On Two Parallel Matched Gratings Demodulation Method of Fiber Grating Strain Sensor

The method of demodulation with two parallel matched fiber Bragg gratings( FBGs)system is introduced to enlarge the range of strain that can be detected by the FBG sensor system.     

The application of spectral distribution of product of two random matrices in the factor analysis

In the factor analysis model with large cross-section and time-series dimensions,we pro- pose a new method to estimate the number of factors.Specially if the idiosyncratic terms satisfy a linear time series model,the estimators of the parameters can be obtained in the time series model. The theoretical properties of the estimators are also explored.A simulation study and an empirical analysis are conducted.     

应变Si1-xGex层中p型杂质电离常温和低温特性

本文采用解析的方法计算了应变Si1-xGex层中p型杂质电离度与Ge组分x、温度T以及掺杂浓度N的关系.发现常温时,在同一Ge组分下,随着掺杂浓度的升高,杂质的电离度的先变小,而后又迅速上升到1.在同一掺杂浓度下,轻掺杂时,杂质的电离度随Ge组分的增加先变大,而后几乎不变;重掺杂时,杂质电离能变为0后,杂质电离度为1.低温下,轻掺杂时,载流子低温冻析效应较为明显,杂质的电离度普遍较小,当掺杂浓度大于Mott转换点时,载流子冻析效应不再明显,电离率迅速上升到1.在同一Ge组分下,随着掺杂浓度的升高,杂质的电离度先变小,后变大,而后又迅速上升到1.在同一掺杂浓度下,轻掺杂时,杂质的电离度随Ge组分的增加变大;重掺杂时,杂质电离能变为0后,杂质电离度为1.     

纳米WO3的制备及其光解水析氧性能研究

用溶胶凝胶法,灼烧法合成了纳米级WO3,采用X-射线衍射、紫外可见漫反射光谱对WO3进行表征.在Fe3 为电子受体、溶液酸度pH为2.0情况下,研究了纳米级WO3在365nm紫外辐射下光解水析氧的光催化活性,并讨论了不同方法制备的催化剂活性差异的原因.结果表明,结晶程度越高、尺寸越小、比表面积越大的纳米级WO3具有更高的光分解水析氧活性,电子受体的浓度、溶液的酸度对析氧活性有明显的影响.     

Investigation on crosslinking behaviors of NBR/PVC filled with anhydrous copper sulfate particles by dynamic mechanical analysis

Crosslinking behaviors of acrylonitrile butadiene rubber (NBR)/poly (vinyl chloride) (PVC) alloy, filled with anhydrous copper sulfate (CuSO₄) particles, were investigated for the first time by dynamic mechanical analysis (DMA) under hetero and isothermal modes, respectively. In the heterothermal testing, (NBR/PVC)/CuSO₄ compound showed two marked increases in the storage modulus (E′), corresponding to coordination crosslinking of NBR-CuSO₄ and self-crosslinking of NBR and PVC respectively. During the isothermal testing, a dramatic increase in E′ was found at the initial stage while that of original NBR/PVC alloy was not detected. The marked increase in E′ of (NBR/PVC)/CuSO₄ compound was mainly due to the crosslinking induced by coordination between  CN and Cu²⁺. The increasing extent of E′ increased with the rise of CuSO₄ content, suggesting the formation of a greater number of crosslinks. Moreover, the activation energy (E_a) of crosslinking process was about 139 kJ/mol. In this work, fourier transform infrared spectrum (FT-IR) and equilibrium swelling method were also performed for the characterization of the compound. © 2006 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 41–51, 2007     

On existence of solutions for some hyperbolic-parabolic-type chemotaxis systems

In this paper, we discuss the local and global existence ofweak solutions for some hyperbolic–parabolic systems modellingchemotaxis.     

Numerical solution of differential equations using Sinc method based on the interpolation of the highest derivatives

In general, we will use the numerical differentiation when dealing with the differential equations. Thus the differential equations can be transformed into algebraic equations and then we can get the numerical solutions. But as we all have known, the numerical differentiation process is very sensitive to even a small level of errors. In contrast it is expected that on average the numerical integration process is much less sensitive to errors. In this paper, based on the Sinc method we provide a new method using Sinc method incorporated with the double exponential transformation based on the interpolation of the highest derivatives (SIHD) for the differential equations. The error in the approximation of the solution is shown to converge at an exponential rate. The numerical results show that compared with the exiting results, our method is of high accuracy, of good convergence with little computational efforts. It is easy to treat nonhomogeneous mixed boundary condition for our method, which is unlike the traditional Sinc method.     

Solvothermal synthesis of TiO2: anatase nanocrystals and rutile nanofibres from TiCl4 in acetone

This work reports a new synthetic approach for single‐phase TiO₂ nanomaterials by solvothermal treatment of titanium tetrachloride in acetone at 80–110 °C. Small, uniform, and yet size‐tunable (5–10 nm) anatase titania nanocrystallites were obtained using a low concentration of TiCl₄ in acetone (i.e., at molar ratios of TiCl₄/acetone ≤ 1:15) in the temperature range of 80–110 °C, while rutile nanofibers were synthesized using a high concentration of TiCl₄ (e.g., TiCl₄/acetone = 1:10) at 110 °C. Copyright © 2007 John Wiley & Sons, Ltd.     

综合网管中基于模型驱动的元数据管理

提出了一种基于模型驱动的元数据管理方案．方案采用了基于模型的形式化描述方法，统一了专业网管子系统间的元数据模式；通过引入模型驱动技术，从元模型的抽象层次消除了不同专业网管子系统之间存在的“信息孤岛”；方案还对综合网管环境下的元数据理论和交换机制进行了研究，并给出了元数据的管理框架以及元数据交换的Java接口映射．