Sigma-1 Receptor Agonist TS-157 Improves Motor Functional Recovery by Promoting Neurite Outgrowth and pERK in Rats with Focal Cerebral Ischemia

Sigma-1 (σ-1) receptor agonists are considered as potential treatment for stroke. TS-157 is an alkoxyisoxazole-based σ-1 receptor agonist previously discovered in our group. The present study describes TS-157 profile in a battery of tests for cerebral ischemia. Initial evaluation demonstrated the compound’s safety profile and blood–brain barrier permeability, as well as its ability to induce neurite outgrowth in vitro. The neurite outgrowth was shown to be mediated via σ-1 receptor agonism and involves upregulation of ERK phosphorylation (pERK). In particular, TS-157 also significantly accelerated the recovery of motor function in rats with transient middle cerebral artery occlusion (tMCAO). Overall, the results herein support the notion that σ-1 receptor agonists are potential therapeutics for stroke and further animal efficacy studies are warranted.     

紫外光辐照对TiO2纳米线电输运性能的影响及磁阻效应研究

采用溶胶凝胶法以及静电纺丝法, 利用热处理工艺, 成功制备出了多晶锐钛矿型TiO₂纳米线, 通过两线法在室温下测试单根TiO₂纳米线的V-I曲线来研究其电输运性能及磁阻效应. 结果表明: 在无光照环境下其V-I曲线为不过零点的直线, 零场电阻较大, 在磁场作用下电阻下降, 表现出负磁阻效应; 紫外光辐照环境下TiO₂纳米线载流子浓度增加使得电阻变小, 然而在磁场作用下电阻增大, 表现为正磁阻效应. 紫外光辐照导致的载流子浓度变化, 使得负磁阻转变为正磁阻, 我们将磁阻变化归结为d电子局域导致的负磁阻与能带劈裂导致的正磁阻两种机理相互竞争的结果.     

Fabrication of a solution-processed thin-film transistor using zinc oxide nanoparticles and zinc acetate

We have fabricated a solution-processed ZnO thin-film transistor without vacuum deposition. ZnO nanoparticles were prepared by the polyol method from zinc acetate, polyvinyl pyrrolidone, and diethyleneglycol. The solution-processable semiconductor ink was prepared by dispersing the synthesized ZnO in a solvent. Inverted stagger type thin-film transistors were fabricated by spin casting the ZnO ink on the heavily doped Si wafer with 200 nm thick SiO₂, followed by evaporation of Cr/Au source and drain electrodes. After the drying and heat treatment at 600 C, a relatively dense ZnO film was obtained. The film characteristics were investigated by scanning electron microscopy (SEM) and X-ray diffraction (XRD). In order to obtain the electrical properties of the solution-derived transistor, the on–off ratio, threshold voltage, and mobility were measured.     

An Aluminophosphate Molecular Sieve with 36 Crystallographically Distinct Tetrahedral Sites

The structure of the new medium‐pore aluminophosphate molecular sieve PST‐6 is determined by the combined use of rotation electron diffraction tomography, synchrotron X‐ray powder diffraction, and computer modeling. PST‐6 was prepared by calcination of another new aluminophosphate material with an unknown structure synthesized using diethylamine as a structure‐directing agent, which is thought to contain bridging hydroxy groups. PST‐6 has 36 crystallographically distinct tetrahedral sites in the asymmetric unit and is thus crystallographically the most complex zeolitic structure ever solved.     

纤维素直接催化转化制乙二醇及其他化学品:从基础研究发现到潜在工业应用(英)

纤维素直接催化转化制乙二醇是一条极具吸引力的生物质转化途径,有助于减轻化石能源资源的消耗。综述了从该反应途径的发现到获得高效、高稳定性催化剂的快速发展过程。基于对钨基催化剂的大量研究结果,本文讨论了反应机制,明确了反应路径、催化剂状态、钨物种及加氢催化活性中心各自在串联反应中的作用。围绕该反应过程的工业化应用需要,讨论了有关原生木质纤维素生物质催化转化以及高效反应过程的发展策略。在此基础上,将纤维素催化转化制乙二醇过程与生物质发酵制丙酮-丁醇-乙醇的生物炼制路线进行整合,构建出一个理想的反应过程潜在应用范例。最后,对纤维素催化转化制乙二醇反应过程进行了总结和前景展望.     

