可变色的ZnSe:Er3+ MIS发光二极管

本文首次利用高场和低场激发下的有效发光中心,设计和制备了随外加电压极性改变而变色的ZoSe:Er3+ MIS发光二极管。这种发光二极管在正向电压激发下得到蓝色发光,而在反向电压激发下得到绿色发光。     

基于双芯光纤耦合器的梳状滤波器及其CO2激光调节

基于光纤耦合器的波长特性,分析了光纤耦合器作为梳状滤波器的光谱特性;将长度不同的双芯光纤(twin-core fiber,TCF)熔接在两根单模光纤(single mode fibors,SMF)之间,实验制得具有不同峰值波长间隔的基于双芯光纤耦合器的全光纤型梳状滤波器,其消光比可达25 dB. 首次使用CO₂激光对其进行光谱调节,调节导致光谱向长波方向漂移和消光比的变化. 这种调节是基于CO₂与光纤相互作用时的残余应力释放和熔融变形机理,使用氢载TCF可以在相同实验参数下得到更大的波长调节激光. 关键词： 双芯光纤耦合器 梳状滤波器 2激光')" href="#">CO₂激光 残余应力     

Decoherence of photon-subtracted squeezed vacuum state in dissipative channel

This paper investigates the decoherence of photo-subtracted squeezed vacuum state (PSSVS) in dissipative channel by describing its statistical properties with time evolution such as Wigner function,Husimi function,and tomogram.It first calculates the normalization factor of PSSVS related to Legendre polynomial.After deriving the normally ordered density operator of PSSVS in dissipative channel,one obtains the explicit analytical expressions of time evolution of PSSVS’s statistical distribution function.It finds that these statistical distributions loss their non-Gaussian nature and become Gaussian at last in the dissipative environment as expected.     

高速双边缘光纤光栅波长解调技术

提出一种双边缘结构对光纤光栅传感进行波长解调的方案,利用被测光谱通过不同光谱特性的滤波器时输出不同光强的比值确定被测光的波长.该系统在解调时不存在任何机械移动部分,比扫描式的解调方法测量速度更快,运行时更稳定、更精确.     

周期性梯度折射率多层膜的软X射线反射率

由于界面互扩散的存在,实际的超薄多层膜很难具有清晰的界面结构.假设超薄多层膜为具有周期性梯度折射率的多层膜结构,用直线模型和余弦模型模拟了周期性梯度折射率多层膜的软X射线反射率.结果证明,折射率余弦渐变的多层膜虽然不具有清晰的界面,但它同样具有很高的反射率.     

低泵浦功率的遥泵放大在超长跨距密集波分复用系统中的应用

针对长跨距密集波分复用系统中喇曼放大入纤泵浦功率过大的问题,将遥泵放大器（RP-EDFA）引入到系统中,通过对共纤RP-EDFA的噪音性能及其优化设计的研究,在理论上计算比较了RP-EDFA系统和后向喇曼放大系统在不同泵浦功率水平下的光信噪比和非线性相移,表明遥泵放大技术有效降低了入纤泵浦的功率水平,更适合长跨距应用.运用遥泵放大技术,对一个典型的长跨距系统进行系统Q值的模拟,结果表明：在 220 mW泵浦功率水平下可以实现跨距为 167 km的40×11.6 Gbit/s系统1000 km传输,Q值裕量4.4 dB.     

Synthesis of spherical LiNi1/3Co1/3Mn1/3O2 cathode materials for Li-ion batteries

Spherical LiNi_1/3Co_1/3Mn_1/3O₂ was successfully prepared by controlled crystallization. The preparation started with the spherical coprecipitate of Ni_1/3Co_1/3Mn_1/3CO₃ from NiSO₄, CoSO₄, MnSO₄, NH₄HCO₃, and NH₃·H₂O, followed by pyrolysis of Ni_1/3Co_1/3Mn_1/3CO₃ at 600°C for 3 h. The X-ray diffraction analysis showed that the homogeneous cubic (Ni_1/3Co_1/3Mn_1/3)₃O₄ was obtained after the pyrolysis. Spherical LiNi_1/3Co_1/3Mn_1/3O₂ was obtained by sintering of the mixture of as-obtained (Ni_1/3Co_1/3Mn_1/3)₃O₄ and LiOH·H₂O at 900°C for 6 h in air. As-prepared spherical LiNi_1/3Co_1/3Mn_1/3O₂ presented initial discharge capacity of 162.9 mA h g⁻¹ and capacity retention of 98% at 50th cycle.     

Defect-induced failure of optical coating filters

Optical filters composed of Ag, Al₂O₃, and ZnSe films were prepared on BK7 substrates by evaporation. By employing spectrophotometer, microscope, scanning electron microscope (SEM), and energy dispersive spectrum (EDS) analysis, the moisture-dependent stability of the samples was tested. The experimental results revealed that filter failure often occurs initially at defect sites. Small sputtering particles and pinhole are found to be two types of defects that induced the optical coating filter failure. The mechanisms of the defect-induced failure of the filters also are discussed in the article.     

Theoretical models for the extracavity Raman laser with crystalline Raman medium

The rate equation model of an extracavity Raman laser is deduced for the first time to the best knowledge of the authors. The normalized radiation transfer equations of the extracavity Raman laser are given. The normalized radiation transfer equations and rate equations were solved numerically to find the optimum reflectivity of the output coupler to realize the maximum conversion efficiency at the first Stokes for both the single and double-pass pumping configurations. Also, the pulse duration of the first Stokes was investigated numerically. The rate equations are verified to be a good approximation to the radiation transfer equations for the regime of low Raman gain and long pump pulse duration. Furthermore, it is found that the optimum reflectivity of the first Stokes and the second Stokes threshold are influenced significantly by the minor feedback of the resonator mirror at the second Stokes. PACS 42.55 42.55.Ye; 42.65 42.65.Dr; 02.60 02.60.Lj; 63.20 63.20.-e