From Nongelating to Gelating: Synthesis and Structural Self‐Assembling Property Relationships of a Homologous Series of Oligo(amide–triazole)s

A homologous series of oligo(amide–triazole)s (OAT) [ OAT‐CO₂H‐2 n and OAT‐COPrg‐(2 n +1) ] with an increasing number of primary amide (CONH) and triazole hydrogen‐bonding functionalities was prepared by an iterative synthetic procedure. It was found that their self‐assembly and thermoreversible gelation strength had a strong correlation to the number of hydrogen‐bonding moieties in the oligomers. There also existed a threshold value of the number of CONH units, above which all the oligomers became organogelators. Hence, oligomers with ≤4 CONH units are devoid of intermolecular hydrogen bonding and also non‐organogelating, whereas those that contain >4 CONH units show intermolecular association and organogelating properties. For the organogelators, the T_gel value increases monotonically with increasing number of CONH units. On the basis of FTIR measurements, both the CONH and triazole C? H groups were involved in the hydrogen‐bonding process. A mixed xerogel that consisted of a 1:1 weight ratio of two oligomers of different lengths ( OAT‐CO₂H‐6 and OAT‐CO₂H‐12 ) was found to show microphase segregation according to differential scanning calorimetry, thus indicating that oligomers that bear a different number of hydrogen‐bonding units exhibited self‐sorting to maximize the extent of intermolecular hydrogen bonding in the xerogel state.     

高铅炉渣中铅的测定

高铅炉渣样品经硝酸分解并过滤,所得滤液中铅离子与硫酸反应生成硫酸铅沉淀,与锌、铁、钙、铜、铝等离子分离,再加入乙酸溶解硫酸铅沉淀,在pH 5.5～6.0的介质中,以二甲酚橙作指示剂,用EDTA标准溶液滴定滤液中铅含量(w1);过滤所得沉淀经过氧化钠碱熔后,用电感耦合等离子体原子发射光谱法测定其中铅含量(w2),二者之和即为炉渣中的总铅(w)含量。     

Synthesis of oxygenated 2-methylindolines

A palladium-mediated high-yielding synthesis of oxygenated 2-methylindolines 4 from 2-allylnitrobenzene 1 and hydrazine is developed. The one-pot route combines the reduction of 2-allylnitrobenzene 1 and the sequential intramolecular hydroamination. The protocol provides a novel alternative for the synthesis of substituted 2-methylindoline 4.     

Polyethylene Glycol Backfilling Mitigates the Negative Impact of the Protein Corona on Nanoparticle Cell Targeting

In protein‐rich environments such as the blood, the formation of a protein corona on receptor‐targeting nanoparticles prevents target recognition. As a result, the ability of targeted nanoparticles to selectively bind to diseased cells is drastically inhibited. Backfilling the surface of a targeted nanoparticle with polyethylene glycol (PEG) molecules is demonstrated to reduce the formation of the protein corona and re‐establishes specific binding. The length of the backfilled PEG molecules must be less than the length of the ligand linker; otherwise, PEG interferes with the binding of the targeting ligand to its corresponding cellular receptor.     

Characterization of the patina formed on a low tin bronze exposed to aqueous hydrogen sulfide

The dark gray corrosion layer (patina) formed on the surface of a polished low tin bronze alloy following exposure to a deoxygenated and saturated aqueous solutions of H₂S has been characterized by X‐ray photoelectron spectroscopy, scanning electron microscopy‐energy dispersive spectroscopy and X‐ray diffraction. The system represents a model for bronze corrosion in reducing conditions where sulfate‐reducing bacteria in soils or deoxygenated seawater may generate H₂S during respiration. The initial surface was dominated by metallic copper together with Sn, Pb and Zn oxides and hydroxides. Surface enrichment of Pb and Zn was noted because of a smearing effect during polishing. At least some of the lead was crystalline. In contrast, the corrosion layer formed by H₂S(aq) exposure was dominated by polycrystalline Cu₂S (low and high chalcocite) and smaller concentrations of CuSO₄ · nH₂O. This surface was enriched with Zn as Zn(OH)₂. Lead was present as redeposited PbS (galena) crystallites in at least two different morphologies. Unlike bronzes exposed to oxidizing conditions, which develop protective SnO₂ layers, the H₂S(aq)‐exposed surface was considerably depleted in Sn. Copyright © 2014 John Wiley & Sons, Ltd.     

