提高微晶硅薄膜太阳电池效率的研究

采用甚高频等离子体增强化学气相沉积技术制备了系列微晶硅薄膜太阳电池，指出了气体总流量和背反射电极的类型对电池性能参数的影响.电池的I-V测试结果表明：随反应气体总流量的增加，对应电池的短路电流密度、开路电压和填充因子都有很大程度的提高，结果使得电池的光电转换效率得以提高.另外，ZnO/Ag/Al背反射电极能明显提高电池的短路电流密度，进而也提高了电池的光电转换效率.对气体总流量和背反射电极类型影响电池效率的原因进行了分析. 关键词： 微晶硅薄膜太阳电池 气体流量 ZnO/Ag/Al背反射电极     

Growth studies of m-GaN layers on LiAlO2 by MOCVD

This paper reports that the m-plane GaN layer is grown on （200）-plane LiAlO2 substrate by metal-organic chemical wpour deposition （MOCVD） method. Tetragonal-shaped crystallites appear at the smooth surface. Raman measurement illuminates the compressive stress in the layer which is released with increasing the layer＇s thickness. The high transmittance （80%）, sharp band edge and excitonic absorption peak show that the GaN layer has good optical quality. The donor acceptor pair emission peak located at -3.41 eV with full-width at half maximum of 120 meV and no yellow peaks in the photoluminescence spectra partially show that no Li incorporated into GaN layer from the LiAlO2 substrate.     

一类高次系统极限环的存在与唯一性

本文对系统dxdt=-y(1-ax2n)(1-bx2n) δx-lx4n 1dydt=x2n-1(1-cx2n)(1-bx2n)进行定性分析,得出其极限环的存在性,不存在性及唯一性的一系列充分条件.     

Calibrating software reliability models when the test environment does not match the user environment

Software failures have become the major factor that brings the system down or causes a degradation in the quality of service. For many applications, estimating the software failure rate from a user's perspective helps the development team evaluate the reliability of the software and determine the release time properly. Traditionally, software reliability growth models are applied to system test data with the hope of estimating the software failure rate in the field. Given the aggressive nature by which the software is exercised during system test, as well as unavoidable differences between the test environment and the field environment, the resulting estimate of the failure rate will not typically reflect the user‐perceived failure rate in the field. The goal of this work is to quantify the mismatch between the system test environment and the field environment. A calibration factor is proposed to map the failure rate estimated from the system test data to the failure rate that will be observed in the field. Non‐homogeneous Poisson process models are utilized to estimate the software failure rate in both the system test phase and the field. For projects that have only system test data, use of the calibration factor provides an estimate of the field failure rate that would otherwise be unavailable. For projects that have both system test data and previous field data, the calibration factor can be explicitly evaluated and used to estimate the field failure rate of future releases as their system test data becomes available. Copyright © 2002 John Wiley & Sons, Ltd.     

Relationship between chemical bond parameters and superconducting temperature in HgBa2Can−1CunO2n+2+δ (n=1, 2, 3, 4)

Bond covalency and valence of elements in HgBa₂Ca_n−1Cu_nO_2n+2+δ (n=1, 2, 3, 4) were calculated and their relationship with T_c was discussed. For both oxygen and argon annealed samples, the results indicated that with the increase of n, the trend of bond covalency of Hg-O and Cu-O was the same or opposite compared with that of superconducting temperature. This may suggest that the magnitudes of Cu-O and Hg-O bond covalency are important in governing the superconducting temperature. For the highest T_c sample, Hg had the lowest valence, implying that lower valence of Hg was preferred in order to produce higher T_c. For fixed n, the valence of Cu in oxygen annealed samples was larger than that in argon annealed samples, indicating that oxygen annealed samples produced more carriers than argon annealed samples.     

差分吸收光谱法测量大气污染的测量误差分析

差分吸收光谱技术被广泛地应用于测量大气中微量元素的浓度，尽管该技术利用最小二乘法来反演待测气体的浓度，能够得到很高的测量精度。但是，由于仪器本身的噪声以及测量波段其它气体的干扰等，使得仪器的测量有一定的误差，而且上述因素还决定着仪器的测量下限。对差分吸收光谱方法的测量误差以及引起误差的原因作了详细的分析。     

约束层对激光驱动冲击波压力影响机理的理论研究

针对刚性约束层、柔性约束层以及液体约束层，从激光诱导冲击波阵面状态、汽化物(包括气体和等离子体)扩散以及冲击波的反射进行分析，发现对于脉宽小于冲击波通过汽化物层的时间间隔的短脉冲激光，约束层并不能直接提高冲击波的冲量，而对于脉宽大于冲击波通过汽化层时间间隔的激光，其增强冲击效果是通过约束汽化物的扩散，提高压力幅值和由于冲击波在约束层与工件表面的多次反射而延长对工件的作用时间来实现的.刚性约束层能最大地增加冲击冲量，而柔性约束层和液体约束层的主要优点是其形状可与非平面形工件表面符合. 关键词： 激光 约束层 扩散 反射波     

掺钕聚甲基丙烯酸甲酯的光学特性

研究了制备的掺钕螯合物Nd(DBM)3Phen材料的吸收光谱、激发光谱、荧光光谱,应用Judd-Ofelt理论计算了该材料的强度参量．分析了钕离子激发态4F3／2的辐射寿命(631 μs)和4F3／2→4IJ′跃迁的受激发射截面和荧光分支比．     

A Modified Quasi-Newton Method for Structured Optimization with Partial Information on the Hessian

This paper develops a modified quasi-Newton method for structured unconstrained optimization with partial information on the Hessian, based on a better approximation to the Hessian in current search direction. The new approximation is decided by both function values and gradients at the last two iterations unlike the original one which only uses the gradients at the last two iterations. The modified method owns local and superlinear convergence. Numerical experiments show that the proposed method is encouraging comparing with the methods proposed in [4] for structured unconstrained optimization Presented at the 6th International Conference on Optimization: Techniques and Applications, Ballarat, Australia, December 9–11, 2004     

On Dirichlet Characters of Polynomials

The main purpose of this paper is to use the properties of Gaussiansums and the analytic method to study the problem of calculatingone kind of character sums modulo q, and to give an interestingidentity. 2000 Mathematics Subject Classification 11L10, 11L40.