Efficiency of the multiwave method of determination of the ozone content in the atmosphere by UV spectrometry-ozonometry

Translated from Zhurnal Prikladnoi Spektroskopii, Vol. 55, No. 3, pp. 472–477, September, 1991.     

Influence of copper solute on the creep rate sensitivities of aluminium

The presence of copper atoms as continuous networks at the grain boundaries of an aluminium-copper alloy has been considered not preventing the moving of dislocations during creep (or at least partially). The dislocations can bs absorbed by these boundaries and penetrate through them. That leads to changés of shape and structure of grains and also to the sliding of grains against each other. This was deduced from the accelerating increase in the sensitivity of the steady state creep rate to the applied stress of an aluminium 2·8 wt% copper alloy examined at wide range of temperatures (50–350 °C) and applied stresses (7–170 MPa). This rapid increase in the sensitivity parameter of the steady state creep rate occurs in Al-Cu alloys at quite higher ranges of applied stresses and may be attributed mainly to the contribution of the grain boundary movements to the creep strain.     

Buchbesprechungen

Ohne Zusammenfassung

---

Book reviews

     

Indirect Methods For Determination of The Protective Effects of Coating Films on The Surface of Crystals

The extents of the protective effects of coating films on the surface of crystals were determined. Three different samples were made with different quantities of coating fluid (Sepifilm LP 010 in 10% aqueous solution). Since the atomizing rate was constant, the coating time increased in parallel with the volume of coating fluid applied. The direct measurement of film thickness and smoothness is very difficult, and therefore indirect methods were used. Dimenhydrinate was chosen as model drug; this is a heat-sensitive antihistamine with a low melting point. This temperature can be reached during the tableting process. The behaviour of samples on exposure to heat was examined by differential scanning calorimetry. The water uptakes of the samples were determined with an Enslin apparatus. Plasticity was studied with an instrumented tablet machine. These indirect methods (thermal conductivity, water uptake and plasticity measurements) revealed connections between the results of the various experiments. An overlong coating time decreased the protective effect of the coating film. This revised version was published online in August 2006 with corrections to the Cover Date.     

Time Evolution of Vibration-Induced Excited State Decay

A simple model consisting of two electronic levels and one vibrational mode (phonon) was theoretically studied. The electronic-vibrational interaction was linear in the vibrational displacement. The vibrational mode was taken in the harmonic approximation and was attached to the thermal bath formed by the ambient environment. The kinetic constants of the vibrational dissipation were of the second order in the vibrational-bath coupling and were taken in the Markovian limit. Although, depending on the parameters of the model, different curves of the non-radiative vibration-induced excited state decay were obtained, in general, three time intervals, corresponding to different physical behaviour, were found. In the short-time interval, small oscillations superimposed on the excited state decay were observed. They were determined by the vibrational frequency and influenced by electronic-vibrational coupling. In the middle-time interval, almost quasi-exponential decay was detected; its rate constant increased with stronger electronic-vibrational interaction and speed of vibrational relaxation. In the long-time interval, the decay was very slow and, under special conditions, even an asymptotic non-zero excited state population was observed. Its value increased with the strength of the off-diagonal electron-vibrational coupling. Links of the parameters of the model with quantum chemical terms were estimated.     

Structure of neutron-rich Be and C isotopes

The structure of neutron-rich beryllium isotopes has been investigated using different heavy-ion-induced transfer reactions. In neutron transfer reactions, the population of final states shows a strong sensitivity to the chosen core nucleus, i.e., the target nuclei ⁹Be or ¹⁰Be, respectively. Molecular rotational bands up to high excitation energies are observed with ⁹Be as the core due to its pronounced 2α-cluster structure, whereas only a few states at low excitation energies are populated with ¹⁰Be as the core. For ¹¹Be, a detailed investigation has been performed for the three states at 3.41, 3.89, and 3.96 MeV, which resulted in the most probable spin-parity assignments 3/2⁺, 5/2^?, and 3/2^?, respectively. Furthermore, we have studied particle-hole states of ¹⁶C using the ¹³C(¹²C, ⁹C)¹⁶C reaction and found 14 previously unknown states. Using the ¹²C(¹²C, ⁹C)¹⁵C reaction, five new states were observed for ¹⁵C.     

Über die Dichten von Soda- und Ätznatron lösungen

Ohne Zusammenfassung     

A synthesis of the tetracyclic carboskeleton of isaindigotidione

An efficient synthesis of the unique indolizino[7,6-c]quinoline carboskeleton of isaindigotidione has been achieved. This strategy employed l-proline and isatin as the main building blocks in the construction of the framework. Four transformations occurred in a one-pot operation to furnish the tetracyclic nucleus.