合.本文经过不同热处理条件制备了名义成分为La_(0.95)Sr_(0.05)MnO_3的三个样品,通过对样品的XPS分析,发现样品中不存在Mn~(4+)离子,只存在Mn2+和Mn~(3+)离子,平均价态随热处理程序的增加而升高.尽管三个样品有相同的晶体结构,但磁矩明显不同.对于这样的性能,不能用SE和DE模型解释其磁结构.利用本课题组最近在研究尖晶石结构铁氧体磁有序过程中提出的O 2p巡游电子模型解释了这种现象,利用样品在10 K的磁矩估算出的Mn离子平均价态变化趋势与XPS分析结果一致.O 2p巡游电子模型的出发点建立在氧化物中存在一部分负一价氧离子的基础上,这是其与SE和DE模型的根本区别.     

Imaging intrinsic diffusion of bridge-bonded oxygen vacancies on TiO2(110)

We report the first measurements and calculations of the intrinsic mobility of bridge-bonded oxygen (BBO) vacancies on a rutile TiO2(110). The sequences of isothermal (340-420 K) scanning tunneling microscope images show that BBO vacancies migrate along BBO rows. The hopping rate increases exponentially with increasing temperature with an experimental activation energy of 1.15 eV. Density functional theory calculations are in very good agreement giving an energy barrier for hopping of 1.03 eV. Both theory and experiment indicate repulsive interactions between vacancies on a given BBO row.     

In situ synthesis of CdS/ZnS composite nanoparticles from ZIF-8 for visible light disposal of Cr(VI)

Journal of Sol-Gel Science and Technology - Zeolitic Imidazolate Framework (ZIF-8) micropolyhedra were employed as a raw material for the synthesis of fine cadmium sulfide/zinc sulfide (CdS/ZnS)...     

毛细管电泳法高效筛选8-氧代鸟嘌呤DNA糖基化酶的核酸适配体

8-氧代鸟嘌呤DNA糖基化酶(OGG1)是人体中重要的功能蛋白,在修复DNA氧化性损伤过程中起关键作用。氧化应激等引起的氧化损伤易导致炎症反应的发生,对OGG1的抑制可以一定程度上起到缓解作用;对癌细胞OGG1的抑制有望作为癌症治疗的新方法。目前的研究多集中于小分子对OGG1功能的影响和调控,而OGG1的适配体筛选尚未见报道。作为功能配体,适配体具有合成简单、高亲和力及高特异性等优点。该文筛选了OGG1的核酸适配体,结合毛细管电泳高效快速的优点建立了两种基于毛细管电泳-指数富集进化(CE-SELEX)技术的筛选方法:同步竞争法和多轮筛选法。同步竞争法利用单链结合蛋白(SSB)与核酸库中单链核酸的强结合能力,与目标蛋白OGG1组成竞争体系,并通过增加SSB浓度来增加竞争筛选压力,以去除与OGG1弱结合的核酸序列,一步筛选即可获得与OGG1强结合的核酸序列。多轮筛选法在相同孵育条件和电泳条件下,经3轮筛选获得OGG1的核酸适配体。比较两种筛选方法的筛选结果,筛选结果中频次最高的3条候选核酸适配体序列一致,其解离常数(K_D)值在1.71~2.64 μmol/L之间。分子对接分析结果表明候选适配体1(Apt 1)可能与OGG1中具有修复氧化性损伤功能的活性口袋结合。通过对两种筛选方法的对比,证明同步竞争法更加快速高效,对其他蛋白核酸适配体筛选方法的选择具有一定的指导意义。得到的适配体有望用于OGG1功能调控,以抑制其修复功能。