Differentiation of species of the Baccharis genus by HPLC and chemometric methods.

Phytochemical investigation of the aerial parts of three Baccharis species (Asteraceae family) was performed using HPLC and chemometric methods, with the objective of distinguishing between three morphologically very similar species: Baccharis genistelloides Persoon var. trimera (Less.) DC, B. milleflora (Less.) DC and B. articulata (Lam.) Persoon. With the help of Principal Component Analysis (PCA) and variance weights, it was possible to characterize the chromatographic profiles of the alcoholic extracts of the three species. Application of Soft Independent Modeling of Class Analogy (SIMCA) and K-Nearest Neighbor (KNN) methods on a training set of 74 extracts resulted in models that correctly classified all eight samples in an independent test set.     

Gas solubility of carbon dioxide in poly(lactic acid) at high pressures: Thermal treatment effect

The sorption of carbon dioxide in glassy Poly(lactic acid) (PLA) films was studied by quartz crystal microbalance (QCM) at high pressures. Two thermal treatments, melted and quenched, were performed in PLA with two different L:D contents, 80:20 and 98:2, films and compared with a third thermal protocol, annealed, and used in a previous work. The results obtained show that for pressures higher than 2 MPa, the carbon dioxide solubility is larger in PLA 80:20 than in PLA 98:2, indicating that the L:D plays a dominant role on this property. The thermal treatments only affect the gas solubility in PLA 98:2. Sorption isotherms at temperatures 303, 313, and 323 K, below the glass transition temperature of the polymer, and pressures up to 5 MPa were measured and analyzed with three different models, the dual‐mode sorption model, the Flory–Huggins equation, and a modified dual‐mode sorption model where the Henry's law term was substituted by the Flory–Huggins equation. This last model performs especially well for CO₂ in PLA 80:20, due to the convex upward curvature of the solubility isotherms for that system. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 616–625, 2007     

Calculation of the dynamic temperature characteristics of a heated graphite tube used in electrothermal atomic absorption measurements

A method and computer program were developed for calculating the temperature of any part of a graphite furnace tube at any instant of time after onset of the heating cycle. Results for tubes of the Massman design show large differences in spatial temperature distributions during and at the end of the heating cycle when equilibrium is reached. When constant current is applied to contoured tubes, greater heating rates at the tube centres are obtained than with standard tubes.     

Determination of lead in wines by hydride generation atomic absorption spectrometry.

The optimization of lead hydride generation in aqueous ethanolic media and the influence on its generation of the wine components, both white and red, have been studied. These interferences were overcome by careful control of the parameters affecting hydride generation and the procedure was applied to the determination of Pb in wines. The method is fast, accurate and sensitive and can be used to quantify 24 ppb of Pb in wines.     

Quantitative separation of zinc traces from cadmium matrices by solid-phase extraction with polyurethane foam

A system for separation of zinc traces from large amounts of cadmium is proposed in this paper. It is based on the solid-phase extraction of the zinc in the form of thiocyanate complexes by the polyurethane foam. The following parameters were studied: effect of pH and of the thiocyanate concentration on the zinc extraction, shaking time required for quantitative extraction, amount of PU foam necessary for complete extraction, conditions for the separation of zinc from cadmium, influence of other cations and anions on the zinc sorption by PU foam, and required conditions for back extraction of zinc from the PU foam. The results show that zinc traces can be separated from large amounts of cadmium at pH 3.0±0.50, with the range of thiocyanate concentration from 0.15 to 0.20 mol l⁻¹, and the shaking time of 5 min. The back extraction of zinc can be done by shaking it with water for 10 min. Calcium, barium, strontium, magnesium, aluminum, nickel and iron(II) are efficiently separated. Iron(III), copper(II) and cobalt(II) are extracted simultaneously with zinc, but the iron reduction with ascorbic acid and the use of citrate to mask copper(II) and cobalt(II) increase the selectivity of the zinc extraction. The anions nitrate, chloride, sulfate, acetate, thiosulphate, tartarate, oxalate, fluoride, citrate, and carbonate do not affect the zinc extraction. Phosphate and EDTA must be absent. The method proposed was applied to determine zinc in cadmium salts using 4-(2-pyridylazo)-resorcinol (PAR) as a spectrophotometric reagent. The result achieved did not show significant difference in the accuracy and precision (95% confidence level) with those obtained by ICP–AES analysis.     

