丙烯选择氧化铋钼铁复氧化物催化剂组成,结构及性能的研究

采用XRD、Raman、XPS及催化剂性能评价等手段,考察了Bi_3(FeO_4)(MoO_4)_2和Fe_2(MoO_4)_3分别存在及两者共存时对Bi-Mo复氧化物体系催化性能的影响.结果表明,这两种含Fe物种的存在都有助于改善Bi-Mo系复氧化物催化剂对丙烯选择氧化反应的催化性能.但两者在作用机理上有所不同.Fe_2(MoO_4)_3本身无催化活性,但在反应条件下可部分还原为FeMoO_4形成Fe~(3+)/Fe~(2+)氧化还原对;且其地结构上与α-Bi_2(MoO_4)_3相匹配,这些因素都有助于促进催化体系中电子和氧物种的传递及催化剂表面活性中心的再生,从而提高催化性能.Bi_3(FeO_4)(MoO_4)_2在反应条件下也可形成Fe~(3+)/Fe~(2+)氧化还原对,但由于其Fe~(3-)所处的化学环境与Fe_2(MoO_4)_3很不相同,且Fe的含量也不及Fe_2(MoO_4)_3,因此它在促进催化体系中电子和氧物种的传递及催化剂表面活性中心的再生等方面的性能较差,但它对提高催化剂表面的活性中心(Bi-Mo对)数目有贡献.     

Y2O3 and MgO co-doped ceria based electrolytes

Electrolytes of Ce_1-x-y Y _x Mg _y O_2-0.5x-y were prepared with citrate method and were characterized by inductively coupled plasma-atomic emission spectrometry, energy dispersive spectrometry, powder X-ray diffraction, and impedance spectroscopy. The effect of composition on the structure, conductivity, and stability of the electrolytes were investigated. When 0≤x≤ about 0.2 and 0≤y≤ about 0.05, the electrolytes were all single phase materials of ceria-based solid solution. However, when y> about 0.05, the electrolytes became two-phase materials, Y³⁺ and Mg²⁺ co-doped ceria-based solid solution and free MgO. The sample with nominal composition of Ce_0.815Y_0.065Mg_0.12O_2-d showed ionic conductivity at 973 K close to or even a little higher than that of similarly prepared Ce_0.9Gd_0.1O_1.95, but had lower cost of raw materials and a little better stability in reducing atmosphere. The existing of free MgO improved the stability of the electrolytes in reducing atmosphere, but too much free MgO reduced the conductivity.     

酞菁铜与Q-CdS超微粒子界面的光致电荷转移研究

半导体超微粒子与有机分子界面的光致电行转移过程是当前光化学和材料科学研究的一个活跃领域［‘，2］；研究的目的主要有两个方面，一是研究半导体超微粒子表面光致电行转移的特性；二是研究有机分子对超微粒子的光敏化作用．目前，超微粒子的功能化研究日益深入，其独特的光     

Simulation of water cluster assembly on a graphite surface

The assembly of small water clusters (H2O)n, n = 1-6, on a graphite surface is studied using a density functional tight-binding method complemented with an empirical van der Waals force correction, with confirmation using second-order M?ller-Plesset perturbation theory. It is shown that the optimized geometry of the water hexamer may change its original structure to an isoenergy one when interacting with a graphite surface in some specific orientation, while the smaller water cluster will maintain its cyclic or linear configurations (for the water dimer). The binding energy of water clusters interacting with graphite is dependent on the number of water molecules that form hydrogen bonds, but is independent of the water cluster size. These physically adsorbed water clusters show little change in their IR peak position and leave an almost perfect graphite surface.     

NITROXIDE-MEDIATED FREE RADICAL SYNTHESIS OF MESOGEN-JACKETED LIQUID CRYSTAL POLYMERS*

The first TEMPO-mediated "living" free radical polymerization of liquid crystallinemonomer, 2, 5-bis[(4-methoxyphenyl)oxycarbonyl]styrene(MPCS), was carried out at 130℃ withBPO as an initiator. The molecular weight of the polymer can be varied from rather low values to highvalues while maintaining narrow polydispersity. It was observed that the polymerization of MPCSproceeded much faster than that of styrene. A tentative explanation for this fast polymerization wassuggested.     

