Me[14]-N4大环四烯镍(Ⅱ)催化、BrO3-氧化丙酮酸的振荡化学反

本文报道了一种以２，３，９，１０－四甲基－１，４，８，１１－四氮杂环十四－１，３，８，１０－四烯镍（Ⅱ）配合物［Ｎｉ（ㄔＩＭ）］＾２＋为催化剂、ＮａＢｒＯ３为氧化剂、丙酮酸为有机废物、稀硫酸为介质的振荡化学反应新体系。对该体系的振荡特性进行了描述。研究了Ａｇ＾＋、Ｈｇ＾２＋、还原性物质、自由基抑制剂、四氯化碳以及温度对振荡的影响。     

Infrared-optical properties of vapour-deposited metal films

Spectroscopic infrared ellipsometry was applied to determine the optical constants of thin metal layers deposited on dielectric substrates such as glass or CaF(2). The layers were produced by evaporating gold or silver in a vacuum, and the coverage, that is the deposited mass per area, was chosen in the range 80-1200 mg m(-2) for gold, which refers to thicknesses in the lower nanometer range; in the case of the specifically lighter silver, about half the coverage was applied. At low coverage a metal island structure is obtained, which gives rise to surface-enhanced infrared absorption (SEIRA). Depending on the coverage, the deposited films exhibit either dielectric or metallic optical properties. Atomic force microscopy and conductivity measurements complement the spectroscopic observation.     

高分辨等离子体质谱法直接测定高纯镓中的痕量元素

建立高分辨电感耦合等离子体质谱法(HR-ICP-MS)测定高纯镓样品中Be、Mg、A l、S i、Ti、V、Cr、Mn、Fe、Co、N i、Cu、Zn、Ge、As、Mo、Ag、Cd、In、Sb、Ba、Pb、B i等痕量元素的方法。样品用HNO3 HC l经微波消解后,试液直接进样用HR-ICP-MS法同时测定上述元素,在高分辨质谱测量模式下避免了大量的质谱干扰,详细地研究了HC l和高纯镓所产生的基体效应,以Sc、Rh、Tl作为内标元素校正了基体效应,讨论和确定了实验的最佳测定条件。结果表明,23种痕量元素的检出限在0.001~0.21μg/L之间;回收率在89.8%~111.6%之间,相对标准偏差(RSD)小于3.3%。     

最小一乘稳健多元分析校正

本文论述最小一乘求解的多元分析校正算法，探讨了最小一乘较常规最小二乘法及其他隐健算法的优点。用计算机数值模拟及实际多组分光谱体系对方法进行了检验，展示了最小一乘法在分析化学计量学中实际应用的可行性。     

三价铬与丙二酸形成的配合物的热解过程研究

利用热重分析及原位红光谱等方法，定性，定量地研究了三价铬和丙二酸形成的配合物［Ｃｒ（Ｃ３Ｈ２Ｏ４）（Ｈ２Ｏ）４］［Ｃｒ（Ｃ３Ｏ４）２（Ｈ２Ｏ２）］．４Ｈ２Ｏ的热解过程，提出了室温至４００℃下的详细热解途径。基于多种实验结果，分析了螯合物中六员环的化学断裂方式，并由配合物的快原子轰击质谱（ＦＡＢ－ＭＳ）加以佐证。     

双（1,2—丙二胺）合铜的TCNQ盐的合成与光谱研究

合成了导电性ＴＣＮＱ盐Ｃｕ（ｐｎ）２（ＴＣＮＱ）ｎ（ｎ＝２和３，ｐｎ＝１，２－丙二胺，ＴＣＮＱ＝７，７，８，８－四氰基对苯二醌二甲烷）。红外光谱、电子光谱和Ｘ－光电子能谱研究表明ＴＣＮＱ盐中存在ＴＣＮＱ°和ＴＣＮＱ－，ＴＣＮＱ°与ＴＣＮＱ－之间发生了部分电子转移，致使铜呈混合价态。它们的粉末室温电导率为１．１×１０－５～２．４×１０－６ｏｈｍ－１ｃｍ－１。     

2, 2＇─(1, 4─亚乙二氧基)—二苯甲酸与钴(Ⅱ)生成的两种配合物的结构研究

硝酸钴与２，２＇－（１，４－亚乙二氧基）－二苯甲酸（Ｈ２Ｌ，图１）作用分别得到红色配合物ＣｏＬ＇和蓝色配合物ＣｏＬ″。经元素分析、红外光谱、紫外可见光谱、热分析等方法进行了表征、ＣｏＬ＇配合物的分子式为［ＣｏＬ．Ｈ２Ｏ］．３Ｈ２Ｏ，近八面体构型，羧酸根以双齿形式与Ｃｏ（Ⅱ）螯合；ＣｏＬ″配合物分子式为［ＣｏＬ″］。Ｈ２Ｏ，近四面体构型，羧酸根以单齿形与Ｃｏ（Ⅱ）配位。     

Bis(crown-6)calix[4]arene/Cs+ Coordination Chemistry in NPME Solution

NMR spectroscopy was used to show that the symmetry of the crown ether bis(C6) is increased by an increase of the alkali metal cation radius. The EXAFS spectrum demonstrates that a seven oxygen atom coordinated configuration is present in the bis(C6)/Cs⁺/NPME system, where NPME denotes o-nitrophenylmethyl ether. The seventh oxygen in this complex, besides the six crown ether oxygens of bis(C6), may come either from a H₂O molecule or an NO₃⁻ ion.     

Effects of polystyrene-encapsulated magnesium hydroxide on rheological and flame-retarding properties of HIPS composites

In this study, polystyrene (PS)-encapsulated magnesium hydroxide (Mg(OH)₂) was successfully prepared by in situ polymerization of styrene on the surface of Mg(OH)₂ in a high-speed mixer. A large amount of PS chemically bonded on Mg(OH)₂ surface was confirmed by means of FT-IR, TGA and SEM. A series of composites of high impact polystyrene (HIPS) were prepared by melt blending in a co-rotating twin-screw extruder. The effects of PS-encapsulated filler on the properties of HIPS composites were studied by SEM, rheology and combustion tests (horizontal burning tests and cone calorimetry). The dispersion and adhesion patterns of PS-encapsulated Mg(OH)₂ in HIPS matrix were investigated through FT-IR and SEM. The experimental results demonstrated that comparing to the composites containing untreated filler, the rheological and flame retardant properties of those containing PS-encapsulated filler were found to be significantly improved. This improvement is mostly attributed to a better dispersion of the encapsulated filler and a strong adhesion between the filler and matrix.     

Enzymatic surface modification of Kevlar fibers

Horseradish peroxidase catalyzed grafting of acrylamide (AM) onto Kevlar fibers has been studied. The modified fiber has been characterized with scanning electron microscopy (SEM), elemental analysis and the grafting yield. From the SEM micrographs, the surface of the grafted Kevlar fiber is rougher than that of the untreated fiber, and the elemental analysis indicated that the nitrogen content of the treated fibers is higher than that of the untreated fiber. All the results suggested that AM must have been grafted onto the Kevlar surface through HRP-mediated radical initiated grafting reaction. The probably mechanism of HRP catalyzed grafting of AM onto Kevlar surface is proposed.