Effect of Bauhinia monandra Kurz Leaf Preparations on Embryonic Stages and Adult Snails of Biomphalaria glabrata (Say, 1818), Schistosoma mansoni Cercariae and Toxicity in Artemia salina

Biomphalaria glabrata snails constitute the main vector of schistosomiasis in Brazil, and Bauhinia monandra Kurz, the leaves of which contain BmoLL lectin with biocidal action, is a plant widely found on continents in which the disease is endemic. This work describes the composition of B. monandra preparations and the effect on embryos and adult snails, their reproduction parameters and hemocytes. We also describe the results of a comet assay after B. glabrata exposure to sublethal concentrations of the preparations. Additionally, the effects of the preparations on S. mansoni cercariae and environmental monitoring with Artemia salina are described. In the chemical evaluation, cinnamic, flavonoid and saponin derivatives were detected in the two preparations assessed, namely the saline extract and the fraction. Both preparations were toxic to embryos in the blastula, gastrula, trochophore, veliger and hippo stages (LC₅₀ of 0.042 and 0.0478; 0.0417 and 0.0419; 0.0897 and 0.1582; 0.3734 and 0.0974; 0.397 and 0.0970 mg/mL, respectively) and to adult snails (LC₅₀ of 6.6 and 0.87 mg/mL, respectively), which were reproductively affected with decreased egg deposition. In blood cell analysis, characteristic cells for apoptosis, micronucleus and binucleation were detected, while for comet analysis, different degrees of nuclear damage were detected. The fraction was able to cause total mortality of the cercariae and did not present environmental toxicity. Therefore, B. monandra preparations are promising in combating schistosomiasis since they can control both the intermediate host and eliminate the infectious agent, besides being safe to the environment.     

Vibrational analysis of d-PCL(530)/siloxane-based hybrid electrolytes doped with two lithium salts

The present study has been focused on environmentally friendly sol–gel-derived electrolytes based on a di-urethane cross-linked d-PCL(530)/siloxane network [where d represents di, PCL identifies the poly(ε-caprolactone) biopolymer, and 530 is the average molecular weight in grams per mole] doped with a wide range of concentration of lithium perchlorate and lithium bis(trifluoromethanesulfonyl)imide. Fourier Transform Infrared and Raman spectroscopies have been applied to evaluate the extent of ionic association. Characteristic bands of the PCL(530) segments, of the urethane cross-links, and of the anions have been examined to gain insight into the cation/biopolymer, cation/anion, and cation/cross-link interactions. In both electrolyte systems, “free” ions and contact ions have been identified. The addition of salt modifies the hydrogen-bonded array of the host matrix, causing the destruction/formation of the urethane/urethane aggregates.     

Characterization of porosity in a 19th century painting ground by synchrotron radiation X-ray tomography

The study of the early oeuvre of the Swiss painter Cuno Amiet (1868–1961) has revealed that, up to 1907, many of his grounds were hand applied and are mainly composed of chalk, bound in protein. These grounds are not only lean and absorbent, but also, as Synchrotron radiation X-ray microtomography has shown, porous. Our approach to the characterization of pore structure and quantity, their connectivity, and homogeneity is based on image segmentation and application of a clustering algorithm to high-resolution X-ray tomographic data. The issues associated with the segmentation of the different components of a ground sample based on X-ray imaging data are discussed. The approach applied to a sample taken from “Portrait of Max Leu” (1899) by Amiet revealed the presence of three sublayers within the ground with distinct porosity features, which had not been observed optically in cross-section. The upper and lower layers are highly porous with important connectivity and thus prone to water uptake/storage. The middle layer however shows low and nonconnected porosity at the resolution level of the X-ray tomography images, so that few direct water absorption paths through the entire sample exist. The potential of the method to characterize porosity and to understand moisture-related issues in paint layer degradation are discussed.     

Critical Evaluation of Analytical Procedures for the Determination of Lead in Seawater

Abstract: This article presents a critical evaluation of the analytical procedures used for the determination of lead in seawater, which is important because lead is a good indicator of marine pollution caused by human activities. Sampling, storage, and pretreatment techniques are briefly overviewed, including the significance of systematic errors that cannot be corrected later on. The main techniques in this article are electrothermal–atomic absorption spectrometry (ET-AAS), inductively coupled plasma–mass spectrometry (ICP-MS), and voltammetry. Flame atomic absorption spectrometry (FAAS) and inductively coupled plasma–optical emission spectrometry (ICP-OES) are treated as well, although their limits of quantification are not sufficient for a determination of lead in unpolluted seawater. Even when separation and preconcentration techniques are applied, these techniques are only capable of detecting lead in polluted coastal seawater. Separation and preconcentration are actually also required for ET-AAS and ICP-MS in order to determine the lowest concentrations of lead found in unpolluted open-ocean seawater, which is still a challenge for the analytical chemist.