Microwave treatment of biological samples for methylmercury determination by high performance liquid chromatography-cold vapour atomic fluorescence spectrometry

A simple and rapid microwave-assisted alkaline digestion procedure was developed in combination with high performance liquid chromatography-ultraviolet post-column oxidation-cold vapour atomic fluorescence spectrometric detection for methylmercury determination in biological tissues. Since the stability of methylmercury in methanolic potassium hydroxide solution under microwave irradiation was verified, the microwave-assisted extraction procedure was optimized in terms of quantitative recovery of methylmercury and minimum time required. The alkaline extracts were subjected to clean-up steps with dichloromethane and hydrochloric acid in order to reduce matrix interferences in methylmercury determination. The effects of matrix interferences were checked by comparison of the slopes corresponding to calibration and standard addition curves. The accuracy of the method was evaluated by the analysis of two biological certified reference materials, NRC TORT-2 and BCR 463. The results obtained by the proposed method were in good agreement with the certified values of methylmercury concentration in both materials. The detection limit was 10 microg kg(-1) and the relative standard deviation was < 8% for methylmercury concentrations ranging from 0.15 to 3.0 mg kg(-1).     

Spectrophotometric determination of silicate with Rhodamine B by flow-injection analysis

A spectrophotometric flow-injection method for the determination of silicate based on the formation of an ion pair between molybdosilicic acid and Rhodamine B is proposed. It allows silicate to be determined over the concentration range 0.17–2.0 mg 1^?1 at a sampling rate of 40 h^?1, is reasonably precise and is highly tolerant to ions that commonly occur in waters. It has been applied with satisfactory results to the determination of silicate in various types of water.     

Effects of citrate on the composition and enzymic coagulation of colloidal bovine casein aggregates

Colloidal casein aggregates (CCA) prepared from soluble whole bovine caseinates in the presence of Ca²⁺ and phosphate (Pi) ions by addition of different citrate (Cit) concentrations showed different mineral and proteic composition. Citrate concentration conditions the Ca and Pi concentrations incorporated into CCA, probably due to the complexing effect of this anion on calcium. A significant change in the incorporated Ca/Pi ratio at 8 mM citrate could very likely be associated to changes in CCA net charge. The incorporation of individual caseins to the colloidal particles obtained, as well as their average size and size distribution, depended also on the Cit concentration used [Cit]_P. α_S- and β-caseins assembled in the CCA structure sharply decreased at a [Cit]_P higher than 15 mM, i.e., at a low Ca²⁺ concentration in the aggregates, showing that the presence of this cation is necessary for the incorporation of these caseins. An inverse relationship between the aggregation step rate in CCA enzymic coagulation and their average size was observed. The aggregation rate vs the average size curve obtained at [Cit]_P 8 mM clearly differed from the curves obtained at 10 and 12 mM, respectively, a fact probably related to a change in the CCA net charge. This behavior showed the effect of citrate concentration on CCA functional properties.     

Solid-phase extraction system for Pb (II) ions enrichment based on multiwall carbon nanotubes coupled on-line to flame atomic absorption spectrometry

The present paper proposes the application of multiwall carbon nanotubes (MWCNTs) as a solid sorbent for lead preconcentration using a flow system coupled to flame atomic absorption spectrometry. The method comprises the preconcentration of Pb (II) ions at a buffered solution (pH 4.7) onto 30 mg of MWCNTs previously oxidized with concentrated HNO₃. The elution step is carried out with 1.0 mol L⁻¹ HNO₃. The effect of the experimental parameters, including sample pH, sampling flow rate, buffer and eluent concentrations were investigated by means of a 2⁴ full factorial design, while for the final optimization a Doehlert design was employed. Under the best experimental conditions the preconcentration system provided detection and quantification limits of 2.6 and 8.6 μg L⁻¹, respectively. A wide linear range varying from 8.6 up to 775 μg L⁻¹ (r > 0.999) and the respective precision (relative standard deviation) of 7.7 and 1.4% for the 15 and 200 μg L⁻¹ levels were obtained. The characteristics obtained for the performance of the flow preconcentration system were a preconcentration factor of 44.2, preconcentration efficiency of 11 min⁻¹, consumptive index of 0.45 mL and sampling frequency estimated as 14 h⁻¹. Preconcentration studies of Pb (II) ions in the presence of the majority foreign ions tested did not show interference, attesting the good performance of MWCNTs. The accuracy of the method was assessed from analysis of water samples (tap, mineral, physiological serum and synthetic seawater) and common medicinal herbs submitted to the acid decomposition (garlic and Ginkgo Biloba). The satisfactory recovery values obtained without using analyte addition method confirms the feasibility of this method for Pb (II) ions determination in different type of samples.     

