Lateral interactions in the thermal desorption of H2 from clean Cu/Ni(110) alloy surfaces

The adsorption of hydrogen on a clean Cu10%/Ni90% (110) alloy single crystal was studied using flash desorption spectroscopy (FDS), Auger electron spectroscopy (AES), and work function measurements. Surface compositions were varied from 100% Ni to 35% Ni. The hydrogen chemisorption on a-surface of 100% nickel revealed strong attractive interactions between the hydrogen atoms in accordance with previous work on Ni(100). Three desorption states (β₁, β₂ and α) appeared in the desorption spectra. The highest temperature (α) state was occupied only after the initial population of the β₂-state. As the amount of copper was increased in the nickel substrate, desorption from the higher energy binding α-state was reduced, indicating a decrease in the attractive interactions among hydrogen atoms. The hydrogen coverage at saturation was not affected by the addition of copper to the nickel substrate until the copper concentration was greater than 25% at which a sharp reduction in saturation coverage occurred. This phenomenon was apparently due to the adsorption of hydrogen on Ni atoms followed by occupation of NiNi and CuNi bridged adsorption sites, while occupation of CuCu sites was restricted due to an energy barrier to migration.     

Rb saturation spectroscopy with an optically narrowed FM diode laser

A fast-frequency modulated (FM) diode laser has been optically narrowed using the technique of resonant optical feedback, to provide linewidths in each FM mode of ≈ 200 kHz peak-to-peak. With a drive frequency of 50 MHz and modulation index of 0.2, the FM laser has been used for the first time to obtain Doppler-free FM spectra of the Rb D₁ line at 795 nm. The potential use of this system for laser frequency stabilisation is discussed.     

The measurement of subcritical electroconvection

Under idealized conditions, electroconvection in a nematic liquid crystal sets in at a well-defined threshold of the driving ac voltage. Fluctuating convection rolls of a small amplitude below that threshold have been observed recently. The measurement of the amplitude of these fluctuations is described in detail in this paper. It is based on averaging the light intensity signals using the structure function and a quantitative analysis of the light deflection.     

The Implications of Cognitive-style Findings for Operational Research

Cognitive style refers to differences that can be perceived in individuals due to differing cognitive structures. There has been a large amount of research on how cognitive style affects managerial decision-making, particularly in the context of management information systems, but little or no attempt to relate these findings to operational research. This paper reviews the findings of cognitive-style research from the perspective of operational research, and draws a number of useful inferences concerning the matching of OR aids to managers, the presentation of information and recommendations, the use and acceptance of OR, and the structure of OR groups. Further, it is argued that cognitive-style findings help to give a justification to the move towards ‘soft’ approaches to analysis.     

Buchbesprechungen

Ohne Zusammenfassung

---

Book reviews

     

Electron traps and positive DLTS signals in VPE GaAs MESFETs

Capacitance DLTS measurements have been performed in VPE GaAs MESFETs prepared on Bridgman Cr-doped and LEC undoped semi-insulating substrates. A band of electron traps not intrinsically related to the VPE growth process and accumulating near the metal (gate) — semiconductor interface was detected in all the samples. Deeper regions into the channel were free from any detectable trap. Near pinch-off conditions, a positive capacitance signal was found to dominate the DLTS spectra only in the case of samples prepared on Cr-doped substrates. The hypothesis of this positive transient being related to changes in the occupation of surface states in the ungated surface access regions has been checked by comparing experimental and calculated dependencies of the signal amplitude on reverse gate voltage. Unexplained discrepancies, together with the absence of positive signal in MESFETs prepared on LEC undoped substrates, suggest the possibility of hole emission from hole traps within the bulk of the device.     

Porosity and typical properties of real-valued continuous functions

Some well-known theorems on typical properties of real-valued continuous functions defined on [0, 1] are improved using the notion of porosity.     

Exact soliton solutions of spinor Bose-Einstein condensates

We study matter-wave solitons in Bose-Einstein condensates of ultracold gaseous atoms with spin degrees of freedom and present a class of exact solutions based on the inverse scattering method. The one-soliton solutions are classified with respect to the spin states. We analyze collisional effects between solitons in the same or different spin state(s), which reveals a very interesting possibility: we can manipulate the spin dynamics by controlling the parameters of colliding solitons.     

Acoustic field in a closed layered shell with resonant systems

The acoustic field inside a shell excited by a spatially inhomogeneous harmonic pressure field is studied. The shell is assumed to have a finite length, a set of orthogonal stiffening ribs, two ends bounding the acoustic volume, and a sound-insulating structure, which includes layers of sound-insulating material, resonant elements, and an interior panel. The shell is considered to be orthotropic with boundary conditions corresponding to a free support. For the acoustic field in the closed volume, analytical expressions are derived with allowance for the elastoacoustic interaction of the shell with the sound-insulating layers and with the medium both inside the shell (with arbitrary impedance values at the ends) and outside it. These expressions are used to investigate the effect of different types of resonant systems on the sound field inside the shell.