The MC SCF theory: Method of one-electron Hamiltonian

The one-electron Hamiltonian method is developed to solve the variational equations of the MC SCF theory. The many-parameter family of the one-electron Hamiltonian is derived and conditions for parameters to provide convergence of the SCF procedure to the energy minimum are obtained. A computation scheme based on the use of the one-electron Hamiltonian is described.     

Studies in the furan series

A study was made of certain transformations of the bicyclic compounds of the fur an series synthesized from 3,4-bis(chloromethyl)furan, N-butyl-4H, 6H-furo [3,4-c]pyrrole and 4H,6H-thieno[3,4-c]furan. On the basis of the same dichloride, 3,4-dimethyl furan and furan-3,4-dialdehyde were synthesized.For part XLVI, see [10].     

A Study of Viscosity in the Extraction System Constituted by Tributyl Phosphate and Phosphoric Acid

Data on the kinematic viscosity of phosphoric acid solutions in technical-grade tributyl phosphate and in an industrial extract from a technological purification system based on tributyl phosphate, which contain 0–18% phosphoric acid in terms of P₂O₅, at 10–70°C are presented.     

Calculation of accurate permanent dipole moments of the lowest 1,3Sigma+ states of heteronuclear alkali dimers using extended basis sets

Obtaining ultracold samples of dipolar molecules is a current challenge which requires an accurate knowledge of their electronic properties to guide the ongoing experiments. In this paper, we systematically investigate the ground state and the lowest triplet state of mixed alkali dimers (involving Li, Na, K, Rb, Cs) using a standard quantum chemistry approach based on pseudopotentials for atomic core representation, Gaussian basis sets, and effective terms for core polarization effects. We emphasize on the convergence of the results for permanent dipole moments regarding the size of the Gaussian basis set, and we discuss their predicted accuracy by comparing to other theoretical calculations or available experimental values. We also revisit the difficulty to compare computed potential curves among published papers, due to the differences in the modelization of core-core interaction.     

Spectral Studies on Some Pyrimidine Derivatives in Different Solvents

The electronic absorption spectra of 2-aminopyrimidine (compound I), 2-amino-4-methylpyrimidine (compound II), 2-amino-4,6-dimethylpyrimidine (compound III), 2-amino-4,6-dimethoxypyrimidine (compound IV), 4-amino-2,6-dimethylpyrimidine (compound V), and 4,5-diamopyrimidine (compound VI) have been measured in water and in a series of different organic solvents. The solvent effects on the spectra are discussed and the solvent induced spectral shifts are analyzed in terms of different solute–solvent interaction mechanisms, using the multiple linear regression technique.     

Thiophene conversion in the BIMF process

Catalytic conversion of an oil distillate with the added extra amounts of thiophene over a zeolite catalyst was studied. The rate of the catalyst deactivation was found to increase with the increase in the thiophene concentration in the feed. A possible pathway of the thiophene conversion is discussed.     

Relative Lewis basicities of six AI(ORF)4- superweak anions and the structures of LiA

The relative Lewis basicities of six Al(ORF)4- ions, Al[OC(CH3)(CF3)2]4-, Al(OC(CF3)3]4-, Al(OCPh(CF3)2]4-, Al[OC[4-C6H4(tBu)](CF3)2]4-, Al(OC(Cy)(CF3)2]4-, and Al(OCPh2(CF3)]4-, have been determined by measuring their relative coordinating abilities towards Li+ in dichloromethane. The relative Li- Lewis basicities of the Al(ORF)4- ions are linearly related to the aqueous pKa values of the corresponding parent HORF fluoroalcohols. The Lewis basicity of Al[OCH(CF3)2]4- could not be measured because two of these anions can coordinate to one Li+ cation. The structures of LiAl[OCH(CF3)2]4 and [1-Et-3-Me-1,3-C3H3N2][Li[Al[OCH(CF3)2)4]2] were determined.     

Reactions of alicyclic epoxy compounds with oxygen-centered nucleophiles

The review analyzes the reactions of alicyclic epoxy compounds with oxygen-containing nucleophiles (alcohols, water, and organic acids), describes biologically active products of these reactions, and discusses their mechanisms and results of their simulation by quantum-chemical methods. The regio-and stereoselectivity of nucleophilic reactions of epoxy compounds and the activation of epoxy ring by achiral and chiral catalysts are also considered.     

Potassium Iodide as a Chemical Actinometer for 254 nm Radiation: Use of lodate as an Electron Scavenger

Abstract— A solution of 0.6 M iodide and 0.1 M iodate in 0.01 M borate buffer (pH 9.25) can be used as a chemical actinometer to measure the incident fluence from a low-pressure mercury lamp that puts out more than 85% of its energy at 254 nm. The actinometric solution is optically opaque to light below 290 nm and is optically transparent to wavelengths greater than 330 nm. Hence, the solution absorbs all of the germicidal wavelengths but little if any of the ambient light normally present in the laboratory. Iodate acts as an electron scavenger and prevents the back reaction of the free electron with the iodine atom following UV excitation of KI. Irradiation results in the linear formation of triiodide, which is quantitated by measuring its absorbance at 352 nm. The quantum yield for this system is approximately 0.75 0.03 at 20.7A_oC or approximately three times greater than that obtained previously using nitrous oxide as an electron scavenger. A model is proposed to account for this difference. A precise expression to account for the concentration and temperature dependence of the quantum yield is given by pH = 0.75(1 + 0.23[C - 0.577])(1 + 0.02[T - 20.7]) where C is the concentration of iodide and T is the temperature. The concentration of iodide can be obtained from the absorbance at 300 nm prior to irradiation using 1.061 MJ cm⁻¹ as the molar extinction coefficient. This actinometric system meets the quality criteria established by the International Union of Pure and Applied Chemistry with the caveat that it is designed to measure only germicidal radiation (i.e. wavelengths less than 290 nm).     

The interactions of (=O→Si)-(benzoyloxymethyl)trifluoro-and -(benzoyloxymethyl) methyldifluorosilanes with a solvent

The IR spectra of solutions of (=OSi)-(benzoyloxymethyl)trifluorosilane (1),-(benzoyloxymethyl)methyldifluorosilane (2), and butyl benzoate (3) are examined in the region of thev(C=O) stretching vibrations in 24 solvents. The ability of compounds1—3 to undergo specific intermolecular interactions is evaluated from the dependence ofv(C=O) on the Kamlet-Taft (^*,, ) parameters, which was obtained for the carbonyl groups involved in the intramolecular coordinate (=OSi) bond and for free carbonyl groups. The corresponding values of the coefficients in the Kamlet-Taft equations are indicative of a weak ability of pentacoordinate silicon compounds1 and2 to undergo acid-base interactions.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 4, pp. 689–692, April, 1995.