Ln(Ⅲ)与2-羟基-1-萘醛缩蛋氨酸盐及邻菲咯啉三元配合物的合成与表征

合成了稀土硝酸盐与希夫碱盐2-羟基-1-萘醛缩蛋氨酸钾(以KL表示)及邻菲咯啉(Phen)的四种固体三元配合物。通过元素分析，IR，UV，DTA-TG及摩尔电导分析等手段确定配合物的组成为[Ln(L)(Phen)(NO3)(H2O)]NO3(Ln＝Gd，Dy，Er，Yb)，并对它们的配合方式及某些物理和化学性质进行了研究。     

Long‐range π‐type hydrogen bond in dimers CH2?HF,CH2O?H2O,and CH2O?NH3

Using four basis bets, (6‐311G(d,p), 6‐31+G(d,p), 6‐31++G(2d,2p), and 6‐311++G(3df,3pd), the optimized structures with all real frequencies were obtained at the MP2 level for the dimers CH₂O? HF, CH₂O? H₂O, CH₂O? NH₃, and CH₂O? CH₄. The structures of CH₂O? HF, CH₂O? H₂O, and CH₂O? NH₃ are cycle‐shaped, which result from the larger bend of σ‐type hydrogen bonds. The bend of σ‐type H‐bond O…H? Y (Y?F, O, N) is illustrated and interpreted by an attractive interaction of a chemically intuitive π‐type hydrogen bond. The π‐type hydrogen bond is the interaction between one of the H atoms of CH₂O and lone pair(s) on the F atom in HF, the O atom in H₂O, or the N atom in NH₃. In contrast with the above three dimers, for CH₂O? CH₄, because there is not a π‐type hydrogen bond to bend its linear hydrogen bond, the structure of CH₂O? CH₄ is noncyclic shaped. The interaction energy of hydrogen bonds and the π‐type H‐bond are calculated and discussed at the CCSD (T)/6‐311++G(3df,3pd) level. © 2005 Wiley Periodicals, Inc. Int J Quantum Chem, 2005     

溶剂热法制备Ag/TiO2纳米材料及其光催化性能

以乙醇为溶剂, 钛酸四丁酯为前驱体, 用溶剂热法制备了Ag表面修饰的负载型纳米二氧化钛光催化剂. 利用X射线衍射(XRD)、N₂吸附-脱附(BET)、透射电子显微镜(TEM)、X射线光电子能谱(XPS)、紫外-可见(UV-Vis)光谱等技术对其进行了系统的表征, 以亚甲基蓝(MB)溶液的脱色降解为模型反应, 考察了不同Ag含量样品的光催化性能. 结果表明: 用溶剂热法制备的样品中TiO₂皆为锐钛矿相, 金属Ag颗粒沉积在TiO₂表面, 粒径为2 nm左右, 比表面积较溶胶凝胶法制备的样品大大增加, 最高可达151.44 m²·g^-1; UV-Vis光谱和光催化实验表明: Ag修饰使TiO₂对光的吸收能力大大增强, 吸收带边红移至可见光区, 亚甲基蓝在该复合材料上的光催化降解反应遵循一级反应动力学模型; 溶剂热法制备样品的光催化性能明显好于溶胶凝胶法制备的样品, 在紫外光和可见光下, Ag摩尔分数为5%的样品表现出最佳的光催化活性.     

MCM-41分子筛负载钼钴系催化剂的噻吩HDS研究

通过氧吸附量、噻吩吸附热及反应速率常数的测定，研究了MoO3/MCM-41、MoO3-CoO(NiO)/MCM-41系列催化剂，发现，对于MoO3/MCM-41催化剂，当MoO3的质量分数（以MCM－41为底数，即MCM－41＝1g时，MoO3含量为0．15g，下同）从15％增加到20％时，其噻吩的加氢硫（HDS）活性增大，至25％时活性下降，所对应的氧吸附量（mL/g催化剂）也是先增大后减少，并且两者有很好的线性对应关系，而且噻吩吸附热则基本保持不变，采用不同的MoO3-CoO(NiO)浸渍顺序制备的MoO3-CoO(NiO)/MCM-41催化剂中，先浸渍CoO(NiO）再浸渍MoO3的催化剂，其噻吩HDS活性明显优于对其它浸渍顺序制备的催化剂，同时催化剂的氧吸附量和噻吩吸附热也最大。     

HCl-NaCl-C3H8O3-H2O体系溶液热力学性质

在恒定丙三醇质量分数x=0．1的条件下，测定了无液接电池（A）和电池（B）的电动势根据电池（A）电动势确定了丙三醇和水混合溶剂中的Ag－AgCl电极的标准电极电势，讨论了HCl的迁移性质；由电池（B）测得的电动势计算了HCl在该体系中的活度系数γA，计算的结果表明，对于所讨论的体系，在溶液中总离子强度保持恒定，HCl的活度系数服从Harned规则．在溶液组成恒定时，IgγA是温度倒数1／T的线性函数，讨论了混合物中HCl的相对偏摩尔焓及介质效应．     

Determination of Tiopronin in Human Plasma by SPE then Reversed-Phase HPLC–UV

An accurate, simple and sensitive method based on reversed-phase high-performance liquid chromatography with UV detection has been developed for determination of tiopronin (TP) in human plasma. TP in plasma was reacted with p-bromophenacyl bromide (p-BPB) to give the TP-p-BPB adduct and this derivative was then extracted from the plasma on a silica gel cartridge. Potential interfering compounds were removed by washing with water, and the TP-p-BPB adduct was then eluted with acetonitrile. The organic phase obtained was evaporated to complete dryness under a stream of nitrogen. The residue was dissolved in acetonitrile and this solution was injected on to a reversed-phase ODS HPLC column. The mobile phase was usually the ternary mixture acetonitrile–water–trifluoroacetic acid, 40:59.88:0.12 (v/v). The retention times of TP-p-BPB and the internal standard adduct were 14.4 and 17.9 min, respectively. No interfering peaks were encountered in several blank plasma samples examined. The limit of detection for TP was 12 ng mL^?1. Extraction recovery exceeded 70%. The calibration plot for the TP derivative was linear in the range 40?4000 ng mL^?1, regression coefficient 0.9989, and the coefficient of the variation of the points of the calibration plot was below 10%. The method was validated appropriately and successfully applied to the determination of TP in human plasma.     

Amperometric glucose biosensor based on electrodeposition of platinum nanoparticles onto covalently immobilized carbon nanotube electrode

A new amperometric biosensor for glucose was developed based on adsorption of glucose oxidase (GOx) at the gold and platinum nanoparticles-modified carbon nanotube (CNT) electrode. CNTs were covalently immobilized on gold electrode via carbodiimide chemistry by forming amide linkages between carboxylic acid groups on the CNTs and amine residues of cysteamine self-assembled monolayer (SAM). The fabricated GOx/Au_nano/Pt_nano/CNT electrode was covered with a thin layer of Nafion to avoid the loss of GOx in determination and to improve the anti-interferent ability. The immobilization of CNTs on the gold electrode was characterized by quartz crystal microbalance technique. The morphologies of the CNT/gold and Pt_nano/CNT/gold electrodes have been investigated by scanning electron microscopy (SEM), and the electrochemical performance of the gold, CNT/gold, Pt_nano/gold and Pt_nano/CNT/gold electrodes has also been studied by amperometric method. In addition, effects of electrodeposition time of Pt nanoparticles, pH value, applied potential and electroactive interferents on the amperometric response of the sensor were discussed.

The enzyme electrode exhibited excellent electrocatalytic activity and rapid response for glucose in the absence of a mediator. The linear range was from 0.5 to 17.5 mM with correction coefficient of 0.996. The biosensor had good reproducibility and stability for the determination of glucose.     

Spectroscopy and Structure of Sol-Gel Systems

Sol-gel derived glasses may differ from conventional melt-quenched glasses owing to the peculiar microstructures existing at the gel state, such that, even after gel densification, some differences may remain in their composition and molecular structure.This paper discusses structural characteristics of thin film oxide gels and glasses, with a special emphasis on SiO2-TiO2 based systems, which are of particular interest for sol-gel integrated optics applications. Short range structure aspects are discussed based on infrared, X-ray photoemission and X-ray photoabsorption spectroscopies. The chemical homogeneity of sol-gel materials is evaluated, based on X-ray photoemission and nuclear magnetic resonance spectroscopies, dealing in particular with the issue of homo- vs. heterocondensation. Finally, some microstructural features of sol-gel derived films are analyzed, namely the relationship between infrared absorption and porosity and the structure of nanocrystalline sol-gel films, based on grazing incidence X-ray diffraction and micro-Raman spectroscopy. The types of structural information obtainable by each different technique are compared in detail.     

微波辐射-酶耦合催化(MIECC)反应

将微波辐射用于非水相酶催化可以获得很多有别于常规加热下的反应结果.本文讨论了微波的非热效应在酶促反应中的表现,探讨了微波辐射对酶的结构、构象、活性及酶催化反应动力学的影响,以及微波辐射-酶耦合催化对反应的对映选择性、底物专一性、前手性选择性和区域选择性的影响.在大多数场合,适当的微波辐射不会损伤酶活而且可以提高反应速率,而对酶特异性的影响则不一而论.     

Effects of Calcination Temperature on the Acidity and Catalytic Performances of HZSM-5 Zeolite Catalysts for the Catalytic Cracking of n-Butane

The acidic modulations of a series of HZSM-5 catalysts were successfully made by calcination at different treatment temperatures, i.e. 500, 600, 650, 700 and 800 ℃, respectively. The results indicated that the total acid amounts, their density and the amount of B-type acid of HZSM-5 catalysts rapidly decreased, while the amounts of L-type acid had almost no change and thus the ratio of L/B was obviously enhanced with the increase of calcination temperature (excluding 800 ℃). The catalytic performances of modified HZSM-5 catalysts for the cracking of n-butane were also investigated. The main properties of these catalysts were characterized by means of XRD, N2 adsorption at low temperature, NH3-TPD, FTIR of pyridine adsorption and BET surface area measurements. The results showed that HZSM-5 zeolite pretreated at 800 ℃ had very low catalytic activity for n-butane cracking. In the calcination temperature range of 500-700 ℃, the total selectivity to olefins, propylene and butene were increased with the increase of calcination temperature, while, the selectivity for arene decreased with the calcination temperature.The HZSM-5 zeolite calcined at 700 ℃ produced light olefins with high yield, at the reaction temperature of 650 ℃ the yields of total olefins and ethylene were 52.8% and 29.4%, respectively. Besides, the more important role is that high calcination temperature treatment improved the duration stability of HZSM-5zeolites. The effect of calcination temperature on the physico-chemical properties and catalytic performance of HZSM-5 for cracking of n-butane was explored. It was found that the calcination temperature had large effects on the surface area, crystallinity and acid properties of HZSM-5 catalyst, which further affected the catalytic performance for n-butane cracking.