Array of electrodeposited Ru-decorated TiO<Subscript>2</Subscript> nanotubes with enhanced photoresponse

Although TiO₂ anatase phase has been widely chosen as the main photocatalyst, it presents high electron/hole recombination rate. However, today, what is sought is a semiconductor material with enhanced photocatalytic activity with higher photon to electron conversion efficiency by introduction of electrons trap dopants. In this paper, TiO₂ nanotubes arrays obtained by anodization of Ti substrates were decorated with Ru via electrodeposition, and their photo-response was investigated. First, voltammetric experiments were performed to elucidate the route of Ru reduction on the TiO₂ surface and to select the range of potentials for Ru deposition. The reduction potentials were used for controlling the amount of Ru distributed all over the surface. Although Ru was electrodeposited at potentials over the range from ??0.025 to ??0.188 V vs. Ag/AgCl, the deposition of 3.7 mC cm^?2 at ??0.100 V for 30 min resulted in a tenfold greater photocurrent when compared to the recorded photocurrent for the undecorated TiO₂ nanotubes array. Next, Ru-decorated TiO₂ nanotubes with a length of 323?±?18 nm and inner and outer diameters of 91 and 104 nm, respectively, were characterized using SEM-WDS, SEM-FEG, XRD, and XPS. UV-Vis-NIR diffuse reflectance spectroscopy and photoluminescence (PL) measurements, which revealed a maximum PL emission at 445 nm, showed that for the array of Ru-decorated TiO₂ nanotubes, the electron-hole recombination may be effectively inhibited by the presence of ruthenium electrodeposited, which can make this photocatalyst even more attractive for environmental applications. The performances of the TiO₂ and Ru-decorated TiO₂ catalysts were compared in heterogeneous photocatalysis experiments for color removal of an azo-dye, which presented a pseudo-first-order rate constant more than twofold greater for the Ru-decorated TiO₂ catalysts.     

Selective recovery of solutes from ionic liquids by pervaporation--a novel approach for purification and green processing

Non-porous membranes with the selective layer consisting of hydrophilic or hydrophobic polymers have been applied for the quantitative and selective recovery of solutes with different physico-chemical properties from a room-temperature ionic liquid, ([bmim][PF6]).     

On the correlation between thermal analysis results and corrosion behaviour of some metallic religious artefacts

The aim of this study was to investigate the effects of immersion time on the electrochemical corrosion behaviour of three brass alloys (CuZn) coming from religious artefacts in simulated acid rain at 25 °C, utilising the electrochemical impedance spectroscopy (EIS). The main parameters of the corrosion process were established. On the other hand, the alloys were also analysed by means DSC and TG/DTA before and after immersion in the corrosive environment. Finally, the obtained results were compared in order to correlate them with each other and with the corrosion process.     

Azaphenanthrene alkaloids with antitumoral activity from Anaxagorea dolichocarpa Sprague & Sandwith (Annonaceae)

Phytochemical investigation of Anaxagorea dolichocarpa Sprague & Sandwith led to isolation of three azaphenanthrene alkaloids: eupolauramine, sampangine and imbiline 1. Their chemical structures were established on the basis of spectroscopic data from IR, HR-ESI-MS, NMR (including 2D experiments) and comparison with the literature. Sampangine and imbiline 1 are being described in the Anaxagorea genus for the first time. Eupolauramine and sampangine show concentration-dependent antitumoral activity in leukemic cells K562 with IC(50) of 18.97 and 10.95 μg/mL, respectively.     

Charge carrier mobility and concentration as a function of composition in AgPO3-AgI glasses

Conductivity data of the xAgI(1 - x)AgPO(3) system (0 ≤ x ≤ 0.5) were collected in the liquid and glassy states. The difference in the dependence of ionic conductivity on temperature below and above their glass transition temperatures (T(g)) is interpreted by a discontinuity in the charge carrier's mobility mechanisms. Charge carrier displacement occurs through an activated mechanism below T(g) and through a Vogel-Fulcher-Tammann-Hesse mechanism above this temperature. Fitting conductivity data with the proposed model allows one to determine separately the enthalpies of charge carrier formation and migration. For the five investigated compositions, the enthalpy of charge carrier formation is found to decrease, with x, from 0.86 to 0.2 eV, while the migration enthalpy remains constant at ≈0.14 eV. Based on these values, the charge carrier mobility and concentration in the glassy state can then be calculated. Mobility values at room temperature (≈10(-4) cm(2) V(-1) s(-1)) do not vary significantly with the AgI content and are in good agreement with those previously measured by the Hall-effect technique. The observed increase in ionic conductivity with x would thus only be due to an increase in the effective charge carrier concentration. Considering AgI as a weak electrolyte, the change in the effective charge carrier concentration is justified and is correlated to the partial free energy of silver iodide forming a regular solution with AgPO(3).     

