D-N交替法与Schwartz交替法的收敛关系分析

This paper has demonstrated that the Schwartz alternating process must converge if D-N alternating process has converged. Its technique is that the overlapping regions in Schwartz alternating process are considered as independent domains, then Schwartz alternating process could be transformed into D-N alter-nating process. Finally the convergence estimation of Schwartz alternating process could be obtained. The results show that its convergence rate is same as that of D-N alternating process.     

双光束相干控制产生多次谐波的实验验证

利用两束相干度可改变的飞秒脉冲光对产生的五次谐波的强度特性进行了研究，发现谐波信号的强度随相干程度的增大而增加，谐波信号的最大值相对于相干零点(双光束相干度最大处)是非对称的，从而证明了合成的激光脉冲波形变化对谐波信号的影响.同时对谐波的受激放大理论进行了初步的实验探索和展望. 关键词： 五次谐波 波形变化 相干 受激放大     

IMPULSIVE CONTROL OF A FISHERY SYSTEM

This paper uses the method of linear approximation for impulsive systems and gets a theorem which guarantees a fishery modei to be asymptotically stable at its equilibrium point and gives the ecological explanation.     

Li(AlxCo1-x)O2晶体中Co3+电子态的变化及对结构演化的影响

研究了应用于锂二次电池正极的新型高能量密度存贮材料Li(AlxCo1-x)O2 (x=01—05)的磁性.发现Al3+的掺杂可导致Co3+中d电子自旋态发生变化，即有部分d电子进入高自旋态.伴随Co3+中电子状态的改变，材料结构演化也发生了相应变化，表现为c/a比增大明显减缓，较好地解释了材料结构对Vegard定律的正偏离.这对材料的微观结构与性能设计具有重要意义. 关键词： 锂电池材料 Li（AlxCo1-x）O2 磁性 自旋态 结构演化     

双驱动x射线激光等离子体能谱特性研究

用时间积分空间分辨的平晶千电子伏谱仪测量了钽激光等离子体发射波长范围为045— 075nm的软x射线能谱，精确测量和准确辨认出类镍、类钴和类铁离子的共振线及类镍离子 的内壳层跃迁线-对实验结果处理，获得了辐射线谱的强度-通过谱线比率的诊断推断脉冲激 光时差对等离子体状态的影响，至少也可部分解释激光上能级的粒子数及等离子体的 电离程度- 关键词： 离子谱特性 软x线能谱强度 谱线辨认     

Ab-initio molecular dynamics simulation on nano-system under external pressure

A new constant-pressure molecular dynamics (MD) method is developed to simulate the dynamic behavior and structure transition of finite system under external pressure. In this method, no artificial parameter is introduced and the computation overheads are very small. As an application, a hard-soft transition of single wall carbon nanotube (SWCNT) under external pressure is found, which is in agreement with the experiments.

     

神光Ⅱ上柱形黑腔辐射驱动冲击波

利用神光Ⅱ的八路三倍频激光装置，驱动柱形黑腔产生的x 射线作辐射源驱动台阶铝样品产生冲击波，获得了清晰的冲击波图像，通过冲击波过台阶样 品的时间差获得冲击波速度和压力分别为31.2km/s和17.5×10⁵MPa.采用软x射线能谱 仪通过激光注入孔测量的辐射温度与采用冲击波法测量辐射温度的结果一致. 关键词： 冲击波 辐射驱动 辐射温度     

Hydrogen indium vacancy complex VInH4 in n-type InP studied by positron-lifetime

Positron-lifetime experiments have been carried out on two undoped n-type liquid encapsulated Czochralski (LEC)-grown InP samples with different stoichiometric compositions in the temperature range 10-300 K. For temperatures below 120 K for P-rich InP and 100 K for In-rich InP, the positron average lifetime began to increase rapidly and then leveled off, which was associated with the charge state change of hydrogen indium vacancy complexes from (V_InH₄)⁺ to (V_InH₄)⁰. This phenomenon was more obvious in P-rich samples that have a higher concentration of V_InH₄. The transformation temperature of approximately 120 K suggests that the complex V_InH₄ is a donor defect and that the ionization energy is about 0.01 eV. The ionization of neutral V_InH₄ accounted for the decrease of the positron average lifetime when the sample was illuminated with a photon energy of 1.32 eV at 70 K. These results provide evidence for hydrogen complex defects in undoped LEC InP.     

Evaluation of closed-vessel microwave digestion method for the determination of trace impurities in polymer-based photoresist by inductively coupled plasma mass spectrometry

A closed microwave digestion method followed by inductively coupled plasma spectrometric (ICP-MS) analysis was evaluated for the determination of trace impurities in photoresist. To optimize the digestion procedure, several digestion parameters such as acid, heating temperature and heating time were evaluated. Besides, the digestion efficiency of used photoresist material and the recovery of analyte elements obtained by the use of gravimetric method and ICP-MS measurement, individually, were also compared to clarify the completeness of digestion. According to our experiments, the gravimetric method was found to be not so relevant to the completeness of digestion, because the remaining sample matrix could cause suppression effect in the subsequent ICP-MS measurement. In view of minimizing blank value and working time, a simple single-step heating program was proposed to mineralize 0.25 ml of photoresist material with 5 ml of nitric acid at 180 °C for 10 min. Based on the comparative study of the analytical results obtained by instrumental neutron activation analysis (INAA) and proposed method, the reliability of proposed method for the determination of trace metallic impurities in photoresist material has been confirmed.