A new mathematical model for the enzymatic kinetic resolution of racemates

A mathematical model is presented for the kinetic resolution of racemates. It takes all intermediate binding steps into account and assumes that such steps are reversible. The model describing dynamics of the chiral reaction products consists of two nonlinear differential equations. With this model, the enantioselectivity of enzyme has been studied. Mathematical and numerical simulation of the model show that there are several ways to control the enantiomeric ratio (E) but the affinity and the binding rates of the intermediate enzyme complex to the racemic substrates are the key steps for the enzyme enantioselectivity.     

Polyelectrolyte–protein interaction at low ionic strength: required chain flexibility depending on protein average charge

The effect of low ionic strength leading to reduced polyelectrolyte–protein interactions has been shown by in silico and in vitro experiments, suggesting polyelectrolyte rigidity increasing at low ionic strength, thus leading to reduced interactions with proteins. This contribution elucidates polyelectrolyte–protein precipitation in the 0–2.6-mS?cm^?1 ionic strength regime with polyelectrolyte rigidity determinations, using viscosimetry at these conditions, also considering protein charge distributions, using different proteins. Precipitation yields increased from 5 to 40 % at low ionic strength to up to 90 % at intermediate ionic strength, depending on protein and polyelectrolyte type, using lysozyme and three different monoclonal antibodies. Comparing precipitation behavior of the monoclonal antibodies, a qualitative correlation between required polyelectrolyte flexibility to enhance protein precipitation and protein average charge as well as hydrophobicity of the antibodies was discovered. Antibodies with lower average charge and less hydrophobicity required more flexible polyelectrolytes to enhance precipitation behavior by allowing interaction of the polyelectrolytes with proteins, attaching to positively charged protein patches while “circumnavigating” negatively charged protein areas. In contrast, antibodies with higher protein average charge showed increasing precipitation yields up to 90 % already at lower ionic strength, associated with then more rigid polyelectrolyte structures. Therefore, designing polyelectrolytes with specific chain flexibility could help to improve precipitation behavior toward specific target proteins in polyelectrolyte-driven purification techniques.     

Annelated Pyridines as Highly Nucleophilic and Lewis Basic Catalysts for Acylation Reactions

New heterocyclic derivatives of 9‐azajulolidine have been synthesized and characterized with respect to their nucleophilicity and Lewis basicity. The Lewis basicity of these bases as quantified through their theoretically calculated methyl‐cation affinities correlate well with the experimentally measured reaction rates for addition to benzhydryl cations. All newly synthesized pyridines show exceptional catalytic activities in benchmark acylation reactions, which correlate only poorly with Lewis basicity or nucleophilicity parameters. A combination of Lewis basicity with charge and geometric parameters in the framework of a three‐component quantitative structure–activity relationship (QSAR) model is, however, highly predictive.     

Fluorinated and Trifluoromethylated Corannulenes

The syntheses and properties of corannulenes carrying electron‐withdrawing groups (F, CF₃, C₆F₅) are reported. Direct fluorination of corannulene (C₂₀H₁₀) was carried out with xenon difluoride, and the crystal structure of the product was confirmed by the X‐ray analysis. Novel trifluoromethylated corannulenes, including the versatile 4,9‐dibromo‐1,2‐bis(trifluoromethyl)corannulene, were obtained by various established ring‐closing reactions. Besides the use of hexafluorobutyne for the construction of fluoranthenes by Diels–Alder reaction as precursor molecules to form 1,2‐disubstituted corannulenes, bis(pentafluorophenyl)acetylene was employed as dienophile. The molecular structure and crystal packing of a trifluoromethylated corannulene was determined by single‐crystal X‐ray analysis and compared with those known brominated and trifluoromethylated corannulenes. The general electron‐acceptor properties of corannulenes bearing substituents introduced in particular positions by liquid‐phase synthesis are discussed together with published computational results.     

On the “Tertiary Structure” of Poly‐Carbenes; Self‐Assembly of sp3‐Carbon‐Based Polymers into Liquid‐Crystalline Aggregates

