钛离子辐照对MgB2超导薄膜的载流能力和磁通钉扎能力的影响

利用混合物理化学气相沉积法(hybrid physical-chemical vapor deposition, HPCVD)可以制备出高性能的MgB₂超导薄膜, 再对薄膜进行钛(Ti)离子辐照处理.经过辐照处理后的样品被掺入了Ti元素, 与未处理的干净MgB₂样品相比,其超导转变温度没有出现大幅度的下降, 而在外加磁场下的临界电流密度得到了明显的提高,同时样品的上临界磁场也得到了提高. 在温度5 K, 外加垂直磁场为4 T的情况下, Ti离子辐照剂量为1× 10¹³/cm²的样品的临界电流密度达到了1.72× 10⁵ A/cm², 比干净的MgB₂要高出许多,而其超导转变温度仍能维持在39.9 K的较高水平.     

光电子成像研究AgOCH3-和Ag-(CH3OH)x (x=1, 2)

用光电子成像技术和从头算法研究Ag^-(CH₃OH)_x (x=1, 2)和AgOCH₃^-. 从AgOCH₃^-振动分辨的光电子谱得 到AgOCH₃^-的绝热和垂直电离能分别为1.29(2)和1.34(2) eV. Ag^-(CH₃OH)_{1,2相似文献}   

Origin7．5软件在大学物理综合设计性实验教学中的应用探讨

本文采用origin7．5软件对大学物理综合设计性实验数据的处理进行了探讨。实验结果揭示出了热敏电阻温度特性、光敏电阻伏安特性和光照特性。     

Source breakup dynamics in Au + Au collisions at sqrt[s(NN)]=200 GeV via three-dimensional two-pion source imaging

A three-dimensional correlation function obtained from midrapidity, low p(T), pion pairs in central Au+Au collisions at sqrt[s(NN)]=200 GeV is studied. The extracted model-independent source function indicates a long range tail in the directions of the pion pair transverse momentum (out) and the beam (long). A proper breakup time tau(0) ~ 9 fm/c and a mean proper emission duration Delta tau ~ 2 fm/c, leading to sizable emission time differences ({|Delta t(LCM)|} approximately 12 fm/c), are required to allow models to be successfully matched to these tails. The model comparisons also suggest an outside-in "burning" of the emission source reminiscent of many hydrodynamical models.     

人工神经网络应用于维生素B族4组分同时测定

应用人工神经网络原理，采用Levenberg-Marquardt BP算法，对于吸收光谱严重重叠的维生素B1，B2，B6和烟酰胺4组分同时进行含量测定。四者的平均回收率分别为100％，98％，96％，100％。该方法用于复合维生素B片剂中B1，B2，B6和烟酰胺的同时测定，获得较满意的结果。实验表明，该方法与现有的算法相比具有训练速度快、预测结果准确度高等特点，有望能成为多组分分析的有效方法之一。     

Photonic instantaneous microwave frequency measurement based on two different phase modulation to intensity modulation conversions

A novel photonic technique for instantaneous frequency measurement of microwave signal based on phase modulation to intensity modulation conversion is proposed and demonstrated. In the proposed system, an optical carrier is modulated by a microwave signal with its frequency to be measured through a phase modulator. The phase-modulated optical signal is then converted to intensity-modulated signals in two independent paths using a dispersive media and a frequency discriminator respectively. Since the dependence of the received microwave power on the input microwave frequency in the two paths differs, the microwave power ratio between the two paths can be used to uniquely determine the microwave frequency. The major advantages of the approach lie in that only one laser source and the bias-free phase modulator is employed in the system, which improves the stability of the system. Experimental demonstrations of the frequency measurement based on the proposed approach are presented.     

GPU accelerated simulations of 3D deterministic particle transport using discrete ordinates method

Graphics Processing Unit (GPU), originally developed for real-time, high-definition 3D graphics in computer games, now provides great faculty in solving scientific applications. The basis of particle transport simulation is the time-dependent, multi-group, inhomogeneous Boltzmann transport equation. The numerical solution to the Boltzmann equation involves the discrete ordinates (S_n) method and the procedure of source iteration. In this paper, we present a GPU accelerated simulation of one energy group time-independent deterministic discrete ordinates particle transport in 3D Cartesian geometry (Sweep3D). The performance of the GPU simulations are reported with the simulations of vacuum boundary condition. The discussion of the relative advantages and disadvantages of the GPU implementation, the simulation on multi GPUs, the programming effort and code portability are also reported. The results show that the overall performance speedup of one NVIDIA Tesla M2050 GPU ranges from 2.56 compared with one Intel Xeon X5670 chip to 8.14 compared with one Intel Core Q6600 chip for no flux fixup. The simulation with flux fixup on one M2050 is 1.23 times faster than on one X5670.     

A controlled quantum teleportation scheme of an N-particle unknown state via three-particle W1 states

In this paper a controlled quantum teleportation scheme of an N-particle unknown state is proposed when N groups of three-particle W1 states are utilized as quantum channels. The quantum information of N-particle unknown state is transmitted from the sender to the recipient under the control of all supervisors. It can be realized with a certain probability. After the sender makes Bell-state measurements and the supervisors perform the computational basis measurements, the recipient will introduce auxiliary particles and carry out unitary transformations depending on classical information from the sender and the supervisors. Finally, the computational basis measurement will be performed by the recipient to confirm whether the teleportation succeeds or not. The successful completion of the scheme relies on all supervisors＇ cooperation. In addition, the fidelity and security of the scheme are discussed.     

Characterization of surface deformation around Vickers indentations in InGaAsP epilayers on InP substrate

The deformation surrounding Vickers indentations on InGaAsP/InP epilayers have been studied in detail. The surface topography was characterized by using atomic force microscopy (AFM). The material pile-up and sink-in regions around the indentation impression was observed for the quaternary InGaAsP/InP epilayers. The sectional analysis mode of the AFM shows the depth profile at the indented region. Microindentation studies were carried out for different atomic fraction of the quaternary InGaAsP/InP compound semiconductor alloys. The microhardness values of InGaAsP/InP epilayers were found to be in the range of 5.08 and 5.73 GPa. These results show that the hardness value of the quaternary alloy drastically increases as the composition of As was increased by 0.01 atomic fraction and when the phosphorous concentration decreases from 0.4 to 0.38. The reason may be that the increase in As concentration hardens the lattice when phosphorous concentration was less and hardness decreases when phosphorous was increased.     

基于有机半导体激光材料的高灵敏度溶液检测传感器件

采用光抽运有机激光增益材料产生的放大自发辐射(amplified spontaneous emission ASE), 实现了不同浓度液体的实时检测. 以两种聚合物poly(9, 9-dioctylfluorene-co-benzothiadiazole)和poly(3-hexylthiophene)共混的激光增益介质薄膜作为平面光波导, 观察在滴加少量溶液前后以及不同溶液浓度下, 由于光波导的相对折射率变化导致的放大自发辐射阈值及峰位的变化, 实现对溶液检测. 实验结果显示, 在常温常压下对25 wt.% NaCl溶液检测可得与纯水相比, 放大自发辐射光谱红移了4.5 nm, ASE阈值从0.579 μJ/pulse上升到1.447 μJ/pulse, 约2.5倍, 溶液检测灵敏度达到97.8 nm/RIU(refractive index unit), 精度达到141.9 nm/RIU, 充分说明上述方法能实现高灵敏度溶液检测.