Preparation of spherical spinel LiMn2O4 cathode material for lithium ion batteries

A novel process is proposed for synthesis of spinel LiMn₂O₄ with spherical particles from the inexpensive materials MnSO₄, NH₄HCO₃, and NH₃H₂O. The successful preparation started with carefully controlled crystallization of MnCO₃, leading to particles of spherical shape and high tap density. Thermal decomposition of MnCO₃ was investigated by both DTA and TG analysis and XRD analysis of products. A precursor of product, spherical Mn₂O₃, was then obtained by heating MnCO₃. A mixture of Mn₂O₃ and Li₂CO₃ was then sintered to produce LiMn₂O₄ with retention of spherical particle shape. It was found that if lithium was in stoichiometric excess of 5% in the calcination of spinel LiMn₂O₄, the product had the largest initial specific capacity. In this way spherical particles of spinel LiMn₂O₄ were of excellent fluidity and dispersivity, and had a tap density as high as 1.9 g cm^–3 and an initial discharge capacity reaching 125 mAh g^–1. When surface-doped with cobalt in a 0.01 Co/Mn mole ratio, although the initial discharge capacity decreased to 118 mAh g^–1, the 100th cycle capacity retention reached 92.4% at 25°C. Even at 55°C the initial discharge capacity reached 113 mAh g^–1 and the 50th cycle capacity retention was in excess of 83.8%.     

Chaotic micromixers using two-layer crossing channels to exhibit fast mixing at low Reynolds numbers

We report two chaotic micromixers that exhibit fast mixing at low Reynolds numbers in this paper. Passive mixers usually use the channel geometry to stir the fluids, and many previously reported designs rely on inertial effects which are only available at moderate Re. In this paper, we propose two chaotic micromixers using two-layer crossing channels. Both numerical and experimental studies show that the mixers are very efficient for fluid manipulation at low Reynolds numbers, such as stretching and splitting, folding and recombination, through which chaotic advection can be generated and the mixing is significantly promoted. More importantly, the generation of chaotic advection does not rely on the fluid inertial forces, so the mixers work well at very low Re. The mixers are benchmarked against a three-dimensional serpentine mixer. Results show that the latter is inefficient at Re = 0.2, while the new design exhibits rapid mixing at Re = 0.2 and at Re of O(10(-2)). The new mixer design will benefit various microfluidic systems.     

An evaluation of exogenous application of protoporphyrin IX and its dimethyl ester as a photodynamic diagnostic agent in poorly differentiated human nasopharyngeal carcinoma

5-Aminolevulinic acid and its esterified analogues have been under much investigation to enhance the endogenous production of protoporphyrin IX (PpIX) in tumor cells. However, in this work, we studied the in vitro and in vivo efficacy of exogenously administered PpIX and its esterified analogue, PpIX dimethyl ester (PME), in poorly differentiated human nasopharyngeal carcinoma (NPC/CNE-2) as a photodynamic diagnostic (PDD) agent. NPC/CNE-2 at its earliest time, 1 h after incubation with PME in in vitro studies, has exhibited 64% (P <0.01) higher tumor to normal cell (T/N) fluorescence ratio than with PpIX. In an in vivo mouse xenograft model, comparable photosensitizer concentration in tumor after intravenous administration was observed at 1-3 h time points, but at 9 h, PME had 31% (P=0.05) greater concentration in tumor compared with PpIX. In addition, by constituting PME and PpIX in different topical gel composites, of which, PME gel composition of 8:2 Plasdone and Gantrez resulted in the highest T/N ratio at 6 h after application (34%; P <0.05) in comparison with other gel composites. Evaluation of PME and PpIX constituted in the delivery vehicles investigated showed comparable selectivity for tumor at 1-3 h, thus neither photosensitizer is more efficient than the other for PDD at the early time points; however, beyond 6 h, PME had higher selectivity for tumor compared with PpIX. Thus, further investigation is warranted to improve the drug delivery vehicle for greater tumor selectivity at a shorter incubation time.     

Thermal degradation and flame retardancy of flexible polyvinyl chloride containing solid superacid

The objective of the present article was to study the thermal degradation behavior and flame retardancy of flexible polyvinyl chloride (PVC) composites containing TiO₂/SO ^2?₄ solid superacid because of its strong catalytic ability for esterification and dehydration. The TiO₂/SO ^2?₄ solid superacid was synthesized by using precipitation immersion method, and its structure was investigated by X-ray diffraction. As expected, the value of limiting oxygen index for PVC/Sb₂O₃/(TiO₂/SO ^2?₄ ) composite was 32.5% and the char yield of PVC/Sb₂O₃/(TiO₂/SO ^2?₄ ) composite was significantly improved compared to neat PVC in thermogravimetry tests. In addition, the peak heat release rate and smoke production rate of PVC/Sb₂O₃/(TiO₂/SO ^2?₄ ) decreased by 14% and 42%, respectively, compared with neat PVC. Moreover, the results of cone calorimetry tests and electron micrograph of char residue showed that the char yield of TiO₂/SO ^2?₄ was enhanced, resulting in a strong char layer structure with outstanding fire retardance cone. In conclusion, the results of this work showed that the addition of solid superacid promoted the decomposition and dehydration of PVC, which formed a compact and continuous char layer on the surface of the material. Hence, the study provides a new perspective for producing composites with excellent flame retardancy and smoke suppression properties of PVC.