Application of rainbow schlieren deflectometry to measure temperature and oxygen concentration in a laminar gas-jet diffusion flame

The quantitative rainbow schlieren deflectometry (RSD) technique was applied to measure temperature and oxygen concentration in an axisymmetric hydrogen gas-jet diffusion flame burning in quiescent air at fuel jet exit Reynolds number of 70. Schlieren measurements were compared with conventional measurements using a thermocouple and a gas-sampling probe. Good agreement between the two measurement techniques was achieved on the fuel-lean side of the flame.     

Flow regime identification in a two-phase flow using wavelet transform

This study addresses the problem of the automatic flow regime identification in two-phase flows in pipes. A novel wavelet transform-based approach is proposed and validated using time series of differential pressure fluctuations. The experimental data on the differential pressure measured in a vertically installed Venturi meter for air-water flow were analyzed and found to be appropriate for flow regime identification. The wavelet spectrum of the measured signal is shown to characterize the flow patterns completely, and the vector of the wavelet variances is proposed as the characteristic vector for use in an on-line flow regime identification system.     

A Recursive Algorithm for Order Cycle-time that Minimizes Logistics Cost

A firm's logistics cost, including shipping and inventory-carrying, is a substantial percentage of its sales. Nevertheless, typical inventory-control methods ignore or insufficiently represent the shipping cost. This paper describes a recursive algorithm that determines the reorder cycle-time that minimizes total logistics cost. It allows for a realistic accounting of shipping cost, which is modelled here as a function of shipping distance and weight. The algorithm uses a relaxation procedure to identify a suitable initial approximation to the optimal order cycle-time and then, through a series of recursive steps, moves to the optimal result. We demonstrate the algorithm with a single item, with a group of items that share a common order cycle, and with multi-items when item demands are random variables. Experience with this algorithm indicates that it converges to the optimal result in a very few steps.     

A Language for Teaching Discrete-event Simulation

Courses which teach discrete-event simulation are based on many different simulation languages. The requirements for a language to support teaching simulation are discussed. In particular, it is recommended that such languages separate into distinct modules those aspects of simulation which are taught as separate topics. Implementation of the separation is discussed. The SEESIM language, developed as a teaching aid, is described, and examples of its use are given. Straightforward use of SEESIM can be learned quickly, yet the language provides facilities for a staged introduction to advanced concepts of simulation.     

CsI(Tl)晶体中反冲Cs和I核Quenching?Factor的测量

许多实验对用CsI(Tl)闪烁晶体作为探测器来寻找和探测暗物质的可行性进行了研究.本工作利用8MeV单能中子轰击CsI(Tl)晶体探测器来研究Cs核和I核的QuenchingFactor.在数据处理中,运用脉冲形状甄别(PSD)方法来分辨反冲核信号和本底信号.实验结果表明,在7keV到132keV的能区中,Quench ingFactor随着反冲核能量的减少而增加.在探测暗物质的实验中,这一性质对于CsI(Tl)晶体探测器获得较低的能量阈值是很有利的.     

The operational performance of the Yale ESTU

The ESTU began operation in 1988 and achieved the design voltage of 20 MV in 1990. Since that time, improvements to the gas handling system, negative ion injector, accelerator terminal and control system have greatly increased its capability and reliability. Today, the ESTU can efficiently produce an extensive assortment of stable ions at wide-ranging energies in support of low-energy nuclear physics.     

Formation of hydrogenated amorphous carbon films from polymer pyrolysis

Free-standing and supported hydrogenated amorphous carbon films (a:C–H) were prepared upon pyrolysis of the polymer formed by ethanolamine (EA) and citric acid (CA), under an ambient atmosphere at 300 °C. EA facilitates the formation of the macroscopic films, while CA is essential for obtaining the a:C–H microstructure, which comprises a mixture of sp² and sp³ carbon. Received: 29 May 2001 / Accepted: 17 August 2001 / Published online: 20 December 2001     

Structures and stability of Al<Subscript><Emphasis Type="Bold">7</Emphasis></Subscript>C and Al<Subscript><Emphasis Type="Bold">7</Emphasis></Subscript>N clusters

We report results of the atomic and electronic structures of Al₇C cluster using ab initio molecular dynamics with ultrasoft pseudopotentials and generalized gradient approximation. The lowest energy structure is found to be the one in which carbon atom occupies an interstitial position in Al₇ cluster. The electronic structure shows that the recent observation [Chem. Phys. Lett. 316, 31 (2000)] of magic behavior of Al₇C^- cluster is due to a large highest occupied and lowest unoccupied molecular orbital (HOMO-LUMO) gap which makes Al₇C^- chemically inert. These results have further led us to the finding of a new neutral magic cluster Al₇N which has the same number of valence electrons as in Al₇C^- and a large HOMO-LUMO gap of 1.99 eV. Further, calculations have been carried out on (Al₇N)₂ to study interaction between magic clusters. Received 28 July 2001     

Nonlinear optical parameters and optical limitation in cobalt-doped polyvinylpyrrolidone solutions

Nonlinear optical parameters (nonlinear refractive indices and nonlinear absorption coefficients) of solutions of polyvinylpyrrolidone doped by cobalt to various concentrations are measured at the lasing and second-harmonic wavelengths of a picosecond Nd:YAG laser (λ=1064 and 532 nm, respectively, and τ=35 ps). Data on optical limitation in these solutions are presented. The absence of nonlinear absorption in the IR spectral range and its significant effect in the visible range are demonstrated. Optical limitation at a wavelength of 1064 nm is related to defocusing, whereas at 532 nm, this effect is caused by two-photon absorption and partially by inverse saturated absorption and defocusing. Nonlinear optical parameters of metal-polymer complexes are reported.