Immobilization of chiral Rh catalyst on glass and application to asymmetric transfer hydrogenation of aryl ketones in aqueous media

A chiral catalyst, Cp＊RhTsDPEN （Cp＊ = pentamethyl cyclopentadiene, TsDPEN = substitutive phenylsulfonyl-l,2-diphenylethylenediamine）, was synthesized and immobilized at the surface of glass. The immobilized catalyst exhibited good catalytic efficiency for asymmetric transfer hydrogenation of aromatic ketones in water with HCOONa as hydrogen source.     

Catalytic performance of cement clinker supported nickel catalyst in glycerol dry reforming

The paper reports the development of cement clinker-supported nickel （with metal loadings of 5 wt%, 10 wt%, 15 wt% and 20 wt%） catalysts for glycerol dry （CO2） reforming reaction. XRF results showed that CaO constituted 62.0% of cement clinker. The physicochemical characterization of the catalysts revealed 32-folds increment of BET surface area （SBET） with the addition of nickel metal into the cement clinker, which was also corroborated by FESEM images. Significantly, XRD results suggested different types of Ni oxides formation with Ni loading, whilst Ca3SiO5 and Ca2Al0.67Mn0.33FeO5 were the main crystallite species for pure cement clinker. Temperature-programmed reduction analysis yielded three domains of H2 reduction peaks, viz. centered at approximately 750 K referred to as type-Ⅰ peaks, another peaks at 820 K denoted as type-Ⅱ peaks and the highest reduction peaks, type-Ⅲ recorded at above 1000 K. 20 wt% Ni was found to be the best loading with the highest XG and H2 yield, whilst the lowest methanation activity. Syngas with lower H2/CO ratios （0.6 to 1.5） were readily produced from glycerol dry reforming at CO2-to-Glycerol feed ratio （CGR） of unity. Nonetheless, carbon deposit comprised of whisker type （Cv） and graphitic-like type （Cc） species were found to be in majority on 20 wt%Ni/CC catalysts.     

电感耦合等离子体原子发射光谱法测定人造金刚石中铁、钴、锰、镍

1引言近年来,我国人造金刚石的产量和应用有了很大的发展。以现有的人造金刚石合成技术,通常以Fe,Ni,Co,Mn等元素组成的合金作为触媒,这使人造金刚石中极易残留这些金属组成的包裹体。诸多研究表明,包裹体含量和分布情况对人造金刚石的性能有着重要影响[1]。经查阅文献,已有使用X射线荧光光谱法对人造金刚石中杂质元素含量进行半定量分析的报道[2]。电感耦合等离子体发射光谱法(ICP-AES)被广泛应用于岩矿、土壤样品中多元素分析[3]。本实验以在大气气氛中高温灰化和混合酸对样品进行前处理,采用ICP-AES测定人造金刚石中Fe,Co,Ni和Mn。本方法操作简便,处理效果良好。     

铅镉重金属离子在铋膜电极上的相互影响

采用原位镀铋电极的方式,以玻碳电极为工作电极,通过改变Cd2+和Pb2+的比例,考察不同Pb2+和Cd2+浓度条件下,两者同时存在时的相互影响。实验发现,Cd2+和Pb2+同时存在时,存在相互的影响,特别是对于Cd2+的检测,由于Pb2+较正的析出电位,对于Cd2+的析出有一定的辅助作用。考察了Cd2+和Pb2+单独存在时的分析性能,Pb2+沉积时间为60 s时,在1~80μg/L范围内呈线性关系,检出限为0.5μg/L;Cd2+的沉积时间为120 s,在1~25μg/L和30~200μg/L范围内有良好的线性关系,检出限为1.0μg/L。考察了铋膜电极在不同实际水样中对Pb2+和Cd2+的分析,获得了较好的一致性。     

Iron-mediated AGET ATRP of styrene and methyl methacrylate using ascorbic acid sodium salt as reducing agent

Atom transfer radical polymerization of styrene(St) and methyl methacrylate(MMA) in bulk and in different solvents using activators generated by electron transfer(AGET ATRP) were investigated in the presence of a limited amount of air using FeCl3·6H2O as the catalyst, ascorbic acid sodium salt(AsAc-Na) as the reducing agent, and a cheap and commercially available tetrabutylammonium bromide(TBABr) as the ligand. It was found that polymerization in THF resulted in shorter induction period than that in bulk and in toluene for AGET ATRP of St, while referring to AGET ATRP of MMA, polymerization in THF showed three advantages compared with that in bulk and toluene: 1) shortening the induction period, 2) enhancing the polymerization rate and 3) having better controllability. The living features of the obtained polymers were verified by chain end analysis and chain-extension experiments.     

