The Influence of Variable Convective Velocities on Longitudinal Diffusion

Solutions are presented for the impulsively started uniformstream and simple shear flows past a point source of momentum,which can be interpreted to describe the position and the widthof the front which transmits the knowledge of the singularitythrough a slightly viscous fluid. These understandings are thengeneralized to show that the front always moves with velocityslower than that of a (strictly monotonic) convective velocity,and also that its width always grows faster than with simplediffusion. Finally, a remarkably simple, exact expression is given forvorticity due to a simple shear flow past a point vortex.     

Letters to the Editor

The Mathematical Intelligencer encourages comments about the material in this issue. Letters to the editor should be sent to either of the editors-in-chief, Chandler Davis or Marjorie Senechal.     

Nonlinear optical properties of regioregular main‐chain polyesters

We have prepared new polyesters containing quadratic, nonlinear optical (NLO) active chromophores covalently incorporated into the main chain. In these polymers, the sequence of the chromophore units along the main chain is rigorously head to tail. All the polyesters are processable, both in the melt and in solution. For one polyester, a full second‐order NLO characterization has been performed. An out‐of‐resonance d₃₃ coefficient of 21 pm/V at 1368 nm has been measured. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 2719–2725, 2007     

Degradative chain transfer in vinyl acetate polymerizations using toluene as solvent

In this work, we propose that retardation in vinyl acetate polymerization rate in the presence of toluene is due to degradative chain transfer. The transfer constant to toluene (C_trs) determined using the Mayo method is equal to 3.8 × 10^?3, which is remarkably similar to the value calculated from the rate data, assuming degradative chain transfer (2.7 × 10^?3). Simulations, including chain‐length‐dependent termination, were carried out to compare our degradative chain transfer model with experimental results. The conversion–time profiles showed excellent agreement between experiment and simulation. Good agreement was found for the M_n data as a function of conversion. The experimental and simulation data strongly support the postulate that degradative chain transfer is the dominant kinetic mechanism. © 2007 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 45: 3620–3625, 2007     

Influence of organic modifiers on morphology and crystallization of poly(ϵ‐caprolactone)/synthetic clay intercalated nanocomposites

ε‐caprolactone was polymerized in the presence of neat montmorillonite or organomontmorillonites to obtain a variety of poly(ε‐caprolactone) (PCL)‐based systems loaded with 10 wt % of the silicates. The materials were thoroughly investigated by different X‐ray scattering techniques to determine factors affecting structure of the systems. For one of the nanocomposites it was found that varying the temperature in the range corresponding to crystallization of PCL causes reversible changes in the interlayer distance of the organoclay. Extensive experimental and literature studies on this phenomenon provided clues indicating that this effect might be a result of two‐dimensional ordering of PCL chains inside the galleries of the silicate. Small angle X‐ray scattering and wide angle X‐ray scattering investigation of filaments oriented above melting point of PCL revealed that polymer lamellae were oriented perpendicularly to particles of unmodified silicate, while in PCL/organoclay systems they were found parallel to clay tactoids. Calorimetric and microscopic studies shown that clay particles are effective nucleating agents. In the nanocomposites, PCL crystallized 20‐fold faster than in the neat polymer. The crystallization rate in nanocomposites was also significantly higher than in microcomposite. Further research provided an insight how the presence of the filler affects crystalline fraction and spherulitic structure of the polymer matrix in the investigated systems. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 2350–2367, 2007     

Structure of norbornene-fused 3,1-oxazine double cycloadducts

Pentacyclic isoxazolines were obtained by the cycloaddition of benzonitrile oxide to norbornene-azetidinone-fused 3,1-oxazines. The constitutions of two of the isomers obtained, and the configurations and conformations of all products, were determined by means of ¹H and ¹³C NMR spectroscopy and DNOE experiments.     

Galactic model of element formation

A cosmological model is presented that produces He, C, O, D, Li, Be, and B in their observed abundances without a Big Bang. The elements are produced during the 1.5-Gy formation period of a galaxy, with C, O, and other heavy elements produced by stars of M>12 M₃ , He by stars of 6 M_s<M<12 M_s, and D, Li, Be, and B by cosmic-ray reactions in a nearly pure H plasma halo. Thus, the model shows that the major elements used in astrophysical studies can be produced during galactic formation by exactly the same processes known to function today at much lower rates     

The effect of geoacoustic characteristics of the bottom on the long-range sound propagation in an inhomogeneous ocean

The long-range sound propagation from a deep ocean to a receiving system located on the shelf is modeled. The waveguide model is constructed on the basis of the data of an acoustic-oceanographic experiment carried out in the northwestern Pacific. The sensitivity and the frequency dependence of the difference in the sound field levels at the crossing of the frontal zone on the geoacoustic characteristics of the bottom of the shelf and the continental slope are investigated. It is shown that the level difference decreases by 8.2 dB as the velocity of longitudinal waves increases by 100 m/s in the range within 1490–1820 m/s.