Power flow analysis for a floating sandwich raft isolation system using a higher-order theory

A higher-order sandwich theory is implemented in conjunction with an equivalent mobility-based power flow progressive method to determine power flow for a sandwich configured floating raft vibration isolation system. The power spectrum changes in whole frequency range effectively when core materials’ properties change. It is also shown that the loss factors of the sandwich configured floating raft influence the power flow transmitted to the foundation effectively in the medium- to high-frequency range and that the resonant peak cannot be avoided by increasing damping only in high-frequency ranges which is not found in floating raft isolation systems with isotropic beams.     

Observation of a charmoniumlike state produced in association with a J/psi in e+e- annihilation at sqrt[s] approximately equal to 10.6 GeV

We report the first observation of a charmoniumlike state recoiling from the J/psi in the inclusive process e+e- -->J/psi+anything at a mass of (3.943+/-0.006+/-0.006) GeV/c{2}. We also observe the decay of this state into D*D[over ] and determine its intrinsic width to be less than 52 MeV/c{2} at the 90% C.L. These results are obtained from a 357 fb{-1} data sample collected with the Belle detector near the Upsilon(4S) resonance, at the KEKB asymmetric-energy e+e- collider.     

Effects of edge screens on the absorption of blocks of theatre chairs

This paper reports new measurement results investigating the use of screens around samples of theatre chairs to minimize edge effects when measuring theatre chair absorption in reverberation chambers. The absorption measurements included both full scale and scale model measurements in reverberation chambers and a model recital hall. The use of screens has been proposed to better approximate the sound absorption of the larger blocks of chairs in auditoria. The method of measuring the absorption of blocks of chairs with screens around their edges and located in the corner of a reverberation chamber did not give results indicative of the values obtained for larger areas in auditoria. The addition of screens around samples of chairs did not eliminate the variation of absorption coefficients with perimeter/area ratio. The results of extrapolations from measurements of blocks of screened chairs to infinite samples gave lower absorption coefficients than found for blocks of unscreened chairs. The absorption of chairs in large performance halls can best be predicted using the P/A method to extrapolate from reverberation chamber measurements of smaller samples of unscreened chairs, with a range of P/A values, to the larger samples and lower P/A ratios of blocks of chairs typical of performance spaces.     

High-performance fiber-optic temperature sensor using low-coherence interferometry

A temperature-sensor system based on low-coherence interferometry with a fiber Mach-Zehnder interferometer as a phase modulator was implemented. A measurement range of 20 to 800 degrees C with a resolution of 0.025 degrees C (corresponding to 0.0004 fringe) was achieved with a 1-mm-long fiber Fabry-Perot interferometer as the sensing element.     

Investigation of the Li1+xV3O8 electrode–organic electrolyte interface by scanning photoelectron microscopy

To investigate the formation of a solid electrolyte interface (SEI) on the Li_1+xV₃O₈ electrode surface in the thermodynamic stability range of the organic electrolyte, we applied scanning photoelectron microscopy (SPEM) to a pristine electrode and to an electrode after ten cycles. The F K-edge absorption spectrum of the cycled electrode showed that LiF forms on the electrode surface during the lithium insertion–extraction process in the Li_1+xV₃O₈/Li cell. The photoelectron spectrum for the cycled electrode showed intense spectral features corresponding to Li 1s, F 2s, F 2p, and P 2p electron signals, whereas these spectral features were of negligible intensity for the pristine electrode. The above results give strong support for the formation of an SEI that consists of LiF and compounds containing phosphorus during operation of the battery. The SPEM images also revealed that the fluorine distribution on the surface of the cycled electrode was inhomogeneous.     

