The acoustic spectrophonometer: a novel bioanalytical technique based on multifrequency acoustic devices

A measurement technique similar to optical absorption spectroscopy but based on evanescent acoustic waves is described in this paper. This format employs a planar spiral coil to vibrate a single crystal of quartz from 6 to 400 MHz, in order to measure multifrequency acoustic spectra. Consistency with the defined Sauerbrey and Kanazawa terms K1 and K2 when applied to multiple frequencies was found for these specific operating conditions in terms of a significant fit between the measured and calculated values: For an IgG surface density of 13.5 ng mm(-2) the measured value of K1 is 22.5 x 10(-6) and the calculated value is 20.4 x 10(-6), whilst for glycerol viscous loadings of 5.131 cP the measured value of K2 is 0.47 and the calculated value is 0.54. Thus for these specific surface loadings the multifrequency data fits to the predictions of the Sauerbrey model to within 10% and to Kanazawa model within 13%. However collective frequency shifts for 5.131 cP solutions of sucrose, dextran and glucose were found to exhibit an unanticipated additional variability (R2 < 0.4) with frequency, but retained a square root of frequency dependency within a factor 2 of the interpolated K2 values. The response to the 5.131 cP dextran solution was found to be significantly below the other isoviscous solutions, with a substantially reduced frequency shift and K2 value than would be expected from its bulk viscosity. In comparison with these viscous solutions, IgG protein films consistently produced linear frequency shifts with little scatter (R2 > 0.96) that were proportional to the operating frequency, and fully consistent with the Sauerbrey model under these specific conditions. A t-test value of 14.52 was calculated from the variance and mean of the two groups, and demonstrates that the acoustic spectrophonometer can be used to distinguish between the acoustic impedance characteristics of two chemical systems that are not clearly differentiable at a single operating frequency.     

Hypersonic evanescent waves generated with a planar spiral coil

A planar spiral coil has been used to induce hypersonic evanescent waves in a quartz substrate with the unique ability to focus the acoustic wave down onto the chemical recognition layer. These special sensing conditions were achieved by investigating the application of a radio frequency current to a coaxial waveguide and spiral coil, so that wideband repeating electrical resonance conditions could be established over the MHz to GHz frequency range. At a selected operating frequency of 1.09 GHz, the evanescent wave depth of a quartz crystal hypersonic resonance is reduced to 17 nm, minimising unwanted coupling to the bulk fluid. Verification of the validity of the hypersonic resonance was carried out by characterising the system electrically and acoustically: Impedance calculations of the combined coil and coaxial waveguide demonstrated an excellent fit to the measured data, although above 400 MHz a transition zone was identified where unwanted impedance is parasitic of the coil influence efficiency, so the signal-to-noise ratio is reduced from 3000 to 300. Acoustic quartz crystal resonances at intervals of precisely 13.2138 MHz spacing, from the 6.6 MHz ultrasonic range and onto the desired hypersonic range above 1 GHz, were incrementally detected. Q factor measurements demonstrated that reductions in energy lost from the resonator to the fluid interface were consistent with the anticipated shrinkage of the evanescent wave with increasing operating frequency. Amplitude and frequency reduction in contact with a glucose solution was demonstrated at 1.09 GHz. The complex physical conditions arising at the solid-liquid interface under hypersonic entrainment are discussed with respect to acceleration induced slippage, rupture, longitudinal and shear radiation and multiphase relaxation affects.     

