CuAl2Cl8. Darstellung und Kristallstruktur

CuAl₂Cl₈. Preparation and Crystal Structure. Crystals of CuAl₂Cl₈ have been prepared. Their remission spectrum agrees with that of gaseous CuAl₂Cl₈. The crystal structure (P2₁/c;a = 6.614, b = 7.376, c = 12.319 Å; β = 94.11°) shows a molecular lattice with Cu in square planar coordination, which is completed to a stretched octahedron (as in solid CuCl₂) by two Cl atoms from neighbour molecules. Al has tetrahedral coordination.     

Properties of ITO films prepared by reactive magnetron sputtering

Indium tin oxide (ITO) thin films were deposited by mid frequency pulsed dual magnetron sputtering using a metallic alloy target with 10 wt.% tin in an atmosphere of argon and oxygen. The aim of the work was to study the interdependence of structural, electrical and optical properties of ITO films deposited in the reactive and transition target mode, respectively. The deposition rate in the transition mode exceeds the deposition rate in the reactive mode by a factor of six, a maximum value of 100 nm·m min⁻¹ could be achieved. This corresponds to a static deposition rate of 200 nm min⁻¹. The lowest electrical resistivity of 1.1·10⁻³ Ω cm was measured at samples deposited in the high oxygen flow range in the transition mode. The samples show a good transparency in the visible range corresponding to extinction coefficients being below 10⁻². X-ray diffraction was used to characterise crystalline structure as well as film stress. ITO films prepared in the transition mode show a slightly preferred orientation in (211) direction, whereas films deposited in the reactive mode are strongly (222) oriented. Compared to undoped In₂O₃ all samples have an enlarged lattice. The lattice strain perpendicular to the surface is about 0.8% and 2.0% for films grown in the transition and the reactive mode, respectively. Deposition in the transition mode introduces a biaxial film stress in the range of −300 MPa, while stress in reactive mode samples is −1500 MPa.     

Investigating the interface of superhydrophobic surfaces in contact with water

Neutron reflectivity (NR) is used to probe the solid, liquid, vapor interface of a porous superhydrophobic (SH) surface submerged in water. A low-temperature, low-pressure technique was used to prepare a rough, highly porous organosilica aerogel-like film. UV/ozone treatments were used to control the surface coverage of hydrophobic organic ligands on the silica framework, allowing the contact angle with water to be continuously varied over the range of 160 degrees (superhydrophobic) to <10 degrees (hydrophilic). NR shows that the superhydrophobic nature of the surface prevents infiltration of water into the porous film. Atomic force microscopy and density functional theory simulations are used in combination to interpret the NR results and help establish the location, width, and nature of the SH film-water interface.     

CAROTENOID TRIPLET STATES IN PHOTOSYNTHETIC BACTERIA

Abstract— The triplet state spectra of anaerobically grown cells of Rhodopseudomonas sphaeroides GIC and R. sphaeroides wild type and aerobically grown cells of R. sphaeroides wild type were examined under reducing and non-reducing conditions at 100 K. by electron paramagnetic resonance (EPR). Large differences in the zero field splitting parameters, |D| and |E| of the triplets are seen to arise in the different preparations. The spectra are assigned to the triplet states of carotenoids, some of which are closely associated with the reaction center and others are contained in the light harvesting complex. Taken together with the triplet state data on Rhodospirillum rubrum wild type previously published the trends in the zero field splitting parameters can be understood in terms of the extent of electron derealization in carotenoids of varying length.     

Simple evaluation of Franck–Condon factors and non‐Condon effects in the Morse potential

The calculation of Franck–Condon factors between different 1‐D Morse potential eigenstates using a formula derived from the Wigner function is discussed. Our numerical calculations using a simple program written in Mathematica are compared with other calculations. We show that our results have a similar accuracy as those calculations performed with more sophisticated methods. We discuss the extension of our method to include non‐Condon effects in the calculation. © 2002 Wiley Periodicals, Inc. Int J Quantum Chem 88: 280–295, 2002