Ultrasound-assisted analyte extraction for the determination of sulfate and elemental sulfur in zinc sulfide by different liquid chromatography techniques

The speciation and determination of sulfate (SO4(2-)) and elemental sulfur (S degree) in zinc sulfide (ZnS) using ion-chromatography (IC) and reversed-phase liquid chromatography (RPLC) respectively is described. Three sample pretreatment approaches were employed with the aim of determining sulfate: (i) conventional water extraction of the analyte; (ii) solid-liquid aqueous extraction with an ultrasonic probe; and (iii) elimination of the zinc sulfide matrix via ion-exchange dissolution (IED). The separation of sulfate was carried out by an anion-exchange column (IonPac AS17), followed by suppressed conductivity detection. Elemental sulfur was extracted ultrasonically from the acid treated sample solution into chloroform and separated on a reversed phase HPLC column equipped with a diode array detector (DAD) at 264 nm. The achievable solid detection limits for sulfate and sulfur were 35 and 10 microg g(-1) respectively.     

Multielemental characterisation of cobalt by glow discharge quadrupole mass spectrometry

Multielemental determination and the assessment of purity of cobalt metal used in the preparation of Ni-based super-alloys have been carried out by glow discharge quadrupole mass spectrometry (GD-QMS). Relative sensitivity factors (RSF) generated from certified iron matrix reference samples (NIST 663 and 664 low alloy steel pin standards) could be used for the determination of different trace element constituents of the sample. Different wet chemical procedures were also carried out for the determination of the trace constituents in the sample. The GD-QMS results are in reasonably good agreement with those obtained from wet chemical procedures, validating the use of the RSF values generated on low alloy steel standards for the computation of trace element concentrations in cobalt metal. A variety of molecular ions formed through the reaction of cobalt (matrix) with the discharge gas (argon) were also detected.     

The `cyclophene' [2.2.2](1,2,4)cyclophan‐9‐ene

In the title compound, C₁₈H₁₆, the [2.2]paracyclophane geometry is restrained to a considerable extent despite the introduction of the extra C=C bridge; typical paracyclophane features, such as the elongated C—C bridges, are still observed. However, the bridgehead atoms of the C=C bridge are forced into unusually close proximity [2.657 (3) Å], which in turn causes the rings to be rotated to an interplanar angle of 13.7 (2)°. The packing involves hexagonally close‐packed layers of molecules parallel to the xy plane, corresponding to the known `7,11' pattern of paracyclophanes, but without significant short intermolecular contacts.     

Elucidation of efficient dual performance in photodegradation and antibacterial activity by a promising candidate Ni-doped MoO3 nanostructure

Journal of Sol-Gel Science and Technology - In the present work, Nickel doped Molybdenum trioxide (NixMoO3) where Ni = X (X = 5, 10, and 15%) nanoparticles (NPs) were...     

Pulsatile flow between permeable beds

Pulsatile flow of a viscous fluid between two permeable beds is analyzed. The flow between and through the permeable beds are governed by the Navier-Stokes equations and Darcy's law, respectively. The velocity field and the volume flux are obtained for several cases and discussed. Further, when the permeability parameter k→0, the results agree with those of Wang (J. Appl. Mech. 38 (1971) 553).     

Crystal structure and spectroscopy of a hydrogen-bridged one-dimensional Cu(II) complex containing both octahedral and square pyramidal geometries in the same unit cell

Single crystals of the helical hydrogen-bridged one-dimensional Cu(II) complex, [Cu(stpy)₂(CH₃COO)₂(H₂O)₂] (1) [Cu(stpy)₂(CH₃COO)₂(H₂O)] (2), are prepared and characterized by elemental and thermal analyses, IR, electronic and X-ray crystal structure determination. The crystals are monoclinic, of space group C2/c, with unit cell parameters a = 31.842(7) Å, b = 5.9829(10) Å, c = 30.970(14) Å, = 111.78(3)°, Z = 4. The asymmetric unit contains two different types of Cu(II) polyhedra, namely, octahedron and square pyramid within the same unit cell. 1 has elongated octahedral geometry with two nitrogen atoms from stpy and two oxygen atoms from synmonodentate acetate ligands, transcoordinated to Cu(II) in the basal plane. The oxygen atoms of the two water molecules occupy the axial positions. 2 has Cu(II) coordination polyhedra similar to 1, except that only one of the apical positions is occupied by a water molecule. The structure consists of two independent linear chains, one involving octahedral (1) and the other involving square-pyramidal (2) polyhedra, held by hydrogen bridges. The Cu–Cu intra- and interchain separations in both 1 and 2 are 5.983 and 8.214 Å. The unit cell packing shows weak -stacking between adjacent coordinated stpy ligands in the chain, resulting in ladder-type structure. Further, the extended packing reveals helical arrangement of Cu(II) polyhedra in the lattice.     

