Synthesis of pyrimido[4,5-e][1,4]oxazepin-5-ones

Eighteen novel pyrimido[4,5-e][1,4]oxazepin-5-ones were prepared directly via the reaction of either ethyl 4-chloro-2-phenyl-5-pyrimidinecarboxylate (Ia) or ethyl 4-chloro-2-m-chlorophenyl-5-pyrimidinecarboxylate (Ib) with a variety of substituted 2-(alkylamino)ethanols. A typical example was the preparation of 8,9-dihydro-9-methyl-2-phenylpyrimido[4,5-e][1,4]-oxazepin-5(7H)-one (IIa) from the reaction of Ia with 2-(methylamino)ethanol. Hydrolytic cleavage of the lactone ring in IIa with sodium hydroxide solution, followed by acidification with hydrochloric acid afforded 4-[(2-hydroxyethyl)methylamino]-2-phenyl-5-pyrimidinecarboxylic acid (IV). Reactions of IIa with concentrated ammonium hydroxide or hydrazine also caused cleavage of the lactone ring, giving the corresponding amide (V) or hydrazide (VI), respectively. Structural assignments were supported by infrared and nuclear magnetic resonance spectra.     

Synthesis of 5,6,8,9,14,14a-hexahydroisoquino[1,2-b][3]benzazepines

Syntheses of 5,6,8,9,14,14a-hexahydroisoquino[1,2-b][3]benzazepine-2,3,11,12-tetrol and related compounds are described. Key steps involve an initial construction of the isoquinoline ring under the Bischler-Napieralski conditions, which is followed by the building of the azepine ring via an intramolecular lactam formation on to the isoquinoline nucleus.     

Synthesis of 1,2,3,4,8,9,10,11-octahydro-[1,4] diazepino[6,5,4-jk ]earbazole and related compounds

1,2,3,4,8,9,10,11-Octahydro[1,4]diazepino[6,5,4-jk]earbazole (VIa) was synthesized from 2,3,4,5-tetrahydro-1H-benzodiazepine (la) via the route shown in Scheme 1. Other compounds which were prepared similarly are 3-acetyl-6-chloro-1,2,3,4,8,9,10,11-octahydro[1,4]diazepino-[6,5,4-jk]carbazole(Vb) and 3-methyl-1,2,3,4,8,9,10,11-octahydro[1,4]diazepino[6,5,4-jk]carb-azole (VIII). Chemical transformations which were carried out with VI and 3-acetyl-1,2,3,4,8,9, 10,11-octahydro[1,4]diazepino[6,5,4-jk]carbazole (Va) are also described.     

One-step preparation of highly concentrated well-stable gold colloids by direct mix of polyelectrolyte and HAuCl4 aqueous solutions at room temperature

Highly concentrated, well-stable gold colloids can be prepared directly from an amine-bearing polyelectrolyte-HAuCl4 aqueous solution at room temperature. It is found that increasing molar ratio of polyelectrolyte to gold leads to increasing particle size. UV-vis spectra, transmission electron microscopy (TEM), and X-ray photoelectron spectra (XPS) were used to characterize the products thus formed.     

拟薄水铝石/陶瓷胶态加工浆料的流变性能

用拟薄水铝石纳米胶粒分散微米二硼化钛形成固含量为60Wt%的稳定陶瓷浆料,实验考察了拟薄水铝石固含量、二硼化钛固含量、温度对浆料流变性、稳定性的影响,对纳米γ-AlOOH胶粒分散微米TiB2的机制进行了讨论.大小约20nm的γ-AlOOH颗粒相互网联,成为外加微米陶瓷颗粒的骨架.浆料粘度随二硼化钛固含量的增加而增大,温度升高有利于胶体中薄水铝胶团与二硼化钛颗粒的相互作用并促进分散.     

Oxidative reactivity of S-nitrosoglutathione with Hantzsch 1,4-dihydropyridine

[formula: see text] S-Nitrosoglutathione oxidized 4-substituted Hantzsch 1,4-dihydropyridines in CH3CN/H2O or CH3CN/phosphate aqueous buffer solution to give aromatic products in various yields.     

新型重整催化剂的研究—Pt／BaKL型沸石中钡的作用

本文采用XRD,NH_3-TPD,IR以及TEM等方法考察了Pt/BaKL沸石中Ba~(2+)的作用。NH_3-TPD结果表明,交换Ba~(2+)后的L型沸石的酸性,由于阳离子的作用仅在弱酸范围内有些改变,但与载铂的沸石的催化活性无明显的对应关系。IR及XRD谱线表明,BaKL沸石中Ba~(2+)在最佳交换度(26.3%)时,随预培烧温度的提高,使Ba~(2+)处于沸石孔道中B、C、D位置,接近于最佳分布,此时IR谱线上1421cm~(-1)处有一新峰。当沸石负载铂后,因铂与Ba~(2+)的相互作用,新峰消失,导致铂粒在沸石上分布更加均匀;铂粒在1.5—3.0nm之间占有最大比例,使得Pt/BaKL沸石呈现芳构化活性及选择性高于Pt/KL沸石,分别为～98%和～95%。