Pharmaceutical composition of hydrochlorothiazide:β-cyclo-dextrin: preparation by three different methods, physico-chemical characterization and in vivo diuretic activity evaluation

Hydrochlorothiazide is a common diuretic antihypertensive drug of the thiazide family. Its poor aqueous solubility is one of the reasons for its limited bioavailability after oral administration. This work aimed at the development of a hydrochlorothiazide:β-cyclodextrin (HTZ:β-CD) pharmaceutical composition in order to improve water solubility and bioavailability of the drug. The HTZ:β-CD complexes were prepared by three different methods: spray-drying, freeze-drying and fluid bed. Complexes were characterized by thermal analysis, Fourier transform-infrared (FTIR) spectroscopy, powder X-ray diffractometry, NMR (2D-ROESY), scanning electron microscopy (SEM), particle analysis and intrinsic dissolution. The findings reveal that three binary systems prepared presented better solubility results in comparison with free HTZ. Increased diuretic effect was observed to HTZ:β-CD obtained by fluid bed in comparison to free drug in rats. Results taken together suggest that pharmacological effect of HTZ in complex was increased by solubility improvement promoted by cyclodextrin.     

Identification of volatiles from pineapple (Ananas comosus L.) pulp by comprehensive two-dimensional gas chromatography and gas chromatography/mass spectrometry

Combining qualitative data from the chromatographic structure of 2-D gas chromatography with flame ionization detection (GC×GC-FID) and that from gas chromatography-mass spectrometry (GC/MS) should result in a more accurate assignment of the peak identities than the simple analysis by GC/MS, where coelution of analytes is unavoidable in highly complex samples (rendering spectra unsuitable for qualitative purposes) or for compounds in very low concentrations. Using data from GC×GC-FID combined with GC/MS can reveal coelutions that were not detected by mass spectra deconvolution software. In addition, some compounds can be identified according to the structure of the GC×GC-FID chromatogram. In this article, the volatile fractions of fresh and dehydrated pineapple pulp were evaluated. The extraction of the volatiles was performed by dynamic headspace extraction coupled to solid-phase microextraction (DHS-SPME), a technique appropriate for slurries or solid matrices. Extracted analytes were then analyzed by GC×GC-FID and GC/MS. The results obtained using both techniques were combined to improve compound identifications.     

Counterions in poly(allylamine hydrochloride) and poly(styrene sulfonate) layer-by-layer films

The amount of counterions in layer-by-layer (LBL) films of poly(allylamine hydrochloride) (PAH) and poly(styrene sulfonate) (PSS) has been determined with X-ray photoelectron spectroscopy (XPS) for films prepared from solutions with various NaCl concentrations. Sodium and chloride counterions are present in LBL films produced from salt solutions, which are located at the surface and in the bulk of the films. The percentage of bulk counterions increases with the ionic strength of the polyelectrolyte before reaching a constant value. The bulk sodium/sulfur percentage ratios tend to 0.8 for samples washed with pure water and for samples washed with NaCl aqueous solutions, while the bulk chlorine/nitrogen percentage ratios tend to 0.5 for the same samples. The ratio between the percentages of polyelectrolyte ionic groups lies close to unity for all samples, indicating that counterions do not contribute to charge compensation in the polyelectrolyte during the adsorption process. The presence of counterions in LBL films is explained by Manning condensation near the polyelectrolyte ionic groups, leading to inter-polyelectrolyte ionic bondings via ionic networks. It is believed that condensation leads to the formation of NaCl crystallites in these LBL films, which was confirmed by X-ray diffraction measurements.     

Adsorption of silanes bearing nitrogenated Lewis bases on SiO2/Si (100) model surfaces

The present paper describes the one-pot procedure for the formation of self-assembled thin films of two silanes on the model oxidized silicon wafer, SiO2/Si. SiO2/Si is a model system for other surfaces, such as glass, quartz, aerosol, and silica gel. MALDI-TOF MS with and without a matrix, XPS, and AFM have confirmed the formation of self-assembled thin films of both 3-imidazolylpropyltrimethoxysilane (3-IPTS) and 4-(N-propyltriethoxysilane-imino)pyridine (4-PTSIP) on the SiO2/Si surface after 30 min. Longer adsorption times lead to the deposition of nonreacted 3-IPTS precursors and the formation of agglomerates on the 3-IPTS monolayer. The formation of 4-PTSIP self-assembled layers on SiO2/Si is also demonstrated. The present results for the flat SiO2/Si surface can lead to a better understanding of the formation of a stationary phase for affinity chromatography as well as transition-metal-supported catalysts on silica and their relationship with surface roughness and ordering. The 3-IPTS and 4-PTSIP modified SiO2/Si wafers can also be envisaged as possible built-on-silicon thin-layer chromatography (TLC) extraction devices for metal determination or N-heterocycle analytes, such as histidine and histamine, with "on-spot" MALDI-TOF MS detection.     