Stepwise Assembly of Turn-on Fluorescence Sensors in Multicomponent Metal–Organic Frameworks for in Vitro Cyanide Detection

The controlled synthesis of multicomponent metal–organic frameworks (MOFs) allows for the precise placement of multiple cooperative functional groups within a framework, leading to emergent synergistic effects. Herein, we demonstrate that turn-on fluorescence sensors can be assembled by combining a fluorophore and a recognition moiety within a complex cavity of a multicomponent MOF. An anthracene-based fluorescent linker and a hemicyanine-containing CN⁻-responsive linker were sequentially installed into the lattice of PCN-700. The selective binding of CN⁻ to hemicyanine inhibited the energy transfer between the two moieties, resulting in a fluorescence turn-on effect. Taking advantage of the high tunability of the MOF platform, the ratio between anthracene and the hemicyanine moiety could be fine-tuned in order to maximize the sensitivity of the overall framework. The optimized MOF-sensor had a CN⁻-detection limit of 0.05 μm , which is much lower than traditional CN⁻ fluorescent sensors (about 0.2 μm ).     

ZIF-Induced d-Band Modification in a Bimetallic Nanocatalyst: Achieving Over 44 % Efficiency in the Ambient Nitrogen Reduction Reaction

The electrochemical nitrogen reduction reaction (NRR) offers a sustainable solution towards ammonia production but suffers poor reaction performance owing to preferential catalyst–H formation and the consequential hydrogen evolution reaction (HER). Now, the Pt/Au electrocatalyst d-band structure is electronically modified using zeolitic imidazole framework (ZIF) to achieve a Faradaic efficiency (FE) of >44 % with high ammonia yield rate of >161 μg mg_cat⁻¹ h⁻¹ under ambient conditions. The strategy lowers electrocatalyst d-band position to weaken H adsorption and concurrently creates electron-deficient sites to kinetically drive NRR by promoting catalyst–N₂ interaction. The ZIF coating on the electrocatalyst doubles as a hydrophobic layer to suppress HER, further improving FE by >44-fold compared to without ZIF (ca. 1 %). The Pt/Au-N_ZIF interaction is key to enable strong N₂ adsorption over H atom.     

Host-Guest Chemistry of Truncated Tetrahedral Imine Cages with Ammonium Ions

Three shape-persistent [4+4] imine cages with truncated tetrahedral geometry with different window sizes were studied as hosts for the encapsulation of tetra-n-alkylammonium salts of various bulkiness. In various solvents the cages behave differently. For instance, in dichloromethane the cage with smallest window size takes up NEt₄⁺ but not NMe₄ ^{+ ,} which is in contrast to the two cages with larger windows hosting both ions. To find out the reason for this, kinetic experiments were carried out to determine the velocity of uptake but also to deduce the activation barriers for these processes. To support the experimental results, calculations for the guest uptakes have been performed by molecular mechanics’ simulations. Finally, the complexation of pharmaceutical interested compounds, such as acetylcholine, muscarine or denatonium have been determined by NMR experiments.     

Natural Melanin Nanoparticle‐decorated Screen‐printed Carbon Electrode: Performance Test for Amperometric Determination of Hexavalent Chromium as Model Trace

A biosensor was prepared with natural melanin nanoparticles (MNP) decorated on a screen‐printed carbon electrode (SPCE). Hexavalent chromium was selected as a well‐known heavy metal ion to be detected for testing the performance of novel biosensor. Natural MNP was extracted from cuttlefish (Sepia officinalis) ink. Surface decoration of SPCEs with MNP was performed by two different methods. The first one was layer‐by‐layer assembly (LBL‐A) for different cycle times(n). In the second one, plasma treatment of SPCE incorporated with evaporation‐induced self‐assembly (EI‐SA) techniques including different incubation times in MNP solutions. The performance of both modified SPCEs were tested for amperometric detection of Cr(VI) in various water samples, and peak reduction of Cr(VI) was determined at 0.33 V. Amperometric results showed wide linear ranges of 0.1–2 μM and 0.1–5 μM of Cr(VI) for SPCEs modified with 14n‐LBL‐A and 12h‐EI‐SA, respectively. The sensitivities of SPCEs modified with 14n‐LBL‐A and 12h‐EI‐SA techniques were 0.27 μA μM^?1 and 0.52 μA μM^?1, respectively. In addition, both modified SPCEs selectively detected Cr(VI) in a model aqueous system composed of certain other heavy metals and minerals, and tap and lake water samples. The LOD and LOQ values for 12h‐EI‐SA were 0.03 μM and 0.1 μM, respectively. This showed that MNP‐modified‐SPCEs generated via EI‐SA techniques have the potential to be an alternative to conventional detection methods such as ICP‐MS.