2,6-O-二戊基-3-O-三氟乙酰β-环糊精和聚硅氧烷混合手性石英毛细管柱分离对映体

本文合成了部分烷基化三氟乙酰化的β-环糊精手性固定相(DP-TFA-β-CD),并把它与普通聚硅氧烷OV-7混合制备出了柱效高、热稳定性好的手性石英毛细管柱。与直接涂DP-TFA-β-CD相比,混合固定相能在较短分析时间内对卤代烃、醇、酯、γ-内酯、胺等对映体有更好的拆分。     

Carbonylation of Benzyl Halides Over Two-Phase Catalyst of Iron Pentacarbonyl

Carbonylation of benzyl halides to phenylacetic acid was studied in a two-phase system with iron pentacarbonyl as the catalyst precursor. The solutions consisted of a benzyl halide and iron pentacarbonyl in benzene and tetrabutylammonium hydrogen sulfate in aqueous sodium hydroxide. Stirring under carbon monoxide readily produced phenylacetic salts in aqueous phase which were then acidified and extracted with ether. The yields of phenylacetic acid from benzyl iodide and from benzyl bromide were similar at a evel of about 50percnt;, that of the latter being higher by 1%. The yield from benzyl chloride was far less, at a level of only 21%. The rate as studied with gas chromatography was found to decrease in the order benzyl iodide>benzyl bromide>benzyl chloride.     

3—（3,5—二氨基—2,4,6—三硝基苯基）氨基—5—硝基—1,2,4—三唑的合成

多硝基多氨基三唑类衍生物作为含能材料,具有高氮、致密、钝感等优点。本文通过3-氨基-1,2,4-三唑和三硝基三氯苯的缩合,再经过三唑碳原子上的硝化反应和芳环上的氨化反应,合成并鉴定了标题化合物。     

Boron implantation in Si: Channeling effects studied by SIMS and simulation

The axial channeling behaviour of boron implants in <100>, <110> and <111> silicon wafers is investigated by SIMS. Large differences of channeling characteristics such as channeled projected range (the projected range of channeled ions or channeling peak) and the fraction of channeled to implanted ions are observed among the three major crystal orientations. Within the critical angle, the channeling behaviour is very sensitive to the incidence beam angle with respect to crystal orientations. SIMS measurements are performed at different positions along several critical directions over a whole wafer. Well channeled profiles with an incidence beam angle to crystal orientations of 0 ° are obtained for each ion implantation energy and orientation. The results are used to test various models of ion implantation by simulation. A 3-parameter model for electronic stopping power of boron in silicon was proposed.     

手性高效液相色谱法测定1—（6‘—甲氧基萘）乙醇不对称氢酯基化反应

在自制的硅基纤维素－三（３，５－二甲基苯基氨基甲酸酯）高效液相色谱手性固定相上（ＨＰＬＣ－ＣＳＰ），优化了１－（６＇－甲氧基萘）乙醇氢酯基化反应产物－萘普生甲酯手性分离的条件，测定了相应的一系列不对称氢酯基化反应产物的对映体过剩值（ｅ．ｅ．值）。结果表明，在ＣＤＭＰＣ－ＣＳＰ手性柱上用ＨＰＬＣ测定此类不对称催化反应的光学产率，评价催化剂体系的手性选择是一种非常理想的方法。     

低分子量溴代聚苯乙烯的制备及应用

用溶液法合成了一系列低分子量的聚苯乙烯，其溴化产物（Ｂｒ－ＰＳ）的溴含量和热稳定性与美国同类产品Ｐｙｒｏ－Ｃｈｅｋ ＬＭ相当，分别用作聚苯乙烯树脂的阻燃剂，极限氧指数测定结果表明，其阻燃性也达到了Ｐｙｒｏ－Ｃｈｅｋ ＬＭ的水平。     

高效液相色谱蛋白质手性固定相

本文综述了近年文献中已报道的各种高效液相色谱蛋白质（酶）手性固定相及其在手性拆分中的应用，并阐述了蛋白质作为手性选择剂拆分机理的研究进展。     

电极条件对硫酸介质中电解还原提纯镱过程的影响

研究了以钌铱钛合金网和汞分别为阳、阴电极, 在无气氛保护条件下, 采用电解还原方法从铥、镱、镥硫酸盐溶液中分离提纯镱的过程. 讨论了在8 V恒电压时的电极间距、位置, 以及阴、阳极表面积对电解过程中的电流、还原率影响. 优化了电解还原过程, YbSO4产品的纯度稳定达到99.5%以上, 一次收率可达80%;提镱后母液中的铥和镥被富集4倍以上, 其中Lu含量高于50%, 十分有利于后续铥/镥分离.     

Kinetic spectrophotometric determination of trace manganese (II) with dahlia violet in nonionic microemulsion medium

A new catalytic kinetic spectrophotometric method has been developed for the determination of trace amount of manganese (II) in nonionic microemulsion medium. The method is based on the catalytic effect of manganese (II) on the oxidation of dahlia violet by potassium periodate with nitrilotriacetic acid as an activitor in the presence of nonionic microemulsion. Under the optimum conditions, the calibration graph is linear in the range of 0.0004-0.0056 μg ml⁻¹ of manganese (II) at 580 nm. The detection limit achieved is 3.75×10⁻⁵ μg ml⁻¹. Manganese (II) in foodstuff samples was determined with satisfactory results.     

Alkyl- and aryl-substituted corroles. 4. Solvent effects on the electrochemical and spectral properties of cobalt corroles

Solvent effects on the electrochemistry and spectroscopic properties of alkyl- and aryl-substituted corroles in nonaqueous media are reported. The oxidation and reduction of six compounds containing zero to seven phenyl or substituted phenyl groups on the macrocycle were studied in four different nonaqueous solvents (CH(2)Cl(2), PhCN, THF, and pyridine) containing 0.1 M tetra-n-butylammonium perchlorate. Dimers were formed upon oxidation of all corroles in CH(2)Cl(2), but this was not the case in the other three solvents, where either monomers or dimers were formed upon oxidation depending upon the solvent Gutmann donor number and the number or location of aryl substituents on the macrocycle. The half-wave potentials were analyzed as a function of the number of aryl substituents on the macrocycle as well as the concentration of added pyridine to PhCN solutions of the compound, and these data were combined with data from the spectroelectrochemistry experiments to determine the stoichiometry of the species actually in solution after the first oxidation or first reduction of each compound. The results of these experiments indicate that reduction of the bispyridine adduct (Cor)Co(III)(py)(2) proceeds via the monopyridine complex (Cor)Co(III)(py) to give in each case the unligated cobalt(II) corrole [(Cor)Co(II)](-). In contrast, pyridine remains coordinated after electrooxidation, and the final product was characterized as [(Cor)Co(III)(py)(2)](+).