Characterization of size‐segregated aerosols using ToF‐SIMS imaging and depth profiling

Size‐segregated particles were collected with a ten‐stage micro‐orifice uniform deposit impactor from a busy walkway in a downtown area of Hong Kong. The surface chemical compositions of aerosol samples from each stage were analyzed using time‐of‐flight secondary ion mass spectrometry (ToF‐SIMS) operated in the static mode. The ToF‐SIMS spectra of particles from stage 2 (5.6–10 µm), stage 6 (0.56–1 µm), and stage 10 (0.056–0.1 µm) were compared, and the positive ion spectra from stage 2 to stage 10 were analyzed with principal component analysis (PCA). Both spectral analysis and PCA results show that the coarse‐mode particles were associated with inorganic ions, while the fine particles were associated with organic ions. PCA results further show that the particle surface compositions were size dependent. Particles from the same mode exhibited more similar surface features. Particles from stage 2 (5.6–10 µm), stage 6 (0.56–1 µm), and stage 10 (0.056–0.1 µm) were further selected as representatives of the three modes, and the chemical compositions of these modes of particles were examined using ToF‐SIMS imaging and depth profiling. The results reveal a non‐uniform chemical distribution from the outer to the inner layer of the particles. The coarse‐mode particles were shown to contain inorganic salts beneath the organics surface. The accumulation‐mode particles contained sulfate, nitrate, ammonium salts, and silicate in the regions below a thick surface layer of organic species. The nucleation‐mode particles consisted mainly of soot particles with a surface coated with sulfate, hydrocarbons, and, possibly, fullerenic carbon. The study demonstrated the capability of ToF‐SIMS depth profiling and imaging in characterizing both the surface and the region beneath the surface of aerosol particles. It also revealed the complex heterogeneity of chemical composition in size and depth distributions of atmospheric particles. Copyright © 2014 John Wiley & Sons, Ltd.     

Studies of degradation behaviors of poly (3‐hexylthiophene) layers by X‐ray photoelectron spectroscopy

Degradation behaviors of poly(3‐hexylthiophene‐2,5‐diyl) (P3HT) layers on NiO in the presence of H₂O at ambient pressure and dark conditions were studied using X‐ray photoelectron spectroscopy (XPS). Upon H₂O exposure at 120 °C, partial oxidation of P3HT together with molecular water incorporation, but with the maintained local ring‐structure, were deduced by XPS. Valence band spectra of XPS evidenced that the partial oxidation of P3HT local structure could alter π‐conjugation systems of P3HT layers, forming additional electronic states close to its original highest occupied molecular orbital. For comparison, P3HT surface was also exposed to O₂, and no change in the S 2p and C 1s spectra was found by O₂ exposure at 120 °C, implying that H₂O plays a major role at the initial stage of P3HT oxidation. Copyright © 2014 John Wiley & Sons, Ltd.     

Rapid and sensitive detection of lower respiratory tract infections by stuffer‐free multiplex ligation‐dependent probe amplification

Lower respiratory tract infection is one of the most common infectious diseases. However, conventional methods for detecting infectious pathogens are time‐consuming, and generally have a limited impact on early therapeutic decisions. We previously reported a rapid and sensitive method for detecting such pathogens using stuffer‐free multiplex ligation‐dependent probe amplification coupled with high‐resolution CE‐SSCP. In this study, we report an application of this method to the detection of respiratory pathogens. As originally configured, this method was capable of simultaneously detecting seven bacterial species responsible for lower respiratory tract infections, but its detection limit and assay time were insufficient to provide useful information for early therapeutic decisions. To improve sensitivity and shorten assay time, we added a target‐specific preamplification step, improving the detection limit from 50 pg of genomic DNA to 500 fg. We further decreased time requirements by optimizing the hybridization step, enabling the entire assay to be completed within 7 h while maintaining the same detection limit. Taken together, these improvements enable the rapid detection of infectious doses of pathogens (i.e. a few dozen cells), establishing the strong potential of the refined method, particularly for aiding early treatment decisions.