A Branched Pore Model Analysis for the Adsorption of Acid Dyes on Activated Carbon

A new branched-pore adsorption model has been developed using an external mass transfer coefficient, K _f, an effective diffusivity, D _eff, a lumped micropore diffusion rate parameter, K _b, and the fraction of macropores, f, to describe sorption kinetic data from initial adsorbent-adsorbate contact to the long-term adsorption phase. This model has been applied to an environmental pollution problem—the removal of two dyes, Acid Blue 80 (AB80) and Acid Red 114 (AR114), by sorption on activated carbon. A computer program has been used to generate theoretical concentration-time curves and the four mass transfer kinetic parameters adjusted so that the model achieves a close fit to the experimental data. The best fit values of the parameters have been determined for different initial dye concentrations and carbon masses. Since the model is specifically applicable to fixed constant values of these four parameters, a further and key application of this project is to see if single constant values of these parameters can be used to describe all the experimental concentration-time decay curves for one dye-carbon system.The error analysis and best fit approach to modeling the decay curves for both dye systems show that the correlation between experimental and theoretical data is good for the fixed values of the four fitted parameters. A significantly better fit of the model predictions is obtained when K _f, K _b and f are maintained constant but D _eff is varied. This indicates that the surface diffusivity may vary as a function of surface coverage.     

The temperature dependence of coherent two-photon processes in naphthalene in the strong exciton-photon coupling regime

Temperature-dependent intensity data for two-photon excitation and second harmonic generation signals phase matched onto the polariton branches of the single a-exciton of naphthalene are presented. The data are shown be in quantitative agreement with the polariton fusion model which accounts for strong exciton-photon coupling. In this model the polariton scattering frequency and group velocity determine the branching ratios for the above signals.     

Stereoselective synthesis of (8R,8aS)-8-methylhexahydroindolizin-5-one

Catalytic hydrogenation of dihydroindolizidinone occurred preferentially from the endo-face giving rapid entry to (8R,8aS)-8-methylhexahydroindolizin-5-one, a key intermediate in the synthesis of 5,8-disubstituted indolizidines and deoxypumiliotoxin 251H. The selectivity could be improved further by diimide reduction though this also resulted in some oxidation of the alkene to the diene. The basis of the unusual stereoselectivity in the diimide reduction is believed to be stereoelectronic in origin.     

Immunoaffinity-based extraction of phenylurea herbicides using mixed antibodies against isoproturon and chlortoluron

Summary The analysis of several phenylurea herbicides in different waters is described using an immunoaffinity column clean-up and determination by high performance liquid chromatography. The pesticides were selectively retained on a solid phase extraction column containing antibodies to chlortoluron and to isoproturon immobilised onto silica. Selected phenylureas were eluted using a simple phosphate buffered saline/ethanol mixture at low pH. The immunoaffinity approach gave extracts free of interfering substances and allowed detection limits comparable to those required for pesticides in water in the European Community. The proposed method was successfully applied to the determination of chlortoluron, isoproturon, linuron and chlorbromuron in tap and river water. Presented at the 21^st ISC held in Stuttgart, Germany, 15^th–20^th September, 1996     

Natural benzofurans. Synthesis of medicagol methoxybenzofuran

A general route to 2-arylbenzofurans, consisting of reaction of an o-halogenophenol ester with a cuprous arylacetylide, was employed to synthesize medicagol methoxybenzofuran. 2,4-Diraethoxyacetophenone was converted to 2,4-dimethoxyphenylacetylene in three steps and reaction of the cuprous salt with 2-iodo-4,5-methylenedioxyphenyl acetate gave the desired 2-(2′,4′-dimethoxyphenyl)-5,6-methylenedioxybenzofuran.     

Permittivity and AC conductivity in yttria-stabilized zirconia

Alternating current (ac) conductivity and permittivity measurements were carried out on yttriastabilized cubic zirconia, with yttria varying from 9.6 to 25.5 mol%. In this composition range, the dielectric constant measured at 10³ Hz decreased from 29.8 to 23.2 as the yttria concentration increased. A plot of the ac conductivity versus frequency exhibited a plateau conductivity (_dc) and a frequency () dependent term '(). An analysis of '() with a suitable theoretical approach based on a pairs-approximation model, resulted in a calculated binding energy for the yttrium-associated oxygen vacancy of 0.29±0.05 eV, which compares favorably with values obtained by different means in previous studies. The experimental determination of the frequency dependence of the conductivity and its analysis provides an effective basis for understanding the ionic conductivity mechanism.