DFT mechanistic study of the H2‐assisted chain transfer copolymerization of propylene and p‐methylstyrene catalyzed by zirconocene complex

DFT computations have been performed to investigate the mechanism of H₂‐assisted chain transfer strategy to functionalize polypropylene via Zr‐catalyzed copolymerization of propylene and p‐methylstyrene (pMS). The study unveils the following: (i) propylene prefers 1,2‐insertion over 2,1‐insertion both kinetically and thermodynamically, explaining the observed 1,2‐insertion regioselectivity for propylene insertion. (ii) The 2,1‐inserion of pMS is kinetically less favorable but thermodynamically more favorable than 1,2‐insertion. The observation of 2,1‐insertion pMS at the end of polymer chain is due to thermodynamic control and that the barrier difference between the two insertion modes become smaller as the chain length becomes longer. (iii) The pMS insertion results in much higher barriers for subsequent either propylene or pMS insertion, which causes deactivation of the catalytic system. (iv) Small H₂ can react with the deactivated [Zr]?pMS?PP_n facilely, which displace functionalized pMS?PP_n chain and regenerate [Zr]? H active catalyst to continue copolymerization. The effects of counterions are also discussed. © 2014 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2015 , 53, 576–585     

Flame-retardant effect of cross-linked phosphazene derivatives and pentaerythritol derivatives on polypropylene

Journal of Thermal Analysis and Calorimetry - A phosphazene-based flame retardant (PBFA) was synthesized by hexachlorocyclotriphosphazene and N-aminoethylpiperazine. To improve the flame retardancy...     

Positive ground state solutions for Schrödinger–Poisson system with critical nonlocal term in ℝ3

This paper is dedicated to studying the following Schrödinger–Poisson system $$\left\{\begin{array}{ll}-\mathrm{\Delta }u+V(x)u-K(x)\varphi |u{|}^{3}u=a(x)f(u),& x\in {ℝ}^3,\\ -\mathrm{\Delta }\varphi =K(x)|u{|}^5,& x\in {ℝ}^3.\end{array}\right.$$ Under some different assumptions on functions V(x), K(x), a(x) and f(u), by using the variational approach, we establish the existence of positive ground state solutions.     

Photo-Controlled Macroscopic Self-Assembly Based on Photo-Switchable Hetero-Complementary Quadruple Hydrogen Bonds

A photo-switchable hetero-complementary quadruple H-bonding array, which consists of an azobenzene-derived ureidopyrimidinone (UPy) module ( Azo-UPy ) and a nonphotoactive diamidonaphthyridine (DAN) derivative ( Napy-1 ), is constructed based on a reversible photo-locking approach. Upon UV (390 nm)/Vis (460 nm) light irradiations, photo-switchable quadruple H-bonded dimerization between Azo-UPy and Napy-1 can be achieved with exhibiting 4.8×10⁴-fold differences in binding strength (ON/OFF ratios). Furthermore, smart polymeric gels with unique photo-controlled macroscopic self-assembly behavior can be fabricated by introducing such quadruple H-bonding array as photo-regulable noncovalent interfacial connections.     

80.5 MeV/u碳离子诱发铜靶的放射性剩余产物测量

高能重带电粒子能直接穿透靶原子核外电子层,与原子核发生直接碰撞,发生散裂反应,产生一系列具有放射性的剩余产物核.重带电粒子诱发靶材放射性剩余核与辐射防护和人员安全有着密切联系,当前,大部分剩余核产额主要依靠蒙特卡罗粒子输运程序进行模拟计算,其准确程度亟需通过实验测量进行准确评估.本文利用能量为80.5 MeV/u的(12)^C⁶⁺粒子对薄铜靶开展了辐照实验与伽玛射线测量,结合伽玛谱学分析方法,得出了辐照产生的18种放射性剩余产物的初始活度和产生截面值,并与PHITS模拟结果进行对比.结果表明,PHITS模拟程序对放射性剩余核种类的估计具有较高可靠性,在其绝对产额方面,与实验测量仍具有较大偏差.     

Microelectromechanical Systems for Nanomechanical Testing: Electrostatic Actuation and Capacitive Sensing for High-Strain-Rate Testing

Experimental Mechanics - There have been relatively few studies on mechanical properties of nanomaterials under high strain rates, mainly due to the lack of capable nanomechanical testing devices....     

Naphthalimide‐phthalimide derivative based photoinitiating systems for polymerization reactions under blue lights

Naphthalimide‐phthalimide derivatives (NDPDs) have been synthesized and combined with an iodonium salt, N‐vinylcarbazole, amine or 2,4,6‐tris(trichloromethyl)‐1,3,5‐triazine to produce reactive species (i.e., radicals and cations). These generated reactive species are capable of initiating the cationic polymerization of epoxides and/or the radical polymerization of acrylates upon exposure to very soft polychromatic visible lights or blue lights. Compared with the well‐known camphorquinone based systems used as references, the novel NDPD based combinations employed here demonstrate clearly higher efficiencies for the cationic polymerization of epoxides under air as well as the radical polymerization of acrylates. Remarkably, one of the NDPDs (i.e., NDPD2) based systems is characterized by an outstanding reactivity. The structure/reactivity/efficiency relationships of the investigated NDPDs were studied by fluorescence, cyclic voltammetry, laser flash photolysis, electron spin resonance spin trapping, and steady state photolysis techniques. The key parameters for their reactivity are provided. © 2014 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2015 , 53, 665–674     

Detecting nonclassicality of light via Lieb's concavity

Nonclassical light states are important for both conceptual and practical reasons: they are basic ingredients in testing and exploring quantum foundations, and are crucial resources in quantum technologies. Various useful criteria have been developed to detect nonclassicality in the literature, and several meaningful measures of nonclassicality have been introduced and measured experimentally. In this work, by use of a non-Hermitian generalization of the Wigner-Yanase-Dyson skew information and playing with operator ordering in evaluating average photon number, we develop a novel family of criteria for detecting nonclassicality of light based on Lieb's concavity, which is a deep and powerful result concerning interaction between quantum states and observables. We elucidate the information-theoretic as well as the physical meaning of the criteria, and illustrate their effectiveness in capturing and quantifying nonclassicality of various important light states.