体效应振荡器特性观测与使用实验教学研究

探讨了体效应振荡器特性观测与使用实验中，编写实验原理要应用能带结构解释负阻特性并通过对偶极畴生长和运动过程的描述说明振荡原理，提出了实验教学方案，从教学效果上分析了开设此实验的意义及合理性。     

Theoretical Studies on the Si（001）-SiO2 Interface Structure

1 INTRODUCTION Silicon and its alloy have been widely applied in such fields as electronic industry, high-temperature structural ceramics, etc. In addition, the researches on silicon and its relevant materials greatly promote the rapid development of modern optics and infor- mation technology. Therefore, more and more at- tention is focused on the structure of silicon, oxide of silicon and the interfaces between silicon and metal or nonmetal. As an ideal passive film on the Si surface, S…     

轴流泵端壁区域流动三维粘性数值计算

本文采用通用流场分析软件FLUENT,基于N-S方程,选用RNG κ—ε湍流模型与SIMPLEC算法,对轴流泵叶轮内部(及端壁间隙)流动进行了三维粘性数值计算。通过实验验证,表明数值计算结果和实测数据吻合较好。详细分析了叶顶附近流场形态以及叶轮出口轴向、周向速度分布,进行了性能预估。并给出了实验装置图。     

电信运营市场上过度进入的供给分析

本文在分析光纤主干网和本地接入服务市场上电信运营商的供给行为的基础上,首先证明了拥有主干网的运营商愿意租出自己的部分光纤,接着分析证明了上述两市场上使投资更倾向于过度的乘数效应,并进一步证明网络外部性使乘数效应更加明显.旨在对我国电信运营市场发展给出一些参考意见.     

金属表面生成氧化膜在电解质中的电位

测量金属表面生成氧化膜在电解质中的电位时,金属/氧化膜/电解质/参比电极构成了多电极体系,其中包括3个电池,由3个电池之间的关系、电池过程中所有的电化学反应、电荷传输步骤和化学反应步骤,导出电位的普遍适用的公式: E=E_a⁰+sum from s=1 to 3|η_t,s|-1/(ne)v₇ΔG₇, E=E_c⁰-sum from s=4 to 6|η_t,s|+1/(ne)v₈ΔG₈.当金属/氧化膜/电解质电池受到不同的步骤控制时,可以得到不同的简化公式.     

不可微泛函拟极小问题解的Hlder连续性

不可微泛函拟极小问题解的Ｈｏｌｄｅｒ连续性于鸣岐，闵泰山（山西大学数学系，太原０３０００６）（北京轻工业学院，１０００３７）金霁（河北工学院，天津３００１３０）１９９２年１１月２７日收到．设Ｇ是ｎ维欧氏空间Ｅｎ中的有界区域，在上定义，对固定的ｘ关于为...     

用BBO晶体产生196～228nm波长的紫外辐射

本文报道了用BBO晶体通过混频产生196～228nm可调谐紫外辐射的研究结果.产生200nm及222nm的量子转换效率分别为12%及23%,与理论计算值基本相符.     

用激活性非线性介质Nd：MgO：LiNbO3产生二次谐波

以Nd:MgO:LiNbO_3同时兼作激活介质和非线性光学材料,研究自倍频激光器。用小型氙灯泵浦,在室温下获得二次谐波激光(0.547μm) 阈值小于4.8'J,最大输出400μJ/shot,工作温度范围大于20℃～45℃,无光损伤。     

Memory Effect in Ceramic Superconductors

We measured the time decay of the magnetic moment of high T_c superconductors YBa₂Cu₃O_7-δ ceramic samples and found the memory effect which has hitherto been reported only in single crystals. The temperature and field ranges, especially the memory phenomenon in ceramic samples at liquid nitrogen temperature can only be understood in a combined picture of both flux creep and glass behaviour     

Physico-Chemical Characterization of Yu Guo Beads(1100-771 B. C. ) in China

When was the earliest glass produced in China? This has still been a question so far. Some archaeologists have thought that Yu Guo beads are real glass, the earliest glass(1100-771 B. C. ) in China. However, more details of scientific investigations in this paper show that Yu Guo beads are mainly made of clastic quartz (>95%) with a small amount of clay and sintered under the low temperature(500-600℃). It is not a glassy body, but a kind of polycrystal ornaments.