BEPCⅡ直线加速器重大改造和束流调试进展

BEPCⅡ直线加速器的重大改造旨在获得高流强、小发射度和小能散的正负电子束, 以满足对撞机亮度提高两个两级的要求. 这对直线加速器各系统和束流物理是一个挑战. 文章介绍了直接决定束流性能的新电子源、新正电子源、新微波功率源、相位控制系统和束流测量系统等的改造情况; 叙述了束流物理研究; 介绍了束流调试进展情况和进一步改进计划.     

Homoclinic and Periodic Orbits Arising Near the Heteroclinic Cycle Connecting Saddle-focus and Saddle Under Reversible Condition

In this paper, we study the dynamical behavior for a 4-dimensional reversible system near its heteroclinic loop connecting a saddle-focus and a saddle. The existence of infinitely many reversible 1-homoclinic orbits to the saddle and 2-homoclinic orbits to the saddle-focus is shown. And it is also proved that, corresponding to each 1-homoclinic （resp. 2-homoclinic） orbit F, there is a spiral segment such that the associated orbits starting from the segment are all reversible 1-periodic （resp. 2-periodic） and accumulate onto F. Moreover, each 2-homoclinic orbit may be also accumulated by a sequence of reversible 4-homoclinic orbits.     

西咪替丁的应用进展

综述了近年来国内外报道的H2受体抗拮剂－西咪替丁应用于除治疗消化性溃疡以外的其他疾病的进展情况，以其为临床用药提供参考。     

约束装箱问题的混合遗传算法求解

本将最佳适应法和遗传算法相结合，提出了一种新的启发式混合遗传算法对具有时间约束的装箱问题进行求解，给出了具体的算法步骤，试算结果表明基于启发式算法的混合遗传算法适合于求解各种约束条件下的大规模装箱问题。     

多项式理想准素分解的算法

讨论了多项式理想准素分解的算法,对于理想坐标变换中关键的“一般位置”的计算,给出了一个确定算法,并建立了特别规范Groebner基的概念,利用这一概念及文中提供的相应算法,可以方便地计算理想的维数,进而使用降维的方法来得到高维理想的准素分解。     

ONOO-活性氧的荧光光谱分析进展

系统介绍了ONOO^-活性氧的化学性质，并对其参与的主要化学反应进行了分类和总结．同时，比较了近年来用于ONOO^-检测的方法，并重点论述了荧光光谱分析方法尤其是酶催化动力学荧光分析法在检测ONOO^-活性氧方面的优势和最新的研究进展．     

Effects of Processing Parameters on Microstructure and Properties of Nanoscale ZrC/ZrB2 Multilayered Coatings

ZrC/ZrB2 multilayered coatings with bilayer periods of 3.5-40nm are synthesized by rf magnetron sputtering. Analyses of x-ray diffraction, scanning electron microscopy and nanoindentation indicate that multilayered coatings possess much higher hardness and greater fracture resistance than monolithic ZrC and ZrB2 coatings. A maximum hardness （41.TCPa） and a critical fracture load （73.7mN） are observed in the multilayer with A = 32 nm deposited at the substrate bias -40 V. Higher residual stress built in the ZrC layer can be released by periodic insertion of ZrB2 into the ZrC layer. A clear multilayered structure with mixed ZrB2（001）, ZrB2 （002） and ZrC （111） orientations should be responsible for the enhanced mechanical properties.     

Ce偶-偶同位素低激发态性质的IBM2描述

通过考虑同类核子相干对间的四极相互作用，在IBM2中对Ce偶－偶同位素^128Ce-^138Ce的低激发态能谱和E2跃迁几率及分支比进行了理论分析，计算结果有效地改善了IBM中这些核的γ带能谱的Staggering现象描述，与实验观察到的低激发态结果基本一致。     

Melt rheology of polylactide/montmorillonite nanocomposites

In this article, the linear and nonlinear shear rheological behaviors of polylactide (PLA)/clay (organophilic‐montmorillonite) nanocomposites (PLACNs) were investigated by an Advanced Rheology Expanded System rheometer. The nanocomposites were prepared by master batch method using a twin‐screw extruder with poly(ε‐caprolactone) (PCL) as a compatibilizer. The presence of org‐MMT leads to obvious pseudo‐solid‐like behaviors of nanocomposite melts. The behaviors caused by the formation of a “percolating network” derived from the reciprocity among the strong related sheet particles. Therefore, the storage moduli, loss moduli, and dynamic viscosities of PLACNs show a monotonic increase with MMT content. Nonterminal behaviors exists in PLACNs nanocomposites. Besides the PLACNs melts show a greater shear thinning tendency than pure PLA melt because of the preferential orientation of the MMT layers. Therefore, PLACNs have higher moduli but better processibility compared with pure PLA. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 3189–3196, 2007