Investigation of the metabolic fate of 2-, 3- and 4-bromobenzoic acids in bile-duct-cannulated rats by inductively coupled plasma mass spectrometry and high-performance liquid chromatography/inductively coupled plasma mass spectrometry/electrospray mass spectrometry

Inductively coupled plasma mass spectrometry (ICPMS) has been used to determine the rate and routes of excretion of bromine following the intraperitoneal administration (50 mg kg(-1)) of 2-, 3- and 4-bromobenzoic acids to male bile-duct-cannulated rats. Analysis of urine and bile for (79/81)Br using ICPMS showed that all three bromobenzoic acids were rapidly excreted (82-98%) within 48 h of dosing, primarily via the urine. High-performance liquid chromatography/inductively coupled plasma mass spectrometry (HPLC/ICPMS) was then used to obtain metabolite profiles for bile and urine. These profiles revealed that extensive metabolism had taken place, with the unchanged bromobenzoic acids forming a minor part of the total of compound-related material detected. Concomitant MS studies, supplemented by alkaline hydrolysis, enabled the identification of the major metabolite of all three of the bromobenzoic acids as a glycine conjugate. Ester glucuronide conjugates were also identified, but formed only a small proportion of total.     

Preparation and lithium doping of gallium oxynitride by ammonia nitridation via a citrate precursor route

Gallium oxynitride, isostructural to hexagonal gallium nitride (h-GaN), was obtained by ammonia nitridation of a precursor prepared from the addition of citric acid to an aqueous solution of gallium nitrate. Gallium oxynitride produced at 750 °C had a small amount of gallium vacancies, and was formulated as (Ga_0.89□_0.11) (N_0.66O_0.34) where the symbol □ stands for gallium vacancy. Both the gallium vacancies and oxygen substituted for nitrogen were randomly distributed within the structure. The amount of vacancies decreased with nitridation temperatures in the range of 750-850 °C. Approximately, 10 at% Li⁺ was doped into the gallium oxynitride, using a similar preparation with the additional presence of lithium nitrate, resulted in the random substitution of Ga³⁺ in an atomic ratio of Li/Ga<1 at 750 °C. Oxygen was codoped with lithium and substituted nitrogen in the wurtzite-type crystal lattice. These substitutions reduced the electrical conductivity in the gallium oxynitride semiconductor. A new oxynitride, Li₂Ga₃NO₄, was also obtained with Li₂CN₂ impurity using similar preparations from a mixture of Li/Ga?1. The crystal structure was isostructural with h-GaN, and was refined as P6₃mc with a=0.31674(1) nm, and c=0.50854(2) nm. The Ga and Li occupancies at the 2b site were refined to be 0.6085 and 0.3915, respectively, assuming that the other 2b site was randomly occupied with 1/5O and 4/5N. When the new compound was washed for over 1 min for the removal of Li₂CN₂ impurities, it was decomposed to a mixture of α-GaOOH and α-LiGaO₂. The as-prepared product with Li/Ga=1 showed the highest intensity in yellow luminescence among the products under excitation at 254 nm.     

Large-scale resonance amplification of optical sensing of volatile compounds with chemoresponsive visible-region diffraction gratings

Micropatterning of the vapochromic charge-transfer salt, [Pt(CNC6H4C10H21)4][Pd(CN)4], on transparent platforms yields transmissive chemoresponsive diffraction gratings. Exposure of the gratings to volatile organic compounds (VOCs) such as chloroform and methanol leads to VOC uptake by the porous material comprising the grating lattice or framework, and a change in the material's complex refractive index, ?. The index change is accompanied by a change in the degree of index contrast between the lattice and the surrounding medium (in this case, air), and a change in the diffraction efficiency of the grating. When a monochromatic light source that is not absorbed by the lattice material is employed as a probe beam, only changes in the real component of ? are sensed. Under these conditions, the grating behaves as a nonselective, but moderately sensitive, sensor for those VOCs capable of permeating the porous lattice material. When a probe color is shifted to a wavelength coincident with the vapochromic charge-transfer transition of the lattice material, the sensor response is selectively amplified by up to 3.5 orders of magnitude, resulting in greatly enhanced sensitivity and some degree of chemical specificity. On the basis of studies at four probe wavelengths, the amplification effect is dominated by resonant changes in the imaginary component of the refractive index. The observed wavelength- and analyte-dependent amplification effects are quantitatively well described by a model that combines a Kramers-Kronig analysis with an effective-medium treatment of dielectric effects.     

Mass spectrometrically detected directly coupled high performance liquid chromatography/nuclear magnetic resonance spectroscopy/mass spectrometry for the identification of xenobiotic metabolites in maize plants

Reconstructed ion chromatograms have been used to identify relevant high performance liquid chromatography (HPLC) peaks in a directly coupled high performance liquid chromatography/nuclear magnetic resonance spectroscopy/mass spectrometry (HPLC/NMR/MS) experiment. This has been applied to a study of the metabolism of a model compound, 5-nitropyridone (2-hydroxy-5-nitropyridine), in maize plants grown hydroponically. By monitoring the on-flow reconstructed ion chromatogram corresponding to the 5-nitropyridone fragment at m/z 143, and additional molecular ions corresponding to metabolites identified as products from similar compounds, relevant peaks were identified rapidly for subsequent stopped-flow 1H NMR spectroscopic analysis. The combination of coupled HPLC/NMR/MS enabled the direct identification of three metabolites, namely the N-glucoside, N-malonylglucoside, and O-malonylglucoside. This work demonstrates the power of HPLC/NMR/MS for the structural elucidation of xenobiotic metabolites in complex biological matrices (such as plant material) with minimal sample preparation. In particular, using mass spectrometry for the initial identification of relevant HPLC peaks allows the analysis of complex samples without the necessity for other spectroscopic markers, such as 19F NMR signal for fluorinated compounds or UV spectroscopy for molecules with strong UV chromophores.     