An efficient one-pot synthesis of strongly fluorescent (hetero)arenes polysubstituted with amino and cyano groups

An efficient one-pot synthesis simultaneously results in three types of densely substituted mono-, di- and tetracyclic π-systems, which can easily be isolated. Each chromophore presents a strong fluorescence emission, either in the red, green or blue part of the spectrum.     

Charge state distribution studies of pure and oxygen mixed krypton ECR plasma – signature of isotope anomaly and gas mixing effect

We report the charge state distributions of the pure, 25% and 50% oxygen mixed krypton plasma to shed more light on the understanding of the gas mixing and the isotope anomaly [A. G. Drentje, Rev. Sci. Instrum. 63 (1992) 2875 and Y Kawai, D Meyer, A Nadzeyka, U Wolters and K Wiesemann, Plasma Sources Sci. Technol. 10 (2001) 451] in the electron cyclotron resonance (ECR) plasmas. The krypton plasma was produced using a 10 GHz all‐permanent‐magnet ECR ion source. The intensities of the highly abundant four isotopes, viz. ⁸²Kr (~11.58%), ⁸³Kr (~11.49%), ⁸⁴Kr (~57%) and ⁸⁶Kr (17.3%) up to ~ +14 charge state have been measured by extracting the ions from the plasma and analysing them in the mass and the energy using a large acceptance analyzer‐cum‐switching dipole magnet. The influence of the oxygen gas mixing on the isotopic krypton ion intensities is clearly evidenced beyond +9 charge state. With and without oxygen mixing, the charge state distribution of the krypton ECR plasma shows the isotope anomaly with unusual trends. The anomaly in the intensities of the isotopes having quite closer natural abundance, viz. ⁸²Kr, ⁸⁶Kr and ⁸³Kr, ⁸⁶Kr is prominent, whereas the intensity ratio of ⁸⁶Kr to ⁸⁴Kr shows a weak signature of it. The isotope anomaly tends to disappear with increasing oxygen mixing in the plasma. The observed trends in the intensities of the krypton isotopes do not follow the prediction of linear Landau wave damping in the plasma. Copyright © 2016 John Wiley & Sons, Ltd.     

Biocompatible titania hydrogels with chemically triggered release of a photosensitive dye

5,10,15,20-Tetrakis(4-sulfonatophenyl)porphyrin was entrapped into biocompatible hydrogels formed by self-assembling micelles of the titanium dioxide prepared by hydrolysis of titanium ethoxide modified with triethanolamine (TEA). The materials were characterized by their optical and photosensitive properties. The immobilization led to changes of the absorption spectra of the dye and decreased its molar absorption coefficient. The TiO₂ matrix did not degrade the entrapped porphyrin upon u.v. irradiation. The formation of TEA–titanium(IV) chelates facilitated a controlled and triggered release of the immobilized dye from the hydrogels in lactate and citrate buffers. The released dye prolonged the sterility of citrate–phosphate buffer and its illumination with visible light inhibited growth of Aspergillus niger.     

Nanostructures of sodium titanate/zirconium oxide

In this work is reported the synthesis of nanotubes and nanoribbons from mixed oxides (Ti_1−x Zr _x O₂·nH₂O), employing hydrothermal treatment in a highly alkaline medium. The morphology and crystal structure of the products obtained via hydrothermal treatment depend on the value of x. For example, for x equal to 0 and 0.50 were observed the presence of nanotubes (diameter around 9 nm) and nanoribbons (diameter around 200 nm), respectively. However, for x values above 0.50, there was no morphological change. Regarding the crystalline structure of these samples, for x equal to 0 was observed the sodium titanate phase; already for x values up to 0.50, we observed the presence of two crystalline phases: sodium titanate and tetragonal ZrO₂. For x values above 0.50, only tetragonal ZrO₂ was observed. Furthermore, only the product obtained from x equal to 0.15 was observed the presence of three-dimensional flower-like arrangements. The results obtained by the characterization techniques showed the segregation of zirconium after hydrothermal treatment of precursors with x less or equal to 0.50. Thus, we describe the important role that Ti/Zr molar ratio of the precursor plays on the morphology and crystalline phase of the products formed by hydrothermal treatment.