High-throughput purification of combinatorial libraries I: a high-throughput purification system using an accelerated retention window approach

We have developed a high-throughput purification system to purify combinatorial libraries at a 50-100-mg scale with a throughput of 250 samples/instrument/day. We applied an accelerated retention window method to shorten the purification time and targeted one fraction per injection to simplify data tracking, lower QC workload, and simplify the postpurification processing. First, we determined the accurate retention time and peak height for all compounds using an eight-channel parallel LC/UV/MS system, and calculated the specific preparative HPLC conditions for individual compounds. The preparative HPLC conditions include the compound-specific gradient segment for individual compounds with a fixed gradient slope and the compound-specific UV or ELSD threshold for triggering a fraction collection device. A unique solvent composition or solvent strength was programmed for each compound in the preparative HPLC in order to elute all compounds at the same target time. Considering the possible deviation of the predicted retention time, a 1-min window around the target time was set to collect peaks above a threshold based on UV or ELSD detection. Dual column preparative instruments were used to maximize throughput. We have purified more than 500 000 druglike compounds using this system in the past 3 years. We report various components of this high-throughput purification system and some of our purification results.     

在PVA存在下Os-SnCl_2-亮绿离子缔合体系的研究高纯镍中微量Os的测定

本文研究了Os-SnCl_2-PVA-亮绿离子缔合体系的显色反应,摩尔吸光系数ε_(434)为5.6×10~6L·mol~(-1)·cm~(-1),锇含量在0.1～0.7μg/25mL范围内遵守比耳定律,室温下显色后,吸光度在110min内稳定。研究了30种外来离子的影响,并进行了高纯镍中微量锇的测定。     

Microstructure and Ion Exchange in Stearic Acid Langmuir-Blodgett Films Studied by Fourier Transform Infrared-Attenuated Total Reflection Spectroscopy

Fourier transform infrared-attenuated total reflection (FTIR-ATR) spectra have been recorded of 11-layer Langmuir-Blodgett (LB) films of stearic acid deposited at various surface pressures (0.1, 15, and 35 mN/m), and the molecular orientation angles were evaluated quantitatively, which supplied insight into the molecular order with the alkyl chains tightly packed like crystal in the LB films deposited at the zero and higher surface pressures. These experimental results indicate that, in the Langmuir film as the precursor of LB films, stearic acid molecules self-aggregate to form two-dimensional crystalline domains already even at the zero surface pressure, which results in the inhomogeneity of monolayer. The analysis of dependence of nu(C=O) intensity on the surface pressure, surface density, and subphase temperature leads to the conclusion that the defects in LB films originate from the Langmuir film and be conserved upon deposition. Annealing below 50 degrees C and cooling could improve the monolayer homogeneity, and thus a defect-free or low-defect LB films can be deposited. Furthermore, ion exchange conducted in the LB films, on the other hand, confirms the existence of structure defects in LB films of stearic acid. The polar plane microstructure, lateral transport along the polar planes and the coordination types of stearic acid/cation system may be the rate-limiting process. The results have implication on the possible uses of stearic acid LB films as ion-exchange materials or sensors. Copyright 2001 Academic Press.     

Determination of Gossypol in Trace Level by Flow Injection Analysis with Chemiluminescence Detection

Gossypol, [1, 1′, 6, 6′, 7,7′-hexahydroxyl-5,5′-diisopropyl-3,3′-dimethyl-(2,2′-binaphtha- lene)-8,8′-dicarboxaldehyde] is a polyphenolic yellow compound naturally occurring in various parts of cotton plants1. The compound has been associated with     

PPC/SBR并用弹性体的配方选择

利用正交法对丁苯橡胶（SBR）／聚丙撑碳酸酯（PPC）共混弹性体进行配方设计，得到了一个具有良好综合性能的配方。并通过方差分析得出PPC含量和马来酸酐（MA）用量是影响弹性体拉伸性能的最显著因素。     

活性炭和石墨混合载体的Pt催化剂（Pt/CG）对乙醇氧化电催化活性的影响

用化学沉积法制备炭载Pt(Pt/C)和以活性炭与石墨作混合载体的Pt(Pt/CG)催化剂。实验结果表明，活性炭与石墨质量比影响Pt/CG催化剂对乙醇氧化的电催化活性。当活性炭与石墨的质量比为15∶1时，制得的Pt/CG催化剂对乙醇氧化的电催化活性最高。     

低热-高压法制备PLGA多孔支架及其体外降解研究

采用低热-高压法制备了聚(dl-丙交酯／乙交酯)75／25(PLGA75／25)组织工程多孔支架。该方法避免了使用有机溶剂，支架的孔隙率在90％以上，孔径大小分布均匀。多孔支架经过酒精处理后，支架表面产生许多微小的凹陷；用藻酸钙改性处理后，支架形态保持良好。两种处理都使支架的压缩强度有所增大，亲水性增强。虽然孔隙率高的支架降解速率稍慢，但其体外降解规律基本一致：特性粘数争力学强度衰减快，而质量损失较慢，降解6周后，支架的质量损失仅为3％左右；体外降解3周后，支架的形态保持良好，可望在细胞移植争组织修复的早期发挥支撑作用。     

Pt-SnO2 / C催化剂对乙醇和吸附态CO的电催化氧化

由于乙醇最有可能成为直接甲醇燃料电池（DMFC）的替代燃料，因此近年来。对乙醇的电化学氧化及直接乙醇燃料电池的研究已引起人们的很大兴趣。甲醇毒性较大并且易透过Nafion膜进入阴极造成阴极的混合电位而影响DMFC的阴极性能．这是制约DMFC走向实用化的主要问题之一。因此人们在致力于研究直接甲醇燃料电池的同时．也寻求其它的小分子醇作为甲醇的替代燃料。乙醇是除甲醇以外最简单的醇．它来源广泛．无毒，是可再生和环保型能源．并且也有较高的能量密度和反应活性。但是乙醇在电极上的完全氧化因涉及到C-C键的断裂要比甲醇困难．阳极反应动力学过程也比较缓慢。到目前为止铂基催化剂仍然是乙醇氧化最好的催化剂．虽然也有使用非铂催化剂研究乙醇的电氧化，但催化活性远不如铂基催化剂高。     

Determination of medecamycin by adsorptive stripping voltammetry with an activated electrode

The adsorptive and electrochemical behaviors of medecamycin were investigated on a glassy carbon electrode (GCE) pretreated by anodic oxidation at +1.8 V for 5 min in 0.025 mol l^–1 NH₃-NH₄Cl (pH 8.6) solution. An adsorptive stripping voltammetric method for the determination of medecamycin at the pretreated glassy carbon electrode has been developed. Medecamycin was accumulated in NH₃-NH₄Cl buffer (pH 9.0) at a potential of –0.7 V (vs. saturated calomel electrode (SCE)) for a certain time, and then determined by second-order differential anodic stripping voltammetry. The second-order differential anodic stripping peak current at +0.72 V was proportional to the concentration of medecamycin in the range 2.0 g ml^–1 to 50.0 g ml^–1. The detection limit (three times the signal-to-noise) was 1.0 g ml^–1 and the relative standard deviation of the results was 3.28% for eight successive determinations of 10.0 g ml^–1 medecamycin. This method has been applied to the direct determination of medecamycin in commercial tablets and spiked urine samples with satisfactory results.