Identification of soy protein in meat by pyrolysis-high-resolution gas chromatography

Pyrolysis-gas chromatography was applied to the characterization of ground beef and soy protein isolate and its mixtures at the 50, 30 and 10% levels. A cryogenic trap pyrolysis mode was employed and the volatile pyrolysates were analysed by a high-resolution capillary gas chromatograph. Two phenolic derivatives, o-methoxy- and dimethoxyphenol, as well as 2,3-dithiabutane are uniquely observed at a large concentration in the soy pyrolysate. Quantification of these characteristic compounds allow the estimation of the level of soy inclusion in the mixture. This approach effectively denotes soy addition up to the 10% level in comminuted beef.     

Aging of poly(2-methoxy-5-(2'-ethylhexyloxy)-1,4-phenylenevinylene)/toluene solutions and subsequent effects on luminescence behavior of cast films

Morphological effects in luminescence properties of a representative semiconducting polymer, poly(2-methoxy-5-(2'-ethylhexyloxy)-1,4-phenylenevinylene) (MEH-PPV), has recently attracted much attention. Previous studies indicated that short-term heat treatment of solution-cast MEH-PPV films may result in the formation of mesomorphic order that is responsible for the "red" emission around 640 nm, in contrast to the single-chromophore "yellow" emission near 590 nm from the disordered matrix. On the basis of microscopic and spectroscopic evidence for films cast from freshly prepared and aged solutions, here we show that prolonged storage of MEHyellowPPV solutions at room temperature or lower may result in retardation of the thermally induced mesophase formation in the subsequently cast films. According to small-angle neutron scattering and differential scanning calorimetric observations over aged MEH-PPV/toluene solutions, we propose that the suppressed transformation into mesomorphic order is due to further development of nanocrystalline aggregates that serve as physical cross-links among MEH-PPV chains in the solution state upon long-term storage. These solvent-induced nanocrystalline aggregates, however, do not exhibit new spectroscopic features beyond the suppression of "red" emission at 640 nm from the mesomorphic phase.     

Effect of particle size in preparative reversed-phase high-performance liquid chromatography on the isolation of epigallocatechin gallate from Korean green tea

To isolate epigallocatechin gallate (EGCG) of catechin compounds from Korean green tea (Bosung, Chonnam), a C18 reversed-phase preparative column (250x22 mm) packed with packings of three different sizes (15, 40-63, and 150 microm) was used. The sample extracted with water was partitioned with chloroform and ethyl acetate to remove the impurities including caffeine. The mobile phases in this experiment were composed of 0.1% acetic acid in water, acetonitrile, methanol and ethyl acetate. The injection volume was fixed at 400 microl and the flow rate was increased as the particle size becomes larger. The isolation of EGCG with particle size was compared at a preparative scale and the feasibility of separation of EGCG at larger particle sizes was confirmed. The optimum mobile phase composition for separating EGCG was experimentally obtained at the particle sizes of 15 and 40-63 microm in the isocratic mode, but EGCG was not purely separated at the particle size of 150 microm.     

Determination of buprenorphine by high-performance liquid chromatography with fluorescence detection: application to human and rabbit pharmacokinetic studies.

A rapid, sensitive, precise and accurate high-performance liquid chromatographic assay with fluorescence detection was developed for the determination of buprenorphine in human, rabbit, pig and dog plasma. It is comprised of only a one-step extraction procedure with hexane-isoamyl alcohol at pH 9.25 and reversed-phase chromatography on a muPorasil column. The recoveries of buprenorphine and nalbuphine (internal standard) were greater than 90%. Calibration graphs were linear over the concentration range 3-300 ng/ml with a coefficient of variation, both within-day and between-day, of less than 9% at any level. The limit of detection was 1.0 ng/ml of plasma based on a signal-to-noise ratio of 3. Eight other clinically used narcotics were investigated to check for potential interferences and their analytical conditions. The possible decomposed compounds of buprenorphine were also checked for the specificity of this assay. The method has been successfully applied to the stability and pharmacokinetic studies of buprenorphine. Buprenorphine in plasma did not decompose significantly at -20 degrees C for four weeks. Pharmacokinetic application in six rabbits and a surgical patient revealed that buprenorphine followed a linear three-compartment model with two distribution phases. The two distribution and elimination half-lives and the clearance of buprenorphine were 1.32, 24.8 and 230 min and 224 ml/min in human plasma, and 0.94, 12.5 and 232 min and 30 ml/min in rabbit plasma.     

Ultrathin polymer film formation by collision-induced cross-linking of adsorbed organic molecules with hyperthermal protons

A new synthetic approach for the formation of ultrathin polymer films with customizable properties was developed. In this approach, the kinematic nature of proton collisions with simple organic molecules condensed on a substrate is exploited to break C-H bonds preferentially. The subsequent recombination of carbon radicals gives a cross-linked polymer thin film, and the selectivity of C-H cleavage preserves the chemical functionalities of the precursor molecules. The nature and validity of the method are exemplified with theoretical results from ab initio molecular dynamics calculations and experimental evidence from a variety of characterization techniques. Its applicability is demonstrated by the synthesis of ultrathin polymer films with precursor molecules such as dotriacontane, docosanoic acid, poly(acrylic acid) oligomer, and polyisoprene. The approach is fundamentally different from conventional chemical synthesis as it involves an unusual mix of physical and chemical processes including charge exchange, projectile penetration, kinematics, collision-induced dissociation, inelastic energy transfer, chain transfer, and chain cross-linking.     

