CsNiCl3晶体的光谱精细结构、零场分裂参量及Jahn-Teller效应

应用不可约张量理论构造了三角对称晶场中3d²/3d⁸态离子的45阶可完全对角化的微扰哈密顿矩阵，研究了CsNiCl₃晶体的光谱精细结构、晶体结构、零场分裂参量、Jahn-Telller效应以及自旋单重态对Ni²⁺离子基态能级的影响，理论与实验相符合.在此基础上，进一步研究了以前工作中被忽略的自旋-自旋耦合作用和Trees修正对CsNiCl₃晶体的光谱精细结构和零场分裂参量的影响，发现有四种机理会影响零场分裂参量：1)自旋-轨道耦合机理，2)自旋-自旋耦合机理；3)自旋-轨道与自旋-自旋联合耦合机理；4)自旋-轨道与Trees修正联合耦合机理，其中自旋-轨道耦合机理是最主要的，其他三种机理也是不可忽略的. 关键词： 基态能级 精细结构 零场分裂 自旋-自旋耦合     

恒流应力下E2PROM隧道氧化层的退化特性研究

在电容测量的基础上研究了薄隧道氧化层在恒定Fowler-Nordheim(F-N)隧穿电流下的退化情况. 这种退化是恒流应力和时间的函数，对恒流应力大小的依赖性更加强烈，隧道氧化层在F-N电流下的退化是注入电荷密度(Q_inj)的函数. 在较低Q_inj下氧化层中发生正电荷俘获，在较高Q_inj下发生负电荷俘获，导致栅压变化的反复. 关键词： 2PROM')" href="#">E²PROM 隧道氧化层 退化 恒流应力     

Au/SiO2纳米复合薄膜的微结构及光吸收特性研究

用多靶磁控溅射技术制备了Au/SiO2纳米多层薄膜.利用透射电子显微镜以及吸收光谱对Au/SiO2复合薄膜的微观结构、表面形貌及光学性能进行了表征和测试.研究结果表明:单层Au/SiO2薄膜中Au沉积时间小于10s时,分散在SiO2中的Au颗粒随Au的沉积时间的延长而增大;当沉积时间超过10s后,Au颗粒的尺寸几乎不随沉积时间变化,但Au颗粒的形状由网络状结构变为薄膜状结构.[Au(t1)SiO2(600)]×5多层薄膜在540-560nm波长附近有明显的表面等离子共振吸收峰,且吸收峰的强度随Au的沉积时间增加而增强.基于修正后的Maxwell-Garnett (M-G)有效媒质理论,讨论了金属颗粒的形状对等离子共振吸收峰的峰位和强度的影响.模拟的吸收光谱与实验吸收光谱形状、趋势及吸收峰位相符合.     

(111)择优取向的Pb(Zr0.52Ti0.48)O3铁电薄膜的制备及研究

选用不同浓度的Pb(Zr_0.52Ti_0.48)O₃溶胶，用Sol-gel法在Pt/Ti/SiO₂/Si基片上沉积一层厚度不同的Pb(Zr_0.52Ti_0.48)O₃ (PZT52)过渡层，经400℃烘烤、550℃退火等程序后，再用Sol-gel法在PZT52过渡层上沉积Pb(Zr_0.52Ti_0.48)O _{关键词： PZT铁电薄膜 择优取向 过渡层 剩余极化强度}     

掺入Ni元素的LiCoO2晶体光谱结构及电子顺磁共振g因子

在弱场图像下,利用Racah不可约张量算符方法得到了三角对称3d4/3d6电子组态的210阶可完全对角化的微扰哈密顿矩阵、最近邻点电荷模型晶体结构常量公式和电子顺磁共振g因子公式.研究了LiCoO2晶体和掺入Ni的LiCoO2:Ni晶体中Co3+的基态能级、晶体结构和电子顺磁共振g因子.考虑了LiCoO2晶体和LiCoO2:Ni晶体中自旋单重态和三重态对Co3+基态能级的影响,讨论了LiCoO2晶体和在LiCoO2晶体中掺杂Ni后Co3+局域结构常量大小的变化是引起Co3+的基态能级变化的主要原因,理论和实验都证实了这一点.还计算了掺杂前后的电子顺磁共振g因子,计算结果与实验值符合得较好.     

The Calibrating Theory in the Network Parameters Measurement of Microwave and MMW Devices

The paper introduces a special system calibration technology in s-parameters measurement of microwave and millimeter wave devices. The 8-term errors module is built by analyzing the signals flowing in the measurement system. Then the calibration technology using non-standard kits is designed on the base. Finally, the experiment using the calibration technology is introduced.     

Challenging Students to View the Concept of Area in Triangles in a Broad Context: Exploiting the Features of Cabri-II

This study focuses on the constructions in terms of area and perimeter in equivalent triangles developed by students aged 12–15 years-old, using the tools provided by Cabri-Geometry II [Labore (1990). Cabri-Geometry (software), Université de Grenoble]. Twenty-five students participated in a learning experiment where they were asked to construct: (a) pairs of equivalent triangles “in as many ways as possible” and to study their area and their perimeter using any of the tools provided and (b) “any possible sequence of modifications of an original triangle into other equivalent ones”. As regards the concept of area and in contrast to a paper and pencil environment, Cabri provided students with different and potential opportunities in terms of: (a) means of construction, (b) control, (c) variety of representations and (d) linking representations, by exploiting its capability for continuous modifications. By exploiting these opportunities in the context of the given open tasks, students were helped by the tools provided to develop a broader view of the concept of area than the typical view they would construct in a typical paper and pencil environment.     

高频强泵浦场激发的等离子体参量不稳定性的特性

本文论证了当泵浦波的强度足够强时,在相当普遍的条件下,对均匀等离子体,唯一可以发生的参量不稳定性是类似于弱场的振荡二束不稳定性(OTSI)。对均匀及弱不均匀等离子体,高频强泵浦场激发的参量不稳定性都是绝对不稳定性。同样的性质在磁化等离子体中也可以得到。 关键词：     

激光等离子体2660紫外探针及干涉系统

成功地在六路高功率Nd玻璃激光装置上建立了2660紫外激光探针和适合紫外波段的Normaski干涉仪,首次将可见波长的连续激光应用于紫外干涉仪中靶成像调整和光路准直。利用该紫外光干涉仪,在铜柱状靶(φ500μm)上测量了厚等离子体中高达0.6n。的电子密度。     

Error analysis: a tool for selecting travel demand models

In developing travel demand models it is generally assumed that the base-year data used in developing the parameters, as well as the forecasted data to be used as independent variables for the design year, are of acceptable quality. The purpose of this paper is to present the application of error propagation theory in assesing the predictive quality of one type of travel demand forecasting model (multinomial logit models) and to demonstrate how error considerations can be used as a tool for identifying the optimal model. The general conclusions of this study are that: (1) it is indeed possible to quantify errors in dependent variables in logit models as a consequence of errors in independent variables; and (2) error consideration can be used as a tool for identifying the optimal model from a set of candidate models. Further research is recommended to develop better insights into the phenomenon of error propagation so that the consideration of errors can be a factor in decisions on model selection.