Exciton Molecules in Quantum Wells: Influence of the Well Width Fluctuations

The influence of the well width fluctuations on the dependence of the binding energy of excitonic complexes in quantum wells is studied by using the path-integral Monte-Carlo technique. The results are compared with available experimental data and a good agreement is found.Postdoctoral researcher of FWO-Vlaanderen     

Effect of nickel coating on electrochemical performance of graphite anodes for lithium ion batteries

Among the different materials often studied and proposed as negative electrodes for lithium-ion batteries, graphite anodes are the most used in commercial batteries. For this study, synthetic graphite was tested. During the first discharge 0.2 Li ions were consumed for the formation of the SEI film and the capacity reaches about 387 mAh/g. But at the end of the first charge only 72% of the initial charge was recovered (the reversible capacity is about 279 mAh/g). In order to improve this performance we have deposited metallic nickel on graphite with the intention to obtain a homogeneous thin layer able to modify the nature of the SEI film, to allow the diffusion of lithium ions through the protective layer, and also to increase the performance of graphite electrodes. The results show a decrease of the irreversible capacity loss (16% instead of 28% for pure graphite electrodes) as well as better cycleability for a nickel-deposited graphite electrode with only 11% weight ratio of nickel. On the other hand, an increase of the nickel content decreases this performance.     

Modelling and design of a travelling-wave electro-optic modulator on InP

Based on a rigorous vectorial analysis, a fast travelling-wave Mach–Zehnder modulator is modelled and designed. The cross-section of the semiconductor layer stack and the lossy electrodes are carefully modelled using the method of lines in order to investigate propagation characteristics, velocity and losses. This yields an accurate microwave and optical field distribution to explain the behaviour of the component. In order to enhance the modulation efficiency, design curves are derived and the cross-sectional dimensions for minimum microwave loss are determined. The loss of the optimized modulator agrees very well with small-signal measurements up to 40 GHz and HFSS simulations. The layerstack of the fabricated device is suitable for integration with InP multi-wavelength lasers.     

Finitely generated simple algebras: A question of B. I. Plotkin

In his recent series of lectures, Prof. B. I. Plotkin discussed geometrical properties of the variety of associativeK-algebras. In particular, he studied geometrically noetherian and logically noetherian algebras and, in this connection, he asked whether there exist uncountably many simpleK-algebras with a fixed finite number of generators. We answer this question in the affirmative using both crossed product constructions and HNN extensions of division rings. Specifically, we show that there exist uncountably many nonisomorphic 4-generator simple Ore domains, and also uncountably many nonisomorphic division algebras having 2 generators as a division algebra. The first author is grateful to Professor B. I. Plotkin for communicating this problem to him and for stimulating conversations.     

Polarization dynamics of intracavity frequency-doubled Nd:YAG laser

Experimental study of low-frequency dynamics of an intracavity frequency-doubled Nd:YAG laser demonstrates the influence of the interaction of orthogonally polarized modes, participating in frequency doubling (type II phase matching), on the stability of the laser output. At a sufficiently low pump rate and low conversion efficiency, the laser shows stable operation with a low noise level at the frequencies of relaxation oscillations. At a high pump power and/or a high conversion efficiency, the laser emission becomes unstable as a result of Hopf bifurcation at the frequencies of relaxation oscillations that are responsible for the anti-phase polarization dynamics of the laser.     

What Oxidation State of Iron Determines the Amethyst Colour?

A colourless quartz crystal doped with ⁵⁷Fe³⁺ was obtained by hydrothermal synthesis in an NH₄F solution. The crystal was transformed into violet amethyst by gamma-irradiation. The change in colour was accompanied by changes in the Mössbauer spectrum that can be interpreted as the conversion of trivalent iron into the tetravalent state: Fe³⁺→Fe⁴⁺.

     

The mechanism of emission in the red photoluminescence band of porous silicon

Porous silicon (PS) exhibits several photoluminescence (PL) bands, whose spectral position and intensity depend strongly on the actual conditions of preparation of PS, its treatment, and subsequent use. The PS PL band peaking at about 1.8 eV and usually assigned to the intrinsic emission of silicon nanocrystals was studied. It was shown that the temperature-induced variation of the PL kinetics in the 80 to 300-K interval follows a complex pattern and depends noticeably on the actual point on the band profile. The temperature behavior of PL decay in the 1.8-eV band is determined by the electron-hole recombination rate within a nanocrystal and the cascade carrier transitions from small to large nanocrystals, with an attendant decrease in energy.     

A fast method to measure the thickness of removed layer from etching of SSNTD based on EDXRF

Solid state nuclear track detectors are commonly used for measurements of concentrations of radon gas and/or radon progeny. All these measurements depend critically on the thickness of the removed layer during etching. However, the thickness of removed layer calculated using the etching period does not necessarily provide a sufficiently accurate measure of the thickness. For example, the bulk etch rate depends on the strength of stirring during etching for the LR 115 detector. We propose here to measure the thickness of the removed layer by using energy-dispersive X-ray fluorescence spectrometry. In the present work, a reference silver nitrate pellet is placed beneath the LR 115 detector, and the fluorescence X-ray intensity for silver is then measured. We have found a linear relationship between the X-ray intensity and the thickness of the removed layer for LR 115 detector. This provides a fast method to measure the thickness of removed layer from etching of LR 115 detector. However, this method was found to be inapplicable for the CR-39 detector. Therefore, alternative methods have yet to be explored for the CR-39 detector.     

Optimal entropic uncertainty relation for successive measurements in quantum information theory

We derive an optimal bound on the sum of entropic uncertainties of two or more observables when they are sequentially measured on the same ensemble of systems. This optimal bound is shown to be greater than or equal to the bounds derived in the literature on the sum of entropie uncertainties of two observables which are measured on distinct but identically prepared ensembles of systems. In the case of a two-dimensional Hilbert space, the optimum bound for successive measurements of two-spin components, is seen to be strictly greater than the optimal bound for the case when they are measured on distinct ensembles, except when the spin components are mutually parallel or perpendicular     

A priori estimates and existence of positive solutions for strongly nonlinear problems

In this paper we study the existence of positive solutions for a nonlinear Dirichlet problem involving the m-Laplacian. The nonlinearity considered depends on the first derivatives; in such case, variational methods cannot be applied. So, we make use of topological methods to prove the existence of solutions. We combine a blow-up argument and a Liouville-type theorem to obtain a priori estimates. Some Harnack-type inequalities which are needed in our reasonings are also proved.