Acoustooptic extension of the frequency tunability of CW CO2 lasers: New FIR lasers emissions from CH3OH and13CH3OH

We have increased the frequency tunability of our CW waveguide CO₂ lasers by means of an acoustooptic amplitude modulator, operating at the fixed frequency of 90 MHz. The up-shifted, or down-shifted, laser optical sideband can be generated independently by adjusting the orientation of the modulator. The efficiency is larger than 50%. The frequency tunability of the CO₂ laser around each laser line is thus increased by 180 MHz. To demonstrate the possibilities of this method, a source composed of the above modulator and of a CW, 300 MHz tunable waveguide CO₂ laser has been used for the search of new large offset FIR laser lines from optically pumped CH₃OH and¹³CH₃OH molecules. As a result 15 and 10 new large offset laser lines were discovered respectively. New assignments of some laser lines are also proposed. We have also measured the Stark effect, the offset, and the polarization of other already known lines. In particular a Stark effect frequency tuning of about 1 GHz is demonstrated for a laser line at 208.399 m.     

Existence of generic homoclinic tangencies for henon mappings

It is an open question whether there is a strange attractor for the Henon mapping. We show that for certain maps close to the Henon map there are strange attractors.     

A rapid and convenient synthesis of novel 1-imino-2,3-dihydro-1H-pyrazino[2,1,-b]quinazolin-5-ones

Exploring original approaches for the synthesis of therapeutic agents having a quinazoline part, we discovered that novel 3,4-dihydro-2H-pyrazino[2,1,-b]quinazolines (3) may be rapidly and easily obtained via the chemistry of 4,5-dichloro-1,2,3-dithiazolium chloride (1). Our synthetic approach of this reaction is described with the aim of obtaining a well-controlled access to this very rarely described pyrazino[2,1,-b]quinazoline skeleton.     

Determination of Phenolic Compounds Based on Co‐Immobilization of Methylene Blue and HRP on Multi‐Wall Carbon Nanotubes

This work evaluated an amperometric biosensor based on multi‐wall carbon nanotubes (MWCNT), chemically modified with methylene blue (Met) and horseradish peroxidase (HRP), for detection of phenolic compounds. The dependences of the biosensor response due to the enzyme immobilization procedure, HRP amounts, pH and working potential were investigated. The amperometric response for catechol using the proposed biosensor showed a very wide linear response range (1 to 150 μmol L^?1), good sensitivity (50 nA cm^?2 μmol^?1 L), excellent operational stability (after 300 determinations the response remained at 97%) and very good storage stability (lifetime>3 months). Based on all these characteristics, it is possible to affirm that the material is promising for phenol detection due to its good electrochemical response and enzyme stabilization. The biosensor response for various phenolic compounds was investigated.     

Flow injection turbidimetric determination of thiamine in pharmaceutical formulations using silicotungstic acid as precipitant reagent

A simple flow injection system is proposed for the determination of thiamine in pharmaceutical formulations. The determination is based on the precipitation reaction of thiamine with silicotungstic acid in acidic medium to form a thiamine silicotungstate suspension that is measured at 420 nm. Adding 0.05% (w/v) poly(ethyleneglycol) in the carrier solution (0.5 mol l(-1) hydrochloric acid), an improvement in the sensitivity, repeatability and baseline stability of the flow injection system was obtained. The calibration graph was linear in the thiamine concentration range from 5.0x10(-5) to 3.0x10(-4) mol l(-1) with a detection limit of 1.0x10(-5) mol l(-1). The relative standard deviations for ten successive measurements of 1.0x10(-4) mol l(-1) and 2.5x10(-4) mol l(-1) thiamine were less than 1% and an analytical frequency of 90 h(-1) was obtained.