Reversible replication between ordered mesoporous silica and mesoporous carbon

Highly ordered mesoporous silica can be regenerated from a mesoporous carbon CMK-3 that is a negative replica of mesoporous silica SBA-15, indicating reversible replication between carbon and inorganic materials.     

Theoretical investigation of the mechanisms of reaction of NCN with NO and NS

Quantum-chemical calculations were performed on the mechanisms of reaction of NCN with NO and NS. Possible mechanisms were classified according to four pathways yielding products in the following four possible groups: N2O/N2S + CN, N2 + NCO/NCS, N2 + CNO/CNS, and CNN + NO/NS, labeled in order from p1/p1s to p4/p4s. The local structures, transition structures, and potential-energy surfaces with respect to the reaction coordinates are calculated, and the barriers are compared. In the NCN + NO reaction, out of several adduct structures, only the nitroso adduct NCNNO lies lower in energy than the reactants, by 21.89 kcal/mol; that adduct undergoes rapid transformation into the products, in agreement with experimental observation. For the NS counterpart, both thionitroso NCNNS and thiazyl NCNSN adducts have energies much lower than those of the reactants, by 43 and 29 kcal/mol, respectively, and a five-membered-ring NCNNS (having an energy lower than those of the reactants by 36 kcal/mol) acts as a bridge in connecting these two adducts. The net energy barriers leading to product channels other than p4s are negative for the NS reaction, whereas those for the NO analogue are all positive. The channel leading to p1 (N2O + CN) has the lowest energy (3.81 kcal/mol), whereas the channels leading to p2 (N2 + NCO) and p2s (N2 + NCS) are the most exothermic (100.94 and 107.38 kcal/mol, respectively).     

Reversing a rotaxane recognition motif: threading oligoethylene glycol derivatives through a dicationic cyclophane

An already well-established recognition motif-namely one in which the NH2+ centers in the rod sections of the dumbbell components of rotaxanes are encircled by macrocyclic polyether components-has been turned simultaneously outside-in and inside-out, a fact that has been proved beyond any doubt by the stoppering of both ends of a [2]pseudorotaxane to give a stable [2]rotaxane. The [2]pseudorotaxane is formed in nitromethane when a benzylic dibromide, obtained after reacting an excess of 1,4-bis(bromomethyl)benzene with hexaethylene glycol, is added to an equimolar amount of a dicationic cyclophane in which two -CH2OCH2- chains link a pair of dibenzylammonium ions through the para positions on their phenyl rings. When the [2]pseudorotaxane is reacted in nitromethane with triphenylphosphine, a [2]rotaxane and the corresponding free dumbbell compound are isolated in 58 and 31% yields, respectively. The structure of the [2]rotaxane is established by using mass spectrometry (FABMS and ESMS) and NMR (1H and 13C) spectroscopy in nitromethane-d3. The [2]rotaxane exhibits quite dramatic changes in the 1H chemical shifts of the signals for its CH2N+ and CH2O protons compared with those in the free dumbbell compound. The 1H NMR spectrum of the [2]pseudorotaxane shows many similar features. Titration experiments with three of the six different CH2O probes give an average Ka value of 2900 +/- 750 M-1 in nitromethane-d3. The new recognition motif for the template-directed synthesis of rotaxanes can now be exploited at both the molecular and macromolecular levels of structure with numerous potential applications in sight.     

Comment on "Adsorption of naphthalene on zeolite from aqueous solution" by C.F. Chang, C.Y. Chang, K.H. Chen, W.T. Tsai, J.L. Shie, Y.H. Chen

A paper contributes not only by its originality and creativity, but also by its continuity and development toward subsequent research. Referencing and quotation accuracy are an important part of a scientific article. This study presents a literature review concerning the precision of 50 first authors' publications, which originally cited Ho's pseudo-second-order kinetic expression paper in kinetics model for solute sorption on various sorbents. This model applies to a range of solid-liquid systems such as metal ions, dyestuffs, herbicides, oil, and organic substances in aqueous systems onto various sorbents. In addition, citations of Lagergren and Elovich rate equations are also discussed. This comment offers information for citing the original idea of Ho's pseudo-second-order kinetic expression and Lagergren's pseudo-first-order kinetic equation. It is also suggested that the cited paper should be accurately quoted.     

Photochemistry of 5-phenyl-1-pentene in the gas phase

The photochemistry of the title compound has been studied in the gas phase using 254-nm irradiation. In addition to meta cycloadducts analogous to those observed in solution, population of S1(vib) in the gas phase gives several products, the relative amounts of which depend on quencher gas pressure but not on excitation wavelength. For example, in the absence of butane, the major photoproduct is compound 5. This product is formed by a [1,5] hydrogen shift in the primary photoproduct, compound 4. Compound 4 is an intramolecular meta cycloadduct that is generated in the gas phase with sufficient excess vibrational energy to undergo rearrangement unless quencher gas is present. Likewise, there is evidence that two other meta cycloadducts (2 and 3) are also formed with appreciable vibrational energy in the absence of a quencher gas. A unique intramolecular ortho cycloadduct is also formed from 1 but only within a narrow range of quencher gas pressures. This is a two-photon product, with the initial cycloadduct (11) ring opening to a cyclooctatriene (12) that photochemically closes to 6. The pressure dependence of this ortho cycloaddition may be due to a requirement for vibrational deactivation of 11 (Scheme 5) or a precursor species (Scheme 6). The overall chemistry is outlined in Scheme 7.