Collisional parameters of H2O lines: effects of vibration

A complex semiclassical model for the calculation of line widths and shifts of H₂O broadened by N₂, derived from the Robert and Bonamy approach, is tested by comparisons with measurements for selected transitions in various vibrational bands. The lines retained, which involve rotational states with Kc=J or J−1 have been chosen for two reasons. The first is that they show large variations of the widths with J and thus enable a severe test of the model. The second is that, as explained in this paper, they are well-suited for the study of the effects of vibration on the collisional parameters. The measured values have been extracted from an updated version of a database built years ago (JQSRT 52 (1994) 481) that contains all available measurements. Comparisons between experimental and calculated widths and shifts at room temperature illustrate the quality of the model and clearly demonstrate, for the first time, that there is a vibrational dependence of the broadening. Values of collisional parameters are first studied in fundamental bands. This shows that the theoretical approach accounts for most of the dependence of broadening and shifting on rotational quantum numbers: the variations of γ, which reach a factor of nearly 20 from low to high J values, are correctly accounted for by the model as are some specific features of the shifts δ. Analysis confirms that the bending and stretching vibrations have significantly different effects on δ, due to the vibrational dependence of the intermolecular potential. On the other hand, differences on the widths are rather small with slightly smaller broadening for lines of the bending band. Calculations show that there is a spectroscopic effect, due to the larger rotational constant A in the v₂=1 state. Calculations made for overtone bands involving numerous quanta of the stretching vibration are then presented. They predict that a significant dependence of the width should be observed for high J lines due to the effect of vibration on the interaction potential. This is confirmed by comparisons with measurements for lines involving a change of three and four quanta of stretching vibration.     

Synthesis of optically active 6-substituted 2-(aminomethyl)chromans

Three novel, optically active, 6-substituted 2-(aminomethyl)chromans were synthesized from readily available chroman 2-carboxylic acid precursors. These chroman-containing primary amines are useful building blocks for the synthesis of chroman-derived pharmaceutical agents.     

Negative luminescence from mid-wave infrared HgCdTe diode arrays

A self-referencing, optical modulation technique was used to measure the negative luminescence efficiencies of an array of mid-wave infrared HgCdTe photodiodes with cutoff wavelength 4.6 μm as a function of sample temperature. The internal efficiency at a wavelength of 4 μm was 93% at 295 K, and nearly independent of temperature in the 240–300 K range. This corresponds to an apparent temperature reduction >50 K at room temperature and >30 K at 240 K. Moreover, the reverse-bias saturation current density was only 0.13 A/cm². The measured transmission and emission spectra were simulated using empirical HgCdTe absorption formulas from the literature.     

Atom transfer radical polymerization of methyl methacrylate by copper(I)‐pyridine‐2‐carboximidate catalysts

Pyridine‐2‐carboximidates [methyl ( 1a ), ethyl ( 1b ), isopropyl ( 1c ), cyclopentyl ( 1d ), cyclohexyl ( 1e ), n‐octyl ( 1f ), and benzyl ( 1g )] were prepared from the reaction of 2‐cyanopyridine with the corresponding alcohols. Cyclopentyl‐substituted 1d was found to be a highly effective ligand for copper‐catalyzed atom transfer radical polymerization (ATRP) of methyl methacrylate (MMA). For example, the observed rate constant for a CuBr/ 1d catalytic system was found to be nearly twice as high as the cyclohexyl‐substituted CuBr/ 1e catalytic system [k_obs = (1.19 vs 0.56) × 10^?4 s^?1). The effects of the solvents, temperature, catalyst/initiator, and solvent/monomer ratio on the ATRP of MMA were studied systematically for the CuBr/ 1d catalytic system. The optimum condition for the ATRP of MMA was found to be a 1:2:1:400 [CuBr]_o/[ 1d ]_o/[ethyl 2‐bromoisobutyrate]_o/[MMA]_o ratio at 60 °C in veratrole solution, which yielded well‐defined poly(MMA) with a narrow molecular weight distribution of 1.14. The catalytically active copper complex 2d was isolated from the reaction of CuBr with 1d . Narrow molecular weight distributions as low as 1.06 were achieved for the CuBr/ 1d catalytic system by employing 10% of the deactivator CuBr₂. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 2747–2755, 2004     

Hollow latex particles as submicrometer reactors for polymerization in confined geometries

A method was developed for free‐radical polymerization in the confines of a hollow latex particle. Hollow particles were prepared via the dynamic swelling method from polystyrene seed and divinylbenzene and had hollows of 500–1000 nm. So that these hollow poly(divinylbenzene) particles could function as submicrometer reactors, the particles were filled with a monomer (N‐isopropylacrylamide) via the dispersion of the dried particles in the molten monomer. The monomer that was not contained in the hollows was removed by washing and gentle abrasion. Free‐radical polymerization was then initiated by γ radiolysis in the solid state. Transmission electron microscopy showed that poly(N‐isopropylacrylamide) formed in the hollow interior of the particles, which functioned as submicrometer reactors. © 2004 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 42: 5706–5713, 2004     

Announcement of Proficiency Testing Schemes

Accreditation and Quality Assurance -