Surface hydration and its effect on fluorinated SAM formation on SiO2 surfaces

Substrate hydration is demonstrated to be crucial to film quality during self-assembled (SA) film deposition of tridecafluoro-1,1,2,2,-tetrahydrooctyltrichlorosilane (FOTS) from the vapor phase. The surface hydration was studied by thermogravimetric analysis, and a model was developed to predict the conditions necessary to desorb all of the water adsorbed on a fused silica surface without significantly altering the concentration of the surface hydroxyl groups. The nature of the SA film was investigated as a function of the degree of rehydration of the dehydrated silica surface. The wettability and microstructure of the SA films were examined by water contact angle, ellipsometry, X-ray photoelectron spectroscopy, and atomic force microscopy. There is an optimum degree of substrate hydration, on the order of 1-1.2 monolayers of adsorbed water, required to produce a dense, durable and uniform FOTS film with high water repellency and a smooth surface.     

Profiling of impurities in illicit methamphetamine by high-performance liquid chromatography and capillary electrochromatography

High performance liquid chromatography (HPLC) with photodiode array (PDA) UV and fluorescence (FL) detection, and capillary electrochromatography (CEC) with laser-induced fluorescence (LIF) detection were investigated for the analysis of acidic extracts derived from illicit methamphetamine. These compounds include major impurities from the hydriodic acid/red phosphorous reduction method, i.e., 1,3-dimethyl-2-phenylnaphthalene and 1-benzyl-3-methylnaphthalene, and other trace-level, structurally related impurities. For certain of these solutes, HPLC with conventional FL detection gave at least a 60× increase in sensitivity over UV detection. In addition, other highly fluorescent impurities were detected in methamphetamine produced via four other synthetic routes. The use of a rapid scanning FL detector (with acquisition of “on the fly” excitation or emission) provided structural information and gave “optimum” excitation and emission detection wavelengths. CEC with LIF detection using UV laser excitation provided greatly improved chromatography over HPLC, with good detection limits in the low ng/ml range. Both methodologies provide good run-to-run repeatability, and have the capability to distinguish between samples.     

Asymmetric synthesis of (1R,2S,3R)-gamma-methyl-cis-pentacin by a kinetic resolution protocol

The asymmetric synthesis of (1R,2S,3R)-3-methyl-2-amino-cyclopentane carboxylic acid has been achieved via kinetic resolution of racemic tert-butyl 3-methyl-cyclopentene-1-carboxylate with homochiral lithium (S)-N-benzyl-N-alpha-methylbenzylamide.     

Excited-state distortions determined from structured luminescence of nitridorhenium(V) complexes

The nitridorhenium(V) complexes ReNCl(2)(PCy3)(2) (1), ReNBr(2)(PCy3)(2) (2), ReNCl(2)(PPh3)(2) (3), and ReNBr(2)(PPh3)(2) (4) produce structured emission spectra upon excitation at low temperature. The origin, E(00), occurs at 15 775, 16 375, 15 875, and 16 300 cm(-1), respectively. The vibronic peaks are regularly spaced with an average energy separation corresponding to the Re triple bond N stretching frequency. The nitridorhenium stretching frequency ranges from 1095 to 1101 cm(-1), as determined by Raman and IR spectroscopy. The excited-state distortions are calculated by fitting the emission spectra. The excited state arises primarily from a d(xy) (ReN nonbonding) to d(yz) (ReN pi antibonding) transition. The rhenium-nitrogen bond length in the excited state is 0.08 A longer than in the ground electronic state, which is consistent with the difference in bond lengths of ReN bonds of bond order 3 and bond order 2.5 as determined from molecular structures.     

Differential conductance switching of planar tunnel junctions mediated by oxidation/reduction of functionally protected ferrocene

Planar tunnel junctions were fabricated by self-assembling 1,1'- ferrocenedicarboxylic acid (FDCA) onto native oxides of thermally deposited aluminum films and subsequently depositing a second aluminum film. Junctions were characterized using Reflection-Absorption Fourier Transform Infrared Spectroscopy (RAIRS) and current-voltage (I-V) spectroscopy. Before deposition of the second aluminum film, RAIRS of FDCA and ferrocenecarboxylic acid (FCA) films revealed COO(-), C=O, and Fc ring stretching modes, indicating that both types of molecules can interact strongly with the oxide and remain intact. After deposition, systems exhibited prominent COO(-) modes and weakened C=O modes, indicating further reaction with aluminum/aluminum oxide. Fc ring modes persisted in FDCA systems but disappeared in FCA systems, suggesting that the second COOH group in the FDCA molecule can act as a protecting group for the ferrocene moiety. Cyclic I-V measurements of FDCA tunnel junction systems revealed very strong ( approximately 10-fold) hysteretic differential conductance switching that was both reversible and stable. Control measurements using as prepared junctions, as well as junctions containing 1,6-hexanedioic acid, 1,9-nonanedioic acid, 1,4-dibenzoic acid, or FCA revealed only very weak ( approximately 10%) differential conductance changes. We attribute FDCA junction switching to barrier profile modifications induced by oxidation/reduction of the functionally protected ferrocene moieties.