UPML formulation for truncating conductive media in curvilinear coordinates

This work presents a formulation based on UPML for truncating conductive media by using a local and non-orthogonal coordinate system to solve Maxwell’s equations by the FDTD method. The detailed procedure for obtaining the UPML equations for this case is shown and the complete equation set is provided.     

Mössbauer study of spin-glass Fe x Zn1−x F2 system

⁵⁷Fe Mössbauer effect measurements in the diluted Ising antiferromagnet Fe _x Zn_1?x F₂ withx=0.25 andx=0.57 at temperatures between 4.2 and 55 K, are reported. DC suceptibility measurements show a spin-glass (SG) phase at low temperatures forx≤0.31. Our Mössbauer spectra show a phase transition to a SG state with antiferromagnetic order (AFSG) forx=0.25 and only antiferromagnetic order forx=0.57.     

Gas solubility of carbon dioxide in poly(lactic acid) at high pressures: Thermal treatment effect

The sorption of carbon dioxide in glassy Poly(lactic acid) (PLA) films was studied by quartz crystal microbalance (QCM) at high pressures. Two thermal treatments, melted and quenched, were performed in PLA with two different L:D contents, 80:20 and 98:2, films and compared with a third thermal protocol, annealed, and used in a previous work. The results obtained show that for pressures higher than 2 MPa, the carbon dioxide solubility is larger in PLA 80:20 than in PLA 98:2, indicating that the L:D plays a dominant role on this property. The thermal treatments only affect the gas solubility in PLA 98:2. Sorption isotherms at temperatures 303, 313, and 323 K, below the glass transition temperature of the polymer, and pressures up to 5 MPa were measured and analyzed with three different models, the dual‐mode sorption model, the Flory–Huggins equation, and a modified dual‐mode sorption model where the Henry's law term was substituted by the Flory–Huggins equation. This last model performs especially well for CO₂ in PLA 80:20, due to the convex upward curvature of the solubility isotherms for that system. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 616–625, 2007     

Numerical simulation and experimental validation of heat transfer within rotating flows for three‐dimensional non‐axisymmetric,turbulent conditions

A control volume type numerical methodology for the analysis of steady three‐dimensional rotating flows with heat transfer, in both laminar and turbulent conditions, is implemented and experimentally tested. Non‐axisymmetric momentum and heat transfer phenomena are allowed for. Turbulent transport is alternatively represented through three existing versions of the k–ε model that were adjusted to take into account the turbulence anisotropy promoted by rotation, streamline curvature and thermal buoyancy. Their relative performance is evaluated by comparison of calculated local and global heat balances with those obtained through measurements in a laboratory device. A modified version of the Lam and Bremhorst, low Reynolds number model is seen to give the best results. A preliminary analysis focused on the flow structure and the transfer of heat is reported. Copyright © 2002 John Wiley & Sons, Ltd.     

Electrochemical impedance spectroscopy and linear polarization applied to evaluation of porosity of phosphate conversion coatings on electrogalvanized steels

In this work, electrochemical impedance spectroscopy and linear polarization are used in determining porosity of zinc phosphates, and of nickel and manganese modified zinc phosphates on electrogalvanized steel. The porosity of the phosphate layers ranges from 0.1% for the manganese-modified hopeite to 8% for hopeite, using the linear polarization and the electrochemical impedance spectroscopy techniques. The porosity values measured using the two techniques were in agreement. All impedance spectra of coated samples showed two steps, with two capacitive arcs and an inductive looping.     

Immobilization of catalase on membranes of poly(ethylene)-g-co-acrylic acid and poly(tetrafluoroethylene)-g-co-acrylic acid and their application in hydrogen peroxide electrochemical sensors

The immobilization of catalase on grafted membranes of poly(ethylene)-g-co-acrylic acid and poly(tetrafluoroethylene)-g-co-acrylic acid and their application in hydrogen peroxide electrochemical sensors is described. The introduction of carboxylic acid groups onto a hydrophobic support provides a good environment for subsequent enzyme immobilization. This single membrane, hydrogen peroxide sensor showed significant improvement with respect to the double membrane versions. The response is very rapid, the linear range being from 10 μM up to 6 mM, with a detection limit of 4.7 μM, and a lifetime of more than 4 months.     

Mössbauer study of small amounts of iron in graphite,around the diamond-graphite pressure-temperature stability region

An exploratory Mössbauer spectroscopy study of the Fe-C system in the C rich region, prepared by high pressure-high temperature treatment near the graphite-diamond stability line, was made. The results obtained for the different processing conditions give no evidence of Fe intercalation in graphite. The presence of some water in the cell produced hydrated Fe complexes, which can explain the deleterious effect of water or hydrogen in the high pressure diamond synthesis.     

Crystalline structure of polyamide 12 as revealed by solid‐state 13C NMR and synchrotron WAXS and SAXS

The crystalline structure of polyamide‐12 (PA12) was studied by solid‐state ¹³C nuclear magnetic resonance (NMR) as well as by synchrotron wide‐ and small‐angle X‐ray scattering (WAXS and SAXS). Isotropic and oriented PA12 showed different NMR spectra ascribed to γ‐ and γ′‐crystalline modifications, respectively. On the basis of the position of the first diffraction peak, the isotropic γ‐form and the oriented γ′‐form were shown to be with hexagonal crystalline lattice at room temperature. When heated, the two PA12 polymorphs demonstrated different behaviors. Above 140 °C, the isotropic γ‐PA12 partially transformed into α‐modification. No such transition was observed with the oriented γ′‐PA12 phase even after annealing at temperatures close to melting. A γ′–γ transition was observed here only after isotropization by melting point. Various structural parameters were extracted from the WAXS and SAXS patterns and analyzed as a function of temperature and orientation: the degree of crystallinity, the d‐spacings, the Bragg's long spacings, the average thicknesses of the crystalline (l_c) and amorphous (l_a) phases, and the linear crystallinity x_cl within the lamellar stacks. © 2005 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 43: 3720–3733, 2005     

Asymptotic Properties of Random Multidimensional Assignment Problems

The multidimensional assignment problem (MAP) is a NP-hard combinatorial optimization problem, occurring in many applications, such as data association. In this paper, we prove two conjectures made in Ref. 1 and based on data from computational experiments on MAPs. We show that the mean optimal objective function cost of random instances of the MAP goes to zero as the problem size increases, when assignment costs are independent exponentially or uniformly distributed random variables. We prove also that the mean optimal solution goes to negative infinity when assignment costs are independent normally distributed random variables.