Time calibration for the end cap TOF system of BESⅢ

The time calibration for end cap TOF system of BESⅢ is studied in this paper.It has achieved about 110 ps time resolution for muons in dimu events.The pulse height correction using electronic scan curve and the predicted time calculated using Kalman filter method are introduced.This paper also describes the study of using electrons and muous as calibration samples.     

Growth of Semi-Insulating GaN Using N2 as Nucleation Layer Carrier Gas Combining with an Optimized Annealing Time

Semi-insulating （SI） GaN is grown using N2 as the nucleation layer （NL） carrier gas combined with an optimized annealing time by metalorganic chemical vapour deposition. Influence of using 1-12 and N2 as the NL carrier gas is investigated in our experiment. It is found that the sheet resistance of unintentionally doped GaN can be increased from 10^4 Ω/sq to 10^10 Ω/sq by changing the NL carrier gas from 1-12 to N2 while keeping the other growth parameters to be constant, however crystal quality and roughness of the tilm are degraded unambiguously. This situation can be improved by optimizing the NL annealing time. The high resistance of GaN grown on NL using N2 as the carrier gas is due to higher density of threading dislocations caused by the higher density of nucleation islands and small statistic diameter grain compared to the one using 1-12 as carrier gas. Annealing the NL for an optimized annealing time can decrease the density of threading dislocation and improve the tilm roughness and interface of AlGaN/GaN without degrading the sheet resistance of as-grown GaN signiticantly. High-quality SI GaN is grown after optimizing the annealing time, and AlGaN/GaN high electron mobility transistors are also prepared.     

Optimization on Synchrotron Radiation Lattice of BEPCII

The Beijing Electron and Positron Collider II （BEPCII） is a double ring electron positron collider, which can also be used as a synchrotron radiation （SR） light source. Since the BEPCII will start commissioning with SR mode in November 2006, it is essential to have a satisfying SR lattice. Here we first perform frequency map analysis on the original BEPCII SR lattice. The result shows that the resonance is really severe in the lattice and the transverse motion of particles is unstable. Then a new SR lattice is designed to obtain a large dynamic aperture and much more stable transverse motion. The dynamic aperture of the new lattice including nonlinear wiggler effect is calculated to be very good. This new SR lattice can be used in the commissioning stage of the BEPCII.     

双掺杂LiNbO3:Fe:Mn全息存储动力学

建立了包括扩散、漂移和光伏打效应三种输运机制,小信号光强、小调制度近似下描述双掺杂LiNbO3:Fe:Mn晶体用双色光进行全息存储的动力学的耦合微分方程组,数值求解并解释了晶体光存储的时间动态发展过程.在此基础上,分析了晶体的氧化还原程度对全息存储过程的影响,只有在晶体总的受主数密度Na(即Fe3+和Mn3+的数密度之和)大于铁离子数密度N2的条件下,双掺杂LiNbO3:Fe:Mn晶体全息存储才能达到非破坏性存储的目的.经过光固定的光栅的衍射效率随氧化增大,光折变灵敏度随氧化而减小,要获得高衍射效率就必须以降低光折变灵敏度为代价.在掺铁浓度一定的情况下,掺锰浓度越高,能实现信息长期存储对应的氧化还原状态的有效动态范围越大.     

Bohr-Mottelson公式对超形变带的比较研究

用Bohr-Mottelson的两参数、三参数和四参数公式对A～190区61条超形变带进行了系统分析. 结果显示:3个公式都能较好地拟合190区超形变带的E2跃迁谱,而且带首自旋的确定基本一致. 大部分带Bohr-Mottelson的三参数数值关系符合ab公式的理论预期值,小部分带的三参数数值关系符合Harris公式的理论预期值. 一半以上带的四参数数值关系与ab公式的预期值接近,而与Harris公式的预期值偏离较大. 表明两参数ab公式比Harris公式具有更广泛的实用性.     

重叠微孪晶界面条纹象的电子显微镜观察与强度计算

观察了面心立方镍基合金中重叠微孪晶界面的各种条纹象,发现它们与α条纹及σ条纹不同,当改变基体或孪晶偏离参量的正负号时,重叠区域条纹的衬度会发生明显的改变,本文将多束动力学衍射理论的叠代法用于重叠孪晶界面几种条纹强度的模拟计算,计算束数包括基体、孪晶及其二次衍射在内共九束,计算的强度曲线与实验强度曲线符合良好,分析结果指出,重叠孪晶界面条纹衬度的明显变化是异常吸收或异常透射效应及基体-孪晶-基体三层晶体多束动力学交互作用的结果。 关键词：     

THE KINETIC EFFECTS OF THE RUNAWAY ELECTRONS DURING THE DISCHARGE PROCESS IN THE TOROIDAL SYSTEM

In this paper, the kinetic effects of the runaway electrons during the discharge process in the toroidal system are investigated, taking into account the effects of the, curvature and the gradient of the magnetic field. The density and the temperature of the electrons are inhomogeneous and some criterions of the.instabilities are obtained.     

Lamb wave sensors array for nonviscous liquid sensing

The interdigital transducer (IDT) can excite Lamb wave in a piezoelectric plate loading with a liquid layer, and the phase velocity of Lamb wave is associated with the properties of the liquid layer. In this paper, the concept of effective permittivity is introduced to study the Lamb wave’s potential application in liquid sensing. Considering the measuring of ideal nonviscous liquid, the sensors array is designed to sense the density and the dielectric constant of the liquid layer simultaneously. Using LiNbO₃ as piezoelectric material, in order to improve the sensors array sensitivity and the electro-mechanical coupling coefficient, the optimized results including plate thicknesses and cut orientations are presented by numerical simulation. These studies show that the Lamb wave sensors array can be potential in liquid sensing.