Rapid Isolation of a Facultative Anaerobic Electrochemically Active Bacterium Capable of Oxidizing Acetate for Electrogenesis and Azo Dyes Reduction

In this study, 27 strains of electrochemically active bacteria (EAB) were rapidly isolated and their capabilities of extracellular electron transfer were identified using a photometric method based on WO₃ nanoclusters. These strains caused color change of WO₃ from white to blue in a 24-well agar plate within 40 h. Most of the isolated EAB strains belonged to the genera of Aeromonas and Shewanella. One isolate, Pantoea agglomerans S5-44, was identified as an EAB that can utilize acetate as the carbon source to produce electricity and reduce azo dyes under anaerobic conditions. The results confirmed the capability of P. agglomerans S5-44 for extracellular electron transfer. The isolation of this acetate-utilizing, facultative EBA reveals the metabolic diversity of environmental bacteria. Such strains have great potential for environmental applications, especially at interfaces of aerobic and anaerobic environments, where acetate is the main available carbon source.     

Solution Blowing of Poly（dimethylsiloxane）/Nylon 6 Nanofiber Mats for Protective Applications

A new strategy was developed to fabricate superhydrophobic nylon 6 nanofibers, in which the blend solutions of poly(dimethylsiloxane)(PDMS) prepolymer and nylon 6 was spun using an innovative solution blowing process, and then the PDMS prepolymer contianning nanofibers were cured to obtain PDMS/nylon 6 nanofiber mats. Morphology, surface composition, non-wetting property and protective performance were investigated. The results showed that the addition of PDMS prepolymer improved the spinnability of the spinning solutions, and the PDMS/nylon 6 nanofibers had smooth surfaces and diameters from 100 nm to 350 nm. The presence of PDMS effectively enhanced the hydrophobicity of the nanofiber mats, showing water contact angles of 132° to 161° for PDMS contents of 1 wt% to 3 wt%. The PDMS/nylon 6 mats also possessed excellent protective and transport properties. The results indicated the potential application of the novel nanofiber mats in protective clothing.     

Screening,Growth Medium Optimisation and Heterotrophic Cultivation of Microalgae for Biodiesel Production

This article presents a study on screening of microalgal strains from the Peking University Algae Collection and heterotrophic cultivation for biodiesel production of a selected microalgal strain. Among 89 strains, only five were capable of growing under heterotrophic conditions in liquid cultures and Chlorella sp. PKUAC 102 was found the best for the production of heterotrophic algal biodiesel. Composition of the growth medium was optimised using response surface methodology and optimised growth conditions were successfully used for cultivation of the strain in a fermentor. Conversion of algal lipids to fatty acid methyl esters (FAMEs) showed that the lipid profile of the heterotrophically cultivated Chlorella sp. PKUAC 102 contains fatty acids suitable for biodiesel production.     

Exopolysaccharides and Antimicrobial Biosurfactants Produced by Paenibacillus macerans TKU029

Paenibacillus macerans TKU029 can produce exopolysaccharides (EPSs; 3.46 g/L) and a biosurfactant (1.78 g/L) in a medium with 2 % (w/v) squid pen powder as the sole carbon/nitrogen source. The biosurfactant can reduce the surface tension of water from 72.30 to 35.34 mN/m at a concentration of 2.76 g/L and reach an emulsification index of 56 % after a 24-h reaction with machine oil. This biosurfactant is stable at 121 °C for 20 min, over a pH range from 3 to 11, and in <5 % salt solutions. It also shows significant antimicrobial activity, which remains active after treatment at 121 °C and at pH values from 4 to 10, against Escherichia coli BCRC13086, Staphylococcus aureus BCRC10780, Fusarium oxysporum BCRC32121 and Aspergillus fumigatus BCRC30099. Furthermore, human skin shows from 37.3 to 44.3 % hydration after being treated with TKU029 EPSs for 180 min. These results imply that EPSs and the biosurfactant from this strain have potential in cosmetics, for removal of oil contamination, and as antimicrobial agents.     

I2-mediated α-selective Ferrier glycosylation approach to synthesis of O-glycosyl amino acids

I₂ is an effective promoter for the synthesis of 2,3-unsaturated glycosides via Ferrier glycosylation. This reaction was used in the present work for the synthesis of O-glycosylated Fmoc amino acid building blocks. This metal-free reaction afforded the desired products with good to excellent yields with good α-selectivity.