The self‐assembly of poly(ethylidene acetate) (st‐PEA) into van der Waals‐stabilized liquid‐crystalline (LC) aggregates is reported. The LC behavior of these materials is unexpected, and unusual for flexible sp³‐carbon backbone polymers. Although the dense packing of polar ester functionalities along the carbon backbone of st‐PEA could perhaps be expected to lead directly to rigid‐rod behavior, molecular modeling reveals that individual st‐PEA chains are actually highly flexible and should not reveal rigid‐rod induced LC behavior. Nonetheless, st‐PEA clearly reveals LC behavior, both in solution and in the melt over a broad elevated temperature range. A combined set of experimental measurements, supported by MM/MD studies, suggests that the observed LC behavior is due to self‐aggregation of st‐PEA into higher‐order aggregates. According to MM/MD modeling st‐PEA single helices adopt a flexible helical structure with a preferred trans‐gauche syn‐syn‐anti‐anti orientation. Unexpectedly, similar modeling experiments suggest that three of these helices can self‐assemble into triple‐helical aggregates. Higher‐order assemblies were not observed in the MM/MD simulations, suggesting that the triple helix is the most stable aggregate configuration. DLS data confirmed the aggregation of st‐PEA into higher‐order structures, and suggest the formation of rod‐like particles. The dimensions derived from these light‐scattering experiments correspond with st‐PEA triple‐helix formation. Langmuir–Blodgett surface pressure–area isotherms also point to the formation of rod‐like st‐PEA aggregates with similar dimensions as st‐PEA triple helixes. Upon increasing the st‐PEA concentration, the viscosity of the polymer solution increases strongly, and at concentrations above 20 wt % st‐PEA forms an organogel. STM on this gel reveals the formation of helical aggregates on the graphite surface–solution interface with shapes and dimensions matching st‐PEA triple helices, in good agreement with the structures proposed by molecular modeling. X‐ray diffraction, WAXS, SAXS and solid state NMR spectroscopy studies suggest that st‐PEA triple helices are also present in the solid state, up to temperatures well above the melting point of st‐PEA. Formation of higher‐order aggregates explains the observed LC behavior of st‐PEA, emphasizing the importance of the “tertiary structure” of synthetic polymers on their material properties.     

Targeting the Substrate Binding Site of E. coli Nitrile Reductase QueF by Modeling,Substrate and Enzyme Engineering

Nitrile reductase QueF catalyzes the reduction of 2‐amino‐5‐cyanopyrrolo[2,3‐d]pyrimidin‐4‐one (preQ₀) to 2‐amino‐5‐aminomethylpyrrolo[2,3‐d]pyrimidin‐4‐one (preQ₁) in the biosynthetic pathway of the hypermodified nucleoside queuosine. It is the only enzyme known to catalyze a reduction of a nitrile to its corresponding primary amine and could therefore expand the toolbox of biocatalytic reactions of nitriles. To evaluate this new oxidoreductase for application in biocatalytic reactions, investigation of its substrate scope is prerequisite. We report here an investigation of the active site binding properties and the substrate scope of nitrile reductase QueF from Escherichia coli. Screenings with simple nitrile structures revealed high substrate specificity. Consequently, binding interactions of the substrate to the active site were identified based on a new homology model of E. coli QueF and modeled complex structures of the natural and non‐natural substrates. Various structural analogues of the natural substrate preQ₀ were synthesized and screened with wild‐type QueF from E. coli and several active site mutants. Two amino acid residues Cys190 and Asp197 were shown to play an essential role in the catalytic mechanism. Three non‐natural substrates were identified and compared to the natural substrate regarding their specific activities by using wild‐type and mutant nitrile reductase.     

[6,6]‐Open and [6,6]‐Closed Isomers of C70(CF2): Synthesis,Electrochemical and Quantum Chemical Investigation

Novel difluoromethylenated [70]fullerene derivatives, C₇₀(CF₂)_n (n=1–3), were obtained by the reaction of C₇₀ with sodium difluorochloroacetate. Two major products, isomeric C₇₀(CF₂) mono‐adducts with [6,6]‐open and [6,6]‐closed configurations, were isolated and their homofullerene and methanofullerene structures were reliably determined by a variety of methods that included X‐ray analysis and high‐level spectroscopic techniques. The [6,6]‐open isomer of C₇₀(CF₂) constitutes the first homofullerene example of a non‐hetero [70]fullerene derivative in which functionalisation involves the most reactive bond in the polar region of the cage. Voltammetric estimation of the electron affinity of the C₇₀(CF₂) isomers showed that it is substantially higher for the [6,6]‐open isomer (the 70‐electron π‐conjugated system is retained) than the [6,6]‐closed form, the latter being similar to the electron affinity of pristine C₇₀. In situ ESR spectroelectrochemical investigation of the C₇₀(CF₂) radical anions and DFT calculations of the hyperfine coupling constants provide evidence for the first example of an inter‐conversion between the [6,6]‐closed and [6,6]‐open forms of a cage‐modified fullerene driven by an electrochemical one‐electron transfer. Thus, [6,6]‐closed C₇₀(CF₂) constitutes an interesting example of a redox‐switchable fullerene derivative.     

Editorial

JPC – Journal of Planar Chromatography – Modern TLC -     

Growth of one-dimensional Pd nanowires on the terraces of a reduced SnO2(101) surface

Palladium, vapor-deposited at room temperature on a reduced SnO2(101) surface, forms one-dimensional islands, one atomic layer high, 5 A wide, and up to 350 A long. Scanning tunneling microscopy shows that neighboring islands do not merge. First-principles calculations reveal the atomistic processes that lead to this, for metal oxide substrates unusual, overlayer growth. Formation of 1D islands is mediated by a large anisotropy in surface diffusion, strong Pd-Sn interaction, and the lack of stable binding sites at the sides of the Pd islands. Nucleation is defect mediated, and the initial nucleation site determines the width of the resulting nanocluster.