Laser stabilitron

We consider a new method for producing intensity stabilization of cw lasers. This method incorporates negative feedback from a nonlinear saturable absorber to provide wideband noise-reduction and may produce an output beam for which shot noise is below the quantum limit. This new method can be used with a large variety of cw lasers and is particularly applicable to frequency-stabilized lasers which are locked to absorption lines.Permanent address: Institute of Laser Physics, Novosibirsk 630090, Russia     

Inhibition of the reduction of Cr(VI) at the magnetite–water interface by calcium carbonate coatings

The effect of calcium carbonate coatings on the reduction of aqueous chromate on the magnetite(1 1 1) surface has been investigated using a combination of synchrotron based X-ray photoemission spectroscopy (PES) and X-ray absorption near edge structure (XANES) spectroscopy, along with laboratory-based powder X-ray diffraction (XRD) and scanning electron microscopy (SEM). CaCO₃ coatings (dominantly calcite with minor quantities of aragonite and vaterite) of thicknesses ranging from 10 Å to 20 m were grown on magnetite(1 1 1) surfaces by exposure to supersaturated aqueous solutions followed by evaporation of the solution—a process that mimics pore-water evaporation in vadose zones leading to the formation of caliche and calcium carbonate coatings on mineral grains. Coating thicknesses were determined from attenuation of the Fe 2p photoemission signal by the carbonate coating. For coatings less than 15 Å thick, Cr 2p photoemission and Cr L_II, L_III-edge XANES spectra show that chromate is reduced by the underlying magnetite surface; however, as the minimum coating thickness increases beyond 15 Å, the magnetite surface becomes passivated and further chromate reduction ceases. Our findings suggest that carbonate coatings on natural magnetite grains can significantly reduce or eliminate their ability to reduce Cr(VI), which is a toxic and highly mobile environmental contaminant.     

Detection of hepatocarcinoma in rats by integration of the fluorescence spectrum: Experimental model

The incorporation of spectroscopic techniques into diagnostic procedures may greatly improve the chances for precise diagnostics. One promising technique is fluorescence spectroscopy, which has recently been used to detect many different types of diseases. In this work, we use laser-induced tissue fluorescence to detect hepatocarcinoma in rats using excitation light at wavelengths of 443 and 532 nm. Hepatocarcinoma was induced chemically in Wistar rats. The collected fluorescence spectrum ranges from the excitation wavelength up to 850 nm. A mathematical procedure carried out on the spectrum determines a figure of merit value, which allows the detection of hepatocarcinoma. The figure of merit involves a procedure which evaluates the ratio between the backscattered excitation wavelength and the broad emission fluorescence band. We demonstrate that a normalization allowed by integration of the fluorescence spectra is a simple operation that may allow the detection of hepatocarcinoma.     

Properties of (InGa)As/GaAs QW (λ ≈ 1.2 µm) facet-coated edge emitting diode laser

In this paper, we report on the design and optical properties of laser diodes with an emission wave-length of ～1170 nm based on an (InGa)As/GaAs double quantum well active layer. The back and front facet of the laser diodes were coated with SiO_x dielectric films that influence the output optical power by enhancing or lowering the facet reflectivity. The measurements show improvement of the facet-coated laser diode properties in the threshold-current-density reduction along with light output power enhancement. Furthermore, a narrow far field pattern and high side mode suppression have been observed.     

The first bismuth(III)-catalyzed guanylation of thioureas

This work describes the first catalytic bismuth-promoted synthesis of polysubstituted guanidines in good yields through the guanylation reaction of N-benzoyl or N-phenylthioureas with primary and secondary amines, but now employing equimolar amounts of each organic reagent. Both bismuth iodine and bismuth nitrate were efficient as inorganic thiophiles at only 5 mol % in relation to substrates, being the first example of inorganic thiophiles acting in guanylation at catalytic levels.     

The chemisorption of pentacene on Si(0 0 1)-2 × 1

Adsorption structures of the pentacene (C₂₂H₁₄) molecule on the clean Si(0 0 1)-2 × 1 surface were investigated by scanning tunneling microscopy (STM) in conjunction with density functional theory calculations and STM image simulations. The pentacene molecules were found to adsorb on four major sites and four minor sites. The adsorption structures of the pentacene molecules at the four major sites were determined by comparison between the experimental and the simulated STM images. Three out of the four theoretically identified adsorption structures are different from the previously proposed adsorption structures. They involve six to eight Si-C covalent chemical bonds. The adsorption energies of the major four structures are calculated to be in the range 67-128 kcal/mol. It was also found that the pentacene molecule hardly hopped on the surface when applying pulse bias voltages on the molecule, but was mostly decomposed.     

The measurement of beta asymmetries at UNISOR/NOF using external plastic scintillator detectors

The performance of two external plastic scintillator detectors has been tested in an off-line mode using a source of¹⁰⁶RuFe at UNISOR/NOF. The measurement of beta asymmetries at various temperatures has resulted in the reproduction of the previously-determined magnetic dipole moment for the 1⁺ ground state of¹⁰⁶Rh and in addition the conclusion that the sign of this moment is positive.     

Inertia-preserving secant updates

Corrections to the last two equations of Ref. 1 are given.     

Anharmonic effects in large-amplitude vibrations of metal clusters

Two types of extreme collective motion, large-amplitude many-phonon vibration of the ionic core and rotation of the cluster with high angular momenta, are considered. The interplay between vibration and collective motion towards fission is discussed. A new mechanism of formation and rupture of the neck is proposed which is based on the Franck-Condon principle, and accounts for the interplay between vibration and fission. Under rotation, the change of the shape of the cluster and a phase transition from axially symmetric to triaxial ellipsoid are predicted. For studying the effects, vibrational motion can be induced by laser radiation. Rotational motion may arise in collisions of clusters. Received 26 April 2001 and Received in final form 15 October 2001