Sample Treatment Approaches for Trace Level Determination of Cesium in Hepatitis B Vaccine by Suppressed Ion Chromatography

The hepatitis B surface antigen manufactured by recombinant DNA technology is extracted from the culture media by density gradient centrifugation using cesium salts. Cesium is considered to be toxic, because it affects active ion transport by blocking potassium channels. The residual trace levels of cesium in hepatitis B vaccine samples are determined by suppressed ion chromatography. Hepatitis B vaccines contain various buffer salts, aluminum-containing adjuvants, proteins and traces of iron. The polyvalent cations (Al³⁺, Fe³⁺) and proteins degrade the chromatographic performance in terms of decreased retention time and poor reproducibility. Different sample preparation approaches were evaluated with the aim of eliminating these foulants: (1) filtration, (2) digestion and (3) digestion-protein precipitation. Quantitative elimination of these foulants was achieved in the digestion-protein precipitation sample clean-up approach. Cesium was separated on the IonPac CS17 column with suppressed conductivity detection. The results of the ion chromatography (IC) method were compared with ICP-MS analysis. The precision of determination was better than 6.5% (relative standard deviation) with a method detection limit of 45 ng mL⁻¹. The expanded uncertainty in the measurement at 95% confidence level (coverage factor 2) is better than 16.3%.

     

Studies on outer-sphere electron transfer reactions of surfactant–cobalt(III) complexes with iron(II) in liposome (dipalmitoylphosphotidylcholine) vesicles

The effect of unilamellar vesicles of dipalmitoylphosphotidylcholine (DPPC), both below and above the phase transfer region, on the second-order rate constants for outer-sphere electron transfer between Fe²⁺ and the surfactant?Ccobalt(III) complexes, cis-[Co(en)₂(C₁₂H₂₅NH₂)₂]³⁺ and cis-[Co(trien)(C₁₂H₂₅NH₂)₂]³⁺ (en?=?ethylenediamine, trien?=?triethylenetetramine, C₁₂H₂₅NH₂?=?dodecylamine) was studied by UV?CVis absorption spectroscopy. Below the phase transition temperature of DPPC, the rate decreased with increasing concentration of DPPC, while above the phase transition temperature the rate increased with increasing concentration of DPPC. It is concluded that below the phase transition temperature, there is an accumulation of surfactant?Ccobalt(III) complexes at the interior of the vesicle membrane through hydrophobic effects, and above the phase transition temperature the surfactant?Ccobalt(III) complex is released from the interior to the exterior surface of the vesicle. Through isokinetic plots, we have established that the mechanism of the reaction does not alter during the phase transition of DPPC.     

Determination of indium in high purity antimony by electrothermal atomic absorption spectrometry (ETAAS) using boric acid as a modifier

The use of boric acid as a modifier for the determination of trace amount of indium in high purity antimony by electrothermal atomic absorption is described. It was found that the negative influence of the hydrofluoric acid, used for the digestion could not be eliminated by using stabilized temperature platform furnace (STPF) alone. Due to the high dissociation energy (D₀ = 506 kJ mol⁻¹) of indium fluoride, it is difficult to dissociate in the gas phase and hence is lost. In presence of HF (used for the dissolution of antimony), the universal Pd-Mg modifier does not work satisfactorily. Additionally, rising corrosion and reduced tube lifetime were observed when the acid digested (HF-HNO₃) antimony solution was injected in to the platform. Improvement in platform life and elimination of interferences were achieved by the addition of boric acid as a chemical modifier together with ruthenium coating of the platform. Corrosive changes of the transversely heated graphite atomizer (THGA) platform surface were examined by scanning electron microscopy. The standard addition method was applied. A characteristic mass of 36 pg was obtained. The detection limit of the proposed method is around 0.04 μg g⁻¹. The developed method was applied to the determination of indium in real samples. The data obtained by this method were in good agreement with those obtained by ICP-MS.     

Synthesis,CMC determination and influence of the micelles, β-cyclodextrin,ionic liquids and liposome(dipalmitoylphosphatidylcholine) vesicles on the kinetics of an outer-sphere electron transfer reaction

The surfactant–cobalt(III) complex, cis-[Co(trien)(4AMP)(DA)](ClO₄)₃, trien = triethylenetetramine, 4AMP = 4-aminopyridine, DA = dodecylamine was synthesized and characterized by various spectroscopic and physico-chemical techniques. The critical micelle concentration (CMC) value of this surfactant–cobalt(III) complex in aqueous solution was found out from conductance measurements. The conductivity data (at 303, 308, 313, 318 and 323 K) were used for the evaluation of the temperature-dependent CMC and the thermodynamics of micellization (ΔG _m ^° , ΔH_m and ΔS _m ^° ). Also the kinetics of reduction of this surfactant–cobalt(III) complex by hexacyanoferrate(II) ion in micelles, β-cyclodextrin, ionic liquids (ILs) and in liposome vesicles (DPPC) media were studied at different temperature. The rate constant for the electron transfer reaction in micelles was found to increase with increase in the initial concentration of the surfactant–cobalt(III) complex. This peculiar behaviour of dependence of second-order rate constant on the initial concentration of one of the reactants has been attributed to the presence of various concentration of micelles under different initial concentration of the surfactant–cobalt(III) complex in the reaction medium. Inclusion of the long aliphatic chain of the surfactant complex ion into β-cyclodextrin leads to decrease in the rate constant. Below the phase transition temperature of DPPC, the rate decreased with increasing concentration of DPPC, while above the phase transition temperature the rate increased with increasing concentration of DPPC. It is concluded that below the phase transition temperature, there is an accumulation of surfactant–cobalt(III) complex at the interior of the vesicle membrane through hydrophobic effects, and above the phase transition temperature the surfactant–cobalt(III) complex is released from the interior to the exterior surface of the vesicle. In the presence of ionic liquid medium the second order rate constant for this electron transfer reaction for the same complex was found to increase with increasing concentration of ILs has also been studied. An outer-sphere mechanism is proposed for all these reactions and the results have been explained based on the hydrophobicity of the ligand and the reactants with opposite charges.