640 × 512 pixel narrow-band, four-band, and broad-band quantum well infrared photodetector focal plane arrays

A 9 μm cutoff 640 × 512 pixel hand-held quantum well infrared photodetector (QWIP) camera has been demonstrated with excellent imagery. A noise equivalent differential temperature (NEDT) of 10.6 mK is expected at a 65 K operating temperature with f/2 optics at a 300 K background. This focal plane array has shown background limited performance at a 72 K operating temperature with the same optics and background conditions. In this paper, we discuss the development of this very sensitive long-wavelength infrared camera based on a GaAs/AlGaAs QWIP focal plane array and its performance in quantum efficiency, NEDT, uniformity, and operability. In the second section of this paper, we discuss the first demonstration of a monolithic spatially separated four-band 640 × 512 pixel QWIP focal plane array and its performance. The four spectral bands cover 4–5.5, 8.5–10, 10–12, and 13.5–15 μm spectral regions with 640 × 128 pixels in each band. In the last section, we discuss the array performance of a 640 × 512 pixel broad-band (10–16 μm full-width at half-maximum) QWIP focal plane.     

Midrapidity neutral-pion production in proton-proton collisions at square root s = 200 GeV

The invariant differential cross section for inclusive neutral-pion production in p+p collisions at sqrt[s]=200 GeV has been measured at midrapidity (|eta|<0.35) over the range 1相似文献   

Scaling properties of proton and antiproton production in sqrt[s(NN)]=200 GeV Au+Au collisions

We report on the yield of protons and antiprotons, as a function of centrality and transverse momentum, in Au+Au collisions at sqrt[s(NN)]=200 GeV measured at midrapidity by the PHENIX experiment at the BNL Relativistic Heavy Ion Collider. In central collisions at intermediate transverse momenta (1.5相似文献   

Elliptic flow of identified hadrons in Au+Au collisions at sqrt sNN =200 GeV

The anisotropy parameter (v(2)), the second harmonic of the azimuthal particle distribution, has been measured with the PHENIX detector in Au+Au collisions at sqrt[s(NN)]=200 GeV for identified and inclusive charged particle production at central rapidities (|eta|<0.35) with respect to the reaction plane defined at high rapidities (|eta|=3-4 ). We observe that the v(2) of mesons falls below that of (anti)baryons for p(T)>2 GeV/c, in marked contrast to the predictions of a hydrodynamical model. A quark-coalescence model is also investigated.     

Transport of surface-modified iron nanoparticle in porous media and application to arsenic(III) remediation

The surface-modified iron nanoparticles (S-INP) were synthesized, characterized and tested for the remediation of arsenite (As(III)), a well known toxic groundwater contaminant of concern. The S-INP material was fully dispersed in the aqueous phase with a particle size distribution of 2–10 nm estimated from high-resolution transmission electron microscopy (HR-TEM). X-ray photoelectron spectroscopy (XPS) revealed that an Fe(III) oxide surface film was present on S-INP in addition to the bulk zero-valent Fe⁰ oxidation state. Transport of S-INP through porous media packed in 10 cm length column showed particle breakthroughs of 22.1, 47.4 and 60 pore volumes in glass beads, unbaked sand, and baked sand, respectively. Un-modified INP was immobile and aggregated on porous media surfaces in the column inlet area. Results using S-INP pretreated 10 cm sand-packed columns containing ∼2 g of S-INP showed that 100 % of As(III) was removed from influent solutions (flow rate 1.8 mL min⁻¹) containing 0.2, 0.5 and 1.0 mg L⁻¹ As(III) for 9, 7 and 4 days providing 23.3, 20.7 and 10.4 L of arsenic free water, respectively. In addition, it was found that 100% of As(III) in 0.5 mg/L solution (flow rate 1.8 mL min⁻¹) was removed by S-INP pretreated 50 cm sand packed column containing 12 g of S-INP for more than 2.5 months providing 194.4 L of arsenic free water. Field emission scanning electron microscopy (FE-SEM) showed S-INP had transformed to elongated, rod-like shaped corrosion product particles after reaction with As(III) in the presence of sand. These results suggest that S-INP has great potential to be used as a mobile, injectable reactive material for in-situ sandy groundwater aquifer treatment of As(III).