Evaluation of Immobilized Metal-Ion Affinity Chromatography (IMAC) as a Technique for IgG1 Monoclonal Antibodies Purification: The Effect of Chelating Ligand and Support

Monoclonal antibodies (MAbs) have been used for therapies and some analytical procedures as highly purified molecules. Many techniques have been applied and studied, focusing on monoclonal antibodies purification. In this study, an immobilized metal affinity chromatography membrane was developed and evaluated for the purification of anti-TNP IgG₁ mouse MAbs from cell culture supernatant after precipitation with a 50% saturated ammonium sulfate solution. The chelating ligands iminodiacetic acid, carboxymethylated aspartic acid (CM-Asp), nitrilotriacetic acid, and tris (carboxymethyl) ethylenediamine in agarose gels with immobilized Ni(II) and Zn(II) ions were compared for the adsorption and desorption of MAbs. The most promising chelating ligand—CM-Asp—was then coupled to poly(ethylene vinyl alcohol) (PEVA) hollow fiber membranes. According to SDS-PAGE and ELISA analyses, a higher selectivity and a purification factor of 85.9 (fraction eluted at 500 mM Tris) were obtained for IgG₁ using PEVA-CM-Asp-Zn(II). The anti-TNP MAb could be eluted under mild pH conditions causing no loss of antigen binding capacity.     

Preparation of the Ca–diclofenac complex in solid state

Two ONNO type naphtaldehyde derivative Schiff base compounds were reduced and two symmetric phenol-amine ligands containing naphthalene groups were obtained; bis-N,N′[(2-hydroxy-1-naphtyl) methyl]-1,3-propanediamine (NAFL^H) and bis-N,N′[(2-hydroxy-1-naphtyl) methyl]-2,2′-dimetyhyl-1,3-propanediamine (NAFLDM^H). Homotrinuclear Ni(II) complexes of these ligands were prepared. The solid-state molecular structures of representative nickel complex of NAFLDM^H were determined using single crystal X-ray diffraction analysis. The terminal Ni(II) ions were found to be situated in between the donor atoms of the organic ligand. The central Ni(II) ion was observed to be bonded via two different μ-bridges. The phenolic oxygens and carboxylate ion were seen to form two different μ-bridges. TG analysis proved that the compounds have different thermal characteristics than those cited in literature. The complexes showed extreme exothermic degradation reactions in inert atmosphere. The complexes are ruptured with a two stepped exothermic reaction which appears huge heat over 300 °C. The heat appeared in O₂ atmosphere is observed to be higher than the heat appeared in inert atmosphere. Revealed heat is observed to be higher than the conventional explosive materials.     

Unprecedented Double aza‐Michael Addition within a Sapphyrin Core

A novel sapphyrin derivative was obtained from the reaction between a free‐base sapphyrin and dimethyl acetylenedicarboxylate (DMAD). The formation of the new compound involved a double aza‐Michael addition of two pyrrolic NH groups to a DMAD molecule, with the formation of a disubstituted ethano bridge. The NMR spectral data reveal a product with an unsymmetrical structure; DFT calculations provided support for a structure in which the ethano bridge links two adjacent pyrrole units. The present study provides a seemingly unprecedented example of an N,N′‐dinucleophile reacting with DMAD to form a heterocyclic compound in which the two N‐atoms are linked to the two sp³ carbon atoms derived from a substituted acetylene.     

Detection of Isoforms Differing by a Single Charge Unit in Individual Cells

To measure protein isoforms in individual mammalian cells, we report single‐cell resolution isoelectric focusing (scIEF) and high‐selectivity immunoprobing. Microfluidic design and photoactivatable materials establish the tunable pH gradients required by IEF and precisely control the transport and handling of each 17‐pL cell lysate during analysis. The scIEF assay resolves protein isoforms with resolution down to a single‐charge unit, including both endogenous cytoplasmic and nuclear proteins from individual mammalian cells.     

Penetration and interactions of the antimicrobial peptide, microcin J25, into uncharged phospholipid monolayers

Microcin J25 forms stable monolayers at the air-water interface showing a collapse at a surface pressure of 5 mN/m, 220 mV of surface potential, and 6 fV per squared centimeter of surface potential per unit of molecular surface density. The adsorption of microcin J25 from the subphase at clean interfaces leads to a rise of 10 mN/m in surface pressure and a surface potential of 220 mV. From these data microcin appears to be a poor surfactant per se. Nevertheless, the interaction with the lipid monolayer further increase the stability of the peptide at the interface depending on the mode in which the monolayer is formed. Spreading with egg PC leads to nonideal mixing up to 7 mN/m, with hyperpolarization and expansion of components at the interface, with a small excess free energy of mixing caused by favorable contributions to entropy due to molecular area expansion compensating for the unfavorable enthalpy changes arising from repulsive dipolar interactions. Above 7 mN/m microcin is squeezed out, leaving a film of pure phospholipid. Nevertheless, the presence of lipid at 10 and 20 mN/m stabilize further microcin at the interface and adsorption from the subphase proceeds up to 30 mN/m, equivalent to surface pressure in bilayers.