Exciton-related optical nonlinearities in semiconductors and semiconductor microcrystallites

We report on large optical nonlinearities due to specific many-body effects in high-density electron-hole pair systems. On bulk CdS we study the effect of free-carrier screening on the absorption and refraction in the vicinity of the band-gap at room temperature. Steady-state saturable absorption at mW-power levels and four-wave mixing with first-order efficiencies as large as 2% of the incoming light are demonstrated on a 1m slab. On CuBr microcrystallites embedded in glass we investigate the changes of the exciton absorption caused by many-exciton effects both at cryo and room temperature. In contrast to bulk semiconductors, we observe a blue shift of the exciton peak at resonant optical excitation. In addition, strong saturation of absorption with very large contrast shows up. We find Lorentzian saturation intensities in the 100 kW/cm² range.     

Scalar gluonium candidates and the radiativeJ/ψ decays

We discuss productions of scalar gluonium candidates in the radiativeJ/ decays. The branching ratios of such productions are estimated on the basis of the Euler-Heisenberg effective Lagrangian for gluon-photon couplings. We mention that these estimates cannot be expected to be accurate to better than within a factor 2. We show that the radiativeJ/ decays probably invalidate gluoniumgg interpretation of the GAMS meson F₀(1590) and a narrow 0⁺⁺ stateS lying below 1 GeV. However, a possible wide scalar effective gluonium candidate(920) is shown not to be excluded by the data on the decayJ/. We also find that the experimental data about radiativeJ/ decays presumably agree with a recently suggested interpretation of F₀(1590) as being approximately a half-and-half mixture of pure 0⁺⁺ gluoniumgg andSU(3)_f singlet quarkoniumq¯q states.     

Hypernuclear production with a strong spin-flip

A kinematically correct treatment of the full transition amplitude for many-body hypernuclear production is presented. By an example of (⁺, K⁺) reaction, effects of the spin-flip amplitude and its interference with the spin-non-flip amplitude are demonstrated and specified for ¹² C.Dedicated to Academician Václav Votruba on the occasion of his eightieth birthday.The discussions with many colleagues are appreciated, in particular those with R. Mach, L. Majling and T. Motoba were of much use.     

The electrical resistivity of the reentrant spin glass alloys (Fe0.65Ni0.35)1−x Mn x in the temperature range 4 to 280 K

The specific electrical resistivityp(T) was measured for the reentrant spin glass system (Fe_0.65Ni_0.35)_1–x Mn _x (0x0.102) in the temperature range 4 KT280 K. We used our own phenomenological ansatz to explain the results obtained in order to provide the fitted parameters with physical meaning. The cause of the observed minimum in the measured curves can be given by a model of local magnetism.     

Some problems concerning the use of automated radiochemical separation systems in destructive neutron activation analysis

The present state of a long term program is reviewed. It was started to elaborate a remote controlled automated radiochemical processing system for the neutron activation analysis of biological materials. The system is based on wet ashing of the sample, followed by reactive desorption of some volatile components. The distillation residue is passed through a series of columns filled with selective ion screening materials to remove the matrix activity. The solution is thus “stripped” from the interfering radioions, and it is processed to single-elements through group separations using ion-exchange chromatographic techniques. Some special problems concerning this system are treated. (a) General aspects of the construction of a (semi)automated radiochemical processing system are discussed; (b) Comparison is made between various technical realizations of the same basic concept; (c) Some problems concerning the “reconstruction” of an already published processing system are outlined.     

A SENSITIVE METHOD FOR DETERMINING CHLOROPHYLL b IN PLANT EXTRACTS

Abstract— A new method of using hydroxylamine as the reagent was developed to determine the concentrations of chlorophylls a and b in plant extracts accurately and sensitively. The method is based on the principle that hydroxylamine reacts in a short time with the aldehyde group of chlorophyll b in 95 per cent methanol at pH 5.8 to afford a derivative having a red band similar in position to the red band of chlorophyll a , while the spectrum of chlorophyll a is unaffected by the treatment with hydroxylamine. The method includes the measurements of absorbanlce for the mixture of a plant extract with hydroxylamine and for the reagent blank at a single wavelength, 666 mμ, and the concentrations of chlorophylls a and b are calculated from the absorbance value for the reagent blank and the increment of absorbance due to the reaction. By measuring this increment directly by difference photometry, one can determine a low concentration of chlorophyll b relative to chlorophyll a . The contents of chlorophylls in matured and etiolated leaves were determined by the method, and the errors included in this method were shown to be smaller than those in a commonly used technique including the measurements at two different wavelengths.     

Dielectric behavior of polyethyleneoxide (polyox)

Ohne Zusammenfassung     

PPP-Berechnungen und Vergleich der Elektronenspektren von iso-π-elektronischen Sauerstoff-, Stickstoff-, Schwefel- und Selenheterocyclen

Zusammenfassung 42 Heterocyclen, die sich formal von alternierenden und nichtalternierenden Kohlenwasserstoffen durch Ersatz einer Doppelbindung durch die Heteroatome Sauerstoff, Stickstoff, Schwefel und Selen ableiten, werden nach dem Pariser-Parr-Pople-Verfahren berechnet und ihre Spektren im nahen Ultraviolett und Sichtbaren beschrieben. Schwefel und Selen werden dabei im LCAO-MO-Verfahren nach dem p-Modell behandelt. In den meisten Fällen können die Berechnungen nicht nur die spektralen Charakteristika gut wiedergeben, sondern auch Beziehungen in den Spektren iso--elektronischer Verbindungen gleicher Struktur verständlich machen. Berechnungen an kationischen Stickstoffheterocyclen führten dann zu falschen Ergebnissen, wenn die Stickstoffparameter vom Pyrroltyp übernommen werden.

---

PPP-calculations and comparison of electronic spectra of iso--electronic oxygen, nitrogen, sulfur, and selenium heterocycles

42 heterocyclic compounds, formally derived from alternant or nonalternant hydrocarbons by replacing a C=C group by an oxygen, nitrogen, sulfur or selenium atom, are studied by the Pariser-Parr-Pople-type of calculation. By means of these results the near ultraviolet and visible spectra are described. The sulfur and the selenium atoms are treated in the LCAO-MO-method using the p-model. In most cases spectral features are not only well reproduced, but interrelations of the spectra of iso--electronic compounds, possessing analogous structures are interpreted, too. On calculating cationic nitrogen heterocycles using parameters of pyrrol type nitrogen results are unsatisfactory.

---

Résumé 42 composés hétérocycliques, formellement dérivés d'hydrocarbures alternants ou non alternants par remplacement d'un groupement C=C par un atome d'oxygène, d'azote, de soufre ou de sélénium, sont étudiés par la méthode de Pariser-Parr-Pople. Les résultats obtenus permettent de décrire le spectre U.V. proche et visible. Soufre et sélénium sont traités en utilisant le modèle p. Dans la plupart des cas les caractères spectraux sont non seulement correctement reproduits, mais les relations entre les spectres des composés iso--électroniques à structures analogues peuvent être interprétées. Les calculs concernant les heterocycles à azote cationique sont insatisfaisants lorsqu'ils sont effectués avec des paramètres de l'azote du type pyrrole.

---

---

Anmerkung: Die Arbeit wurde in dem von Prof. Dr. R. Mayer geleiteten Schwefelarbeitskreis der TU Dresden durchgeführt.