Influence of operating conditions and vessel size on oxygen transfer during cellulase production

The production of low-cost cellulase enzyme is a key step in the development of an enzymatic-based process for conversion of lignocellulosic biomass to ethanol. Although abundant information is available on cellulase production, little of this work has examined oxygen transfer. We investigated oxygen transfer during the growth of Trichoderma reesei, a cellulase-producing microorganism, on soluble and insoluble substrates in vessel sizes from 7 to 9000 L. Oxygen uptake rates and volumetric mass transfer coefficients (k _La) were determined using mass spectroscopy to measure off gas composition. Experimentally measured k _La values were found to compare favorably with a k _La correlation available in the literature for a non-Newtonian fermentation broth during the period of heavy cell growth.     

Crystallization of Random Trigonometric Polynomials

We give a precise measure of the rate at which repeated differentiation of a random trigonometric polynomial causes the roots of the function to approach equal spacing. This can be viewed as a toy model of crystallization in one dimension. In particular we determine the asymptotics of the distribution of the roots around the crystalline configuration and find that the distribution is not Gaussian.     

(Thiocarbonyl‐α‐thio)carboxylic acid derivatives as transfer agents in reversible addition–fragmentation chain‐transfer polymerizations

Ethyl S‐(thiobenzoyl)thioacetate, ethyl S‐thiobenzoyl‐2‐thiopropionate, and S‐(thiobenzoyl)thioglycolic acid were used as chain‐transfer agents for the reversible addition–fragmentation chain‐transfer (RAFT) polymerizations of styrene, methyl methacrylate, and butyl acrylate. Of these polymerizations, only those of styrene and butyl acrylate with any of the transfer agents showed molecular weight control corresponding to controlled/living polymerizations. The best molecular weight control was observed for the polymerizations of styrene and butyl acrylate with ethyl (S)‐thiobenzoyl‐2‐thiopropionate. Semiempirical PM3 calculations were performed for the investigation of the relative heats of reaction of the chain‐transfer equilibria between the aforementioned chain‐transfer agents and dimer radicals of the three monomers. The molecular weight control of the polymerizations correlated with the stability trend of the leaving‐group radical of the chain‐transfer agent. This relatively simple computational model offered some value in determining which transfer agents would show the best molecular weight control in RAFT polymerizations. © 2002 John Wiley & Sons, Inc. J Polym Sci Part A: Polym Chem 40: 555–563, 2002; DOI 10.1002/pola.10143     

The Determination of Arsenic in Soil and Sediment Digests by Graphite Furnace Atomic Absorption Spectrometry

Abstract

A method for the determination of As in siliceous materials from a fluoboric acid matrix by GFAAS is described. The basic analytical procedure also permits the measurement of major, minor and other trace elements by flame or graphite furnace AAS as appropriate. For As analysis, the incorporation of matrix modification with Ni and of corrective measures to overcome interference by Al, Na and Si are discussed. The validity of the method is demonstrated by the accurate analysis of four international standard reference materials and agreement with instrumental neutron activation analysis results for As in environmental samples. One application to the study of As geochemistry in lacustrine sediments is presented.     

Dilute-sulfuric acid pretreatment of corn stover in pilot-scale reactor

Corn stover is a domestic feedstock that has potential to produce significant quantities of fuel ethanol and other bioenergy and biobased products. However, comprehensive yield and carbon mass balance information and validated kinetic models for dilute-sulfuric acid (H₂SO₄) pretreatment of corn stover have not been available. This has hindered the estimation of process economics and also limited the ability to perform technoeconomic modeling to guide research. To better characterize pretreatment and assess its kinetics, we pretreated corn stover in a continuous 1 t/d reactor. Corn stover was pretreated at 20% (w/w) solids concentration over a range of conditions encompassing residence times of 3–12 min, temperatures of 165–195°C, and H₂SO₄ concentrations of 0.5–1.4% (w/w). Xylan conversion yield and carbon mass balance data were collected at each run condition. Performance results were used to estimate kinetic model parameters assuming biphasic hemicellulose hydrolysis and a hydrolysis mechanism incorporating formation of intermediate xylo-oligomers. In addition, some of the pretreated solids were tested in a simultaneous saccharification and fermentation (SSF) process to measure the reactivity of their cellulose component to enzymatic digestion by cellulase enzymes. Monomeric xylose yields of 69–71% and total xylose yields (monomers and oligomers) of 70–77% were achieved with performance level depending on pretreatment severity. Cellulose conversion yields in SSF of 80–87% were obtained for some of the most digestible pretreated solids.     

Dynamics of alkyl ammonium intercalants within organically modified montmorillonite: Dielectric relaxation and ionic conductivity

The low-frequency (0.01 Hz-10 MHz) dynamic characteristics of alkyl quaternary ammonium exchanged montmorillonite (SC20A) were investigated to determine the correlation between temperature-dependent changes in the interlayer structure and collective mobility of the surfactant. From 25 to 165 degrees C, SC20A exhibits two interlayer transitions, one ascribed to the melting of the intercalated alkyl chains of the surfactant (20-40 degrees C) and another associated with an abrupt decrease in the interlayer's coefficient of thermal expansion (100 degrees C). For this temperature range, the excess surfactant and residual electrolytes present in commercially manufactured SC20A enhance the direct current conductivity and increase low-frequency space-charge polarization, which is believed to occur across percolation paths established by the surfaces of the SC20A crystallites. In contrast, a higher-frequency relaxation, which was less sensitive to process history and impurity content, is ascribed to relaxation within the interlayer at the surfactant-aluminosilicate interface electrostatic couple. The temperature dependence of these dielectric relaxations indicated a drastic increase in mobility as the interlayer organic phase transitions from static and glasslike into molten and mobile. Overall, SC20A displayed features of alternating current universality, including time-temperature superposition, common in other types of disordered ion-conducting media. The presence of long-range transport and its sensitivity to low amounts of impurities imply that from a dynamic perspective the local environment of the surfactants are substantially diverse and a minority fraction, such as at the edge of the crystallite (gallery and aluminosilicate layer), may dominate the lower-frequency dielectric response.