Role of superheated water in the dissolution and perturbation of hydrogen bonding in the crystalline lattice of polyamide 4,6

Here, we demonstrate that water, in the superheated state, is a solvent for polyamide 4,6 (PA4,6) and that the water molecules can strongly influence hydrogen bonding. In the presence of superheated water, the melting temperature of PA4,6 can be suppressed by nearly 100 degrees C. The depression in the melting temperature follows the Flory-Huggins principle. The instantaneous dissolution of the polymer hardly influences the molar mass of the polymer. However, if the polymer is retained in solution above the dissolution temperature for more than 10 min, hydrolysis occurs. These findings suggest that the dissolution of the aliphatic polymer in superheated water is mainly a physical process as opposed to a chemical process. Time resolved X-ray studies show that the dissolution occurs prior to the Brill transition temperature, as reported earlier. Crystals grown from the water solution show a lath-like morphology with interchain and intersheet distances that are similar to the distances obtained for crystals grown from other known solvents. Electron diffraction further confirmed that the crystals grown from superheated water are single crystals, where the chains are perpendicular to the ab-plane. SAXS performed on dried sedimented water grown single crystals showed a lamellar thickness of 6 nm. The lamellar thickness is in accordance with other reported studies on PA4,6, confirming that the single crystals incorporate four repeat units between re-entrant folds with an amide group incorporated in the tight fold. Solid state NMR studies performed on mats of these single crystals showed two different mobilities of the proton associated with the amide groups: a higher mobility linked to the amide protons in the fold and a reduced mobility of the hydrogen bonded amide protons within the crystal. Additionally, the solid state NMR studies on the dried water crystallized single crystals show the presence of water molecule(s) in the vicinity of the amide groups. This was confirmed by infrared studies that conclusively demonstrated the appearance of two new bands arising due to the binding of a water molecule in the vicinity of the amide group (i.e., NH3(+) and COO(-) bands that disappear upon heating at approximately 200 degrees C). Additionally, DSC traces of the water crystallized PA4,6 show an exothermic event in the same temperature region (i.e., in the vicinity of the Brill transition temperature, where the bound water exits from the lattice). Furthermore, this event was corroborated by TGA data.     

Linear and nonlinear optical properties of cationic bipyridyl iridium(III) complexes: tunable and photoswitchable?

A series of cationic Ir(III) substituted bipyridyl ()(N(∧)N (N(∧)N-bpy) complexes incorporating electron-donor and -acceptor substituents, [Ir(C(∧)N-ppy-R')(2)(N(∧)N-bpy-CH═CH-C(6)H(4)-R)][X] (X(-) = PF(6)(-) or C(12)H(25)SO(3)(-)), 2 (a, R = NEt(2) and R' = Me; b, R = O-Oct and R' = Me; c, R = NO(2) and R' = C(6)H(13); C(∧)N-ppy = cyclometalated 2-phenylpyridine, [Ir(C(∧)N-ppy-Me)(2)(N(∧)N-bpy-CH═CH-thienyl-Me)][PF(6)], 2d, and the dithienylethene (DTE)-containing complex 2e have been synthesized and characterized, and their absorption, luminescence, and quadratic nonlinear optical (NLO) properties are reported. Density functional theory (DFT) and time-dependent-DFT (TD-DFT) calculations on the complexes facilitate a detailed assignment of the excited states involved in the absorption and emission processes. All five complexes are luminescent in a rigid glass at 77 K, displaying vibronically structured spectra with long lifetimes (14-90 μs), attributed to triplet states localized on the styryl-appended bipyridines. The second-order NLO properties of 2a-d and related complexes 1a-d with 1,10-phenanthrolines have been investigated by both electric field induced second harmonic generation (EFISH) and harmonic light scattering (HLS) techniques. They are characterized by high negative EFISH μβ values which decrease when the ion pair strength between the cation and the counterion (PF(6)(-), C(12)H(25)SO(3)(-)) increases. The EFISH response is mainly controlled by metal-to-ligand charge-transfer/ligand-to-ligand charge-transfer (MLCT/L'LCT) processes. A combination of HLS and EFISH techniques is used to evaluate both the dipolar and octupolar contributions to the total quadratic hyperpolarizability, demonstrating that the major contribution is controlled by the octupolar part. The incorporation of a photochromic DTE unit into the N(∧)N-bpy ligand (complex 2e) allows the luminescence to be switched ON or OFF. The photocyclisation of the DTE unit can be triggered by using either UV (365 nm) or visible light (430 nm), leading to an efficient quenching of the ligand-based 77 K luminescence, which can be restored upon irradiation of the closed form at 715 nm. In contrast, no significant modification of the EFISH μβ value is observed upon photocyclization, suggesting that the quadratic NLO response is dominated by the MLCT/L'LCT processes, rather than by the intraligand excited states localized on the substituted bipyridine ligand.     

Intramolecular Diamination of Alkenes with Palladium(II)/Copper(II) Bromide and IPy2BF4: The Role of Halogenated Intermediates

The oxidative intramolecular diamination of alkenes with tethered ureas and related groups as the nitrogen source has been investigated both with the iodonium reagent IPy₂BF₄ (Py=pyridine) and under palladium catalysis in the presence of copper(II) bromide as a reoxidant. For terminal alkenes, the two procedures enable selective and high‐yielding transformations. Studies with deuterated material led to the conclusion that the reactions proceed through different stereochemical pathways. An advanced protocol for palladium‐catalyzed diamination through six‐membered‐ring annulation was also developed, and the first examples of the intramolecular diamination of internal alkenes are described. In this case, the same stereochemical outcome was observed for the iodonium‐promoted and palladium‐catalyzed transformations. On this basis, it was possible to determine the importance of aminohalogenated intermediates in both diamination reactions. Overall, the disclosed procedures broaden significantly the synthetic applicability of the oxidative intramolecular diamination of alkenes.     

Molecularly imprinted polymer grafted to porous polyethylene frits: a new selective solid-phase extraction format

In this paper, a novel format for selective solid-phase extraction based on a molecularly imprinted polymer (MIP) is described. A small amount of MIP has been synthesized within the pores of commercial polyethylene (PE) frits and attached to its surface using benzophenone (BP), a photo-initiator capable to start the polymerisation from the surface of the support material. Key properties affecting the obtainment of a proper polymeric layer, such as polymerisation time and kind of cross-linker were optimised. The developed imprinted material has been applied as a selective sorbent for cleaning extracts of thiabendazole (TBZ), as model compound, from citrus samples. The use of different solvents for loading the analyte in the imprinted frits was investigated, as well as the binding capacity of the imprinted polymer. Imprinted frits showed good selectivity when loads were performed using toluene and a linear relationship was obtained for the target analyte up to 1000 ng of loaded analyte. Prepared composite material was applied to the SPE of TBZ in real samples extracts, showing an impressive clean-up ability. Calibrations showed good linearity in the concentration range of 0.05-5.00 μg g(-1), referred to the original solid sample, and the regression coefficients obtained were greater than 0.996. The calculated detection limit was 0.016 μg g(-1), low enough to satisfactory analysis of TBZ in real samples. RSDs at different spiking levels ranged below 15% in all the cases and imprinted frits were reusable without loss in their performance.     

Divergent synthetic approach to 6'-modified α-GalCer analogues

A synthetic approach is presented for the synthesis of galacturonic acid and D-fucosyl modified KRN7000. The approach allows for late-stage functionalisation of both the sugar 6'-OH and the sphingosine amino groups, which enables convenient synthesis of promising 6'-modified KRN7000 analogues.     

Reaction of N-vinylic phosphazenes with alpha,beta-unsaturated aldehydes. Azatriene-mediated synthesis of dihydropyridines and pyridines derived from beta-amino acids

Aza-Wittig reaction of N-vinylic phosphazenes (1,2 addition), derived from diphenylmethylphosphine or derived from trimethylphosphine with alpha,beta-unsaturated aldehydes, leads to the formation of 3-azatrienes through a [2 + 2]-cycloaddition-cycloreversion sequence. The presence of an alkyl substituent in position 3 of N-vinylic phosphazenes increases the steric interactions, and [4 + 2] periselectivity (1,4 addition) is observed. Reaction of azatrienes with alpha,beta-unsaturated aldehydes yields pyridines.     

Degradation of ionized OV(OCH3)3 in the gas phase. From the neutral compound all the way down to the quasi-terminal fragments VO+ and VOH+

The consecutive fragmentation of ionized trimethyl vanadate(V), OV(OCH3)3 (1), is examined by experiment and theory. After an elimination of formaldehyde from the molecular ion 1+, subsequent dissociations proceed via losses of first H2 and then two molecules of formaldehyde to finally yield the VOH+ cation; these redox reactions involve the V(II)/V(IV) manifold. At elevated energies, expulsion of CH3O* from 1+ can efficiently compete to afford OV(OCH3)2+, a formal V(V) compound, from which subsequent losses of H2 and two units of CH2O lead to bare VO+, thereby exploring the V(III)/V(V) redox manifold. Experiments using complementary mass spectrometric techniques, i.e., neutralization-reionization experiments and ion/molecule reactions, in conjunction with extensive computational studies provide deep insight into the ion structures and the relative energetics of these dissociation reactions. In particular, a quantitative energetic scheme is obtained that ranges from neutral OV(OCH3)3 all the way down to the quasi-terminal fragment ions VOH+ and VO+, respectively.     

Influence of polymer molecular weight on the chemical modifications induced by UV laser ablation

This paper investigates the influence of polymer molecular weight (M(W)) on the chemical modifications of poly(methyl methacrylate), PMMA, and polystyrene, PS, films doped with iodonaphthalene (NapI) and iodophenanthrene (PhenI), following irradiation at 248 nm (KrF excimer laser, 20 ns fwhm and hybrid excimer-dye laser, 500 fs fwhm) and at 308 nm (XeCl excimer laser, 30 ns fwhm). The changes of intensity and position of the polymer Raman bands upon irradiation provide information on cleavage of the polymer bonds. Degradation of PMMA, which is a weak absorbing system at 248 nm, occurs to a higher extent in the case of a larger M(W), giving rise to the creation of unsaturation centers and to degradation products. For highly absorbing PS, no degradation is observed upon irradiation with a KrF laser. Consistently irradiating doped PS at 308 nm, where the absorption is low, induces degradation of the polymer. Results provide direct support for the bulk photothermal model, according to which ejection requires a critical number of broken bonds. In the case of irradiation of doped PMMA with pulses of 248 nm and 500 fs, neither degradation nor dependence with polymer M(W) are observed, indicating that mechanisms involved in the femtosecond laser ablation differ from those operating in the case of nanosecond laser ablation. Participation of multiphoton